#endif
#define CONFIG_PHY_CLK_FREQ EMAC_STACR_CLK_66MHZ
-#define CONFIG_COMMANDS ( CONFIG_CMD_DFL | \
- CFG_CMD_DATE | \
- CFG_CMD_DHCP | \
- CFG_CMD_ELF | \
- CFG_CMD_EEPROM | \
- CFG_CMD_I2C | \
- CFG_CMD_IRQ | \
- CFG_CMD_JFFS2 | \
- CFG_CMD_MII | \
- CFG_CMD_NAND | \
- CFG_CMD_NFS | \
- CFG_CMD_PCI | \
- CFG_CMD_SNTP )
+
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_BOOTFILESIZE
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+
+
+/*
+ * Command line configuration.
+ */
+#include <config_cmd_default.h>
+
+#define CONFIG_CMD_DATE
+#define CONFIG_CMD_DHCP
+#define CONFIG_CMD_ELF
+#define CONFIG_CMD_EEPROM
+#define CONFIG_CMD_I2C
+#define CONFIG_CMD_IRQ
+#define CONFIG_CMD_JFFS2
+#define CONFIG_CMD_MII
+#define CONFIG_CMD_NAND
+#define CONFIG_CMD_NFS
+#define CONFIG_CMD_PCI
+#define CONFIG_CMD_SNTP
+
#define CONFIG_MAC_PARTITION
#define CONFIG_DOS_PARTITION
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
-
#undef CONFIG_WATCHDOG /* watchdog disabled */
#define CONFIG_RTC_M41T11 1 /* uses a M41T00 RTC */
#define CFG_I2C_RTC_ADDR 0x68
#define CFG_M41T11_BASE_YEAR 1900
+/*
+ * SDRAM configuration (please see cpu/ppc/sdram.[ch])
+ */
#define CONFIG_SDRAM_BANK0 1 /* init onboard SDRAM bank 0 */
+/* SDRAM timings used in datasheet */
+#define CFG_SDRAM_CL 2
+#define CFG_SDRAM_tRP 20
+#define CFG_SDRAM_tRC 65
+#define CFG_SDRAM_tRCD 20
+#undef CFG_SDRAM_tRFC
+
/*
* Miscellaneous configurable options
*/
#define CFG_PROMPT_HUSH_PS2 "> "
#endif
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
#define CFG_CBSIZE 1024 /* Console I/O Buffer Size */
#else
#define CFG_CBSIZE 256 /* Console I/O Buffer Size */
*/
#ifdef ENVIRONMENT_IN_EEPROM
-#define CFG_ENV_IS_IN_EEPROM 1 /* use EEPROM for environment vars */
-#define CFG_ENV_OFFSET 0x100 /* environment starts at the beginning of the EEPROM */
-#define CFG_ENV_SIZE 0x700 /* 2048-256 bytes may be used for env vars (total size of a CAT24WC16 is 2048 bytes)*/
+#define CONFIG_ENV_IS_IN_EEPROM 1 /* use EEPROM for environment vars */
+#define CONFIG_ENV_OFFSET 0x100 /* environment starts at the beginning of the EEPROM */
+#define CONFIG_ENV_SIZE 0x700 /* 2048-256 bytes may be used for env vars (total size of a CAT24WC16 is 2048 bytes)*/
#else /* DEFAULT: environment in flash, using redundand flash sectors */
-#define CFG_ENV_IS_IN_FLASH 1 /* use FLASH for environment vars */
-#define CFG_ENV_ADDR 0xFFFF8000 /* environment starts at the first small sector */
-#define CFG_ENV_SECT_SIZE 0x2000 /* 8196 bytes may be used for env vars*/
-#define CFG_ENV_ADDR_REDUND 0xFFFFA000
-#define CFG_ENV_SIZE_REDUND 0x2000
+#define CONFIG_ENV_IS_IN_FLASH 1 /* use FLASH for environment vars */
+#define CONFIG_ENV_ADDR 0xFFFF8000 /* environment starts at the first small sector */
+#define CONFIG_ENV_SECT_SIZE 0x2000 /* 8196 bytes may be used for env vars*/
+#define CONFIG_ENV_ADDR_REDUND 0xFFFFA000
+#define CONFIG_ENV_SIZE_REDUND 0x2000
+
+#define CFG_USE_PPCENV /* Environment embedded in sect .ppcenv */
#endif /* ENVIRONMENT_IN_EEPROM */
#define CFG_EEPROM_PAGE_WRITE_DELAY_MS 10 /* and takes up to 10 msec */
#define CFG_EEPROM_PAGE_WRITE_ENABLE
-/*-----------------------------------------------------------------------
- * Cache Configuration
- */
-#define CFG_DCACHE_SIZE 16384 /* For AMCC 405 CPUs, older 405 ppc's */
- /* have only 8kB, 16kB is save here */
-#define CFG_CACHELINE_SIZE 32 /* ... */
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
-#define CFG_CACHELINE_SHIFT 5 /* log base 2 of the above value */
-#endif
-
/*
* Init Memory Controller:
*
#define CONFIG_VGA_AS_SINGLE_DEVICE
/* This is the base address (on 405EP-side) used to generate I/O accesses on PCI bus */
#define CFG_ISA_IO 0xE8000000
-/* see also drivers/videomodes.c */
+/* see also drivers/video/videomodes.c */
#define CFG_DEFAULT_VIDEO_MODE 0x303
#endif
projects / platform / kernel / u-boot.git / blobdiff