configs: Finish migration of PHY_GIGE

[platform/kernel/u-boot.git] / include / configs / P2041RDB.h

diff --git a/include/configs/P2041RDB.h b/include/configs/P2041RDB.h
index 3fad88f..ef7563d 100644 (file)
--- a/include/configs/P2041RDB.h
+++ b/include/configs/P2041RDB.h
@@ -24,7 +24,6 @@
 #define CONFIG_SYS_SRIO_PCIE_BOOT_SLAVE_ADDR_PHYS \
                (0x300000000ull | CONFIG_SYS_SRIO_PCIE_BOOT_SLAVE_ADDR)
 #define CONFIG_RESET_VECTOR_ADDRESS 0xfffffffc
-#define CONFIG_SYS_NO_FLASH
 #endif
 
 /* High Level Configuration Options */
@@ -41,7 +40,6 @@
 
 #define CONFIG_SYS_FSL_CPC             /* Corenet Platform Cache */
 #define CONFIG_SYS_NUM_CPC             CONFIG_SYS_NUM_DDR_CTLRS
-#define CONFIG_FSL_CAAM                        /* Enable SEC/CAAM */
 #define CONFIG_PCIE1                   /* PCIE controller 1 */
 #define CONFIG_PCIE2                   /* PCIE controller 2 */
 #define CONFIG_PCIE3                   /* PCIE controller 3 */
@@ -56,10 +54,7 @@
 
 #define CONFIG_ENV_OVERWRITE
 
-#ifdef CONFIG_SYS_NO_FLASH
-#if !defined(CONFIG_RAMBOOT_PBL) && !defined(CONFIG_SRIO_PCIE_BOOT_SLAVE)
-#define CONFIG_ENV_IS_NOWHERE
-#endif
+#ifndef CONFIG_MTD_NOR_FLASH
 #else
 #define CONFIG_FLASH_CFI_DRIVER
 #define CONFIG_SYS_FLASH_CFI
@@ -68,7 +63,6 @@
 
 #if defined(CONFIG_SPIFLASH)
        #define CONFIG_SYS_EXTRA_ENV_RELOC
-       #define CONFIG_ENV_IS_IN_SPI_FLASH
        #define CONFIG_ENV_SPI_BUS              0
        #define CONFIG_ENV_SPI_CS               0
        #define CONFIG_ENV_SPI_MAX_HZ           10000000
@@ -78,24 +72,20 @@
        #define CONFIG_ENV_SECT_SIZE            0x10000
 #elif defined(CONFIG_SDCARD)
        #define CONFIG_SYS_EXTRA_ENV_RELOC
-       #define CONFIG_ENV_IS_IN_MMC
        #define CONFIG_FSL_FIXED_MMC_LOCATION
        #define CONFIG_SYS_MMC_ENV_DEV          0
        #define CONFIG_ENV_SIZE                 0x2000
        #define CONFIG_ENV_OFFSET               (512 * 1658)
 #elif defined(CONFIG_NAND)
 #define CONFIG_SYS_EXTRA_ENV_RELOC
-#define CONFIG_ENV_IS_IN_NAND
 #define CONFIG_ENV_SIZE                        CONFIG_SYS_NAND_BLOCK_SIZE
 #define CONFIG_ENV_OFFSET              (7 * CONFIG_SYS_NAND_BLOCK_SIZE)
 #elif defined(CONFIG_SRIO_PCIE_BOOT_SLAVE)
-#define CONFIG_ENV_IS_IN_REMOTE
 #define CONFIG_ENV_ADDR                0xffe20000
 #define CONFIG_ENV_SIZE                0x2000
 #elif defined(CONFIG_ENV_IS_NOWHERE)
 #define CONFIG_ENV_SIZE                0x2000
 #else
-       #define CONFIG_ENV_IS_IN_FLASH
        #define CONFIG_ENV_ADDR         (CONFIG_SYS_MONITOR_BASE \
                        - CONFIG_ENV_SECT_SIZE)
        #define CONFIG_ENV_SIZE         0x2000
@@ -237,7 +227,6 @@ unsigned long get_board_sys_clk(unsigned long dummy);
 
 #define CONFIG_SYS_NAND_BASE_LIST     {CONFIG_SYS_NAND_BASE}
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
-#define CONFIG_CMD_NAND
 #define CONFIG_SYS_NAND_BLOCK_SIZE    (128 * 1024)
 
 /* NAND flash config */
@@ -550,7 +539,6 @@ unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_SATA2_FLAGS         FLAGS_DMA
 
 #define CONFIG_LBA48
-#define CONFIG_CMD_SATA
 #endif
 
 #ifdef CONFIG_FMAN_ENET
@@ -570,7 +558,6 @@ unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_TBIPA_VALUE 8
 #define CONFIG_MII             /* MII PHY management */
 #define CONFIG_ETHPRIME                "FM1@DTSEC1"
-#define CONFIG_PHY_GIGE                /* Include GbE speed/duplex detection */
 #endif
 
 /*
@@ -582,8 +569,6 @@ unsigned long get_board_sys_clk(unsigned long dummy);
 /*
  * Command line configuration.
  */
-#define CONFIG_CMD_ERRATA
-#define CONFIG_CMD_IRQ
 
 #ifdef CONFIG_PCI
 #define CONFIG_CMD_PCI
@@ -596,7 +581,6 @@ unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_HAS_FSL_MPH_USB
 
 #if defined(CONFIG_HAS_FSL_DR_USB) || defined(CONFIG_HAS_FSL_MPH_USB)
-#define CONFIG_USB_EHCI
 #define CONFIG_USB_EHCI_FSL
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #endif
@@ -607,12 +591,6 @@ unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_FSL_ESDHC_BROKEN_TIMEOUT
 #endif
 
-/* Hash command with SHA acceleration supported in hardware */
-#ifdef CONFIG_FSL_CAAM
-#define CONFIG_CMD_HASH
-#define CONFIG_SHA_HW_ACCEL
-#endif
-
 /*
  * Miscellaneous configurable options
  */
@@ -654,9 +632,6 @@ unsigned long get_board_sys_clk(unsigned long dummy);
 /* default location for tftp and bootm */
 #define CONFIG_LOADADDR                1000000
 
-
-#define CONFIG_BAUDRATE        115200
-
 #define __USB_PHY_TYPE utmi
 
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \