Merge branch 'master' of git://git.denx.de/u-boot-nand-flash

[platform/kernel/u-boot.git] / include / configs / P2020DS.h

diff --git a/include/configs/P2020DS.h b/include/configs/P2020DS.h
index cee9fd4..f6b788e 100644 (file)
--- a/include/configs/P2020DS.h
+++ b/include/configs/P2020DS.h
@@ -118,18 +118,8 @@
 #define CONFIG_SYS_L2_SIZE             (512 << 10)
 #define CONFIG_SYS_INIT_L2_END (CONFIG_SYS_INIT_L2_ADDR + CONFIG_SYS_L2_SIZE)
 
-/*
- * Base addresses -- Note these are effective addresses where the
- * actual resources get mapped (not physical addresses)
- */
-#define CONFIG_SYS_CCSRBAR_DEFAULT     0xff700000      /* CCSRBAR Default */
-#define CONFIG_SYS_CCSRBAR             0xffe00000      /* relocated CCSRBAR */
-#ifdef CONFIG_PHYS_64BIT
-#define CONFIG_SYS_CCSRBAR_PHYS                0xfffe00000ull  /* physical addr of CCSRBAR */
-#else
-#define CONFIG_SYS_CCSRBAR_PHYS        CONFIG_SYS_CCSRBAR      /* physical addr of CCSRBAR */
-#endif
-#define CONFIG_SYS_IMMR                CONFIG_SYS_CCSRBAR      /* PQII uses CONFIG_SYS_IMMR */
+#define CONFIG_SYS_CCSRBAR             0xffe00000
+#define CONFIG_SYS_CCSRBAR_PHYS_LOW    CONFIG_SYS_CCSRBAR
 
 /* DDR Setup */
 #define CONFIG_VERY_BIG_RAM
@@ -709,11 +699,11 @@
 
 /*
  * For booting Linux, the board info and command line data
- * have to be in the first 16 MB of memory, since this is
+ * have to be in the first 64 MB of memory, since this is
  * the maximum mapped by the Linux kernel during initialization.
  */
-#define CONFIG_SYS_BOOTMAPSZ   (16 << 20)      /* Initial Memory map for Linux*/
-#define CONFIG_SYS_BOOTM_LEN   (16 << 20)      /* Increase max gunzip size */
+#define CONFIG_SYS_BOOTMAPSZ   (64 << 20)      /* Initial Memory map for Linux*/
+#define CONFIG_SYS_BOOTM_LEN   (64 << 20)      /* Increase max gunzip size */
 
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE   230400  /* speed to run kgdb serial port */
@@ -752,7 +742,8 @@
 
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
  "perf_mode=performance\0"                     \
- "hwconfig=fsl_ddr:ctlr_intlv=bank,bank_intlv=cs0_cs1\0"       \
+       "hwconfig=fsl_ddr:ctlr_intlv=bank,bank_intlv=cs0_cs1;"  \
+       "usb1:dr_mode=host,phy_type=ulpi\0"                     \
  "netdev=eth0\0"                                               \
  "uboot=" MK_STR(CONFIG_UBOOTPATH) "\0"                                \
  "tftpflash=tftpboot $loadaddr $uboot; "                       \