hush.c: Move default CONFIG_SYS_PROMPT_HUSH_PS2 to hush.c

[platform/kernel/u-boot.git] / include / configs / P1_P2_RDB.h

diff --git a/include/configs/P1_P2_RDB.h b/include/configs/P1_P2_RDB.h
index cccf84d..ab88166 100644 (file)
--- a/include/configs/P1_P2_RDB.h
+++ b/include/configs/P1_P2_RDB.h
@@ -148,24 +148,11 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_L2_SIZE             (512 << 10)
 #define CONFIG_SYS_INIT_L2_END         (CONFIG_SYS_INIT_L2_ADDR + CONFIG_SYS_L2_SIZE)
 
-/*
- * Base addresses -- Note these are effective addresses where the
- * actual resources get mapped (not physical addresses)
- */
-#define CONFIG_SYS_CCSRBAR             0xffe00000      /* relocated CCSRBAR */
-#ifdef CONFIG_PHYS_64BIT
-#define CONFIG_SYS_CCSRBAR_PHYS        0xfffe00000ull
-#else
-#define CONFIG_SYS_CCSRBAR_PHYS        CONFIG_SYS_CCSRBAR
-#endif
-                                                       /* CCSRBAR */
-#define CONFIG_SYS_IMMR                CONFIG_SYS_CCSRBAR      /* PQII uses */
-                                                       /* CONFIG_SYS_IMMR */
+#define CONFIG_SYS_CCSRBAR             0xffe00000
+#define CONFIG_SYS_CCSRBAR_PHYS_LOW    CONFIG_SYS_CCSRBAR
 
-#if defined(CONFIG_RAMBOOT_NAND) && !defined(CONFIG_NAND_SPL)
-#define CONFIG_SYS_CCSRBAR_DEFAULT     CONFIG_SYS_CCSRBAR
-#else
-#define CONFIG_SYS_CCSRBAR_DEFAULT     0xff700000      /* CCSRBAR Default */
+#if defined(CONFIG_NAND_SPL)
+#define CONFIG_SYS_CCSR_DO_NOT_RELOCATE
 #endif
 
 /* DDR Setup */
@@ -244,6 +231,7 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_FLASH_AMD_CHECK_DQ7
 
 #define CONFIG_BOARD_EARLY_INIT_R      /* call board_early_init_r function */
+#define CONFIG_MISC_INIT_R
 #define CONFIG_HWCONFIG
 
 #define CONFIG_SYS_INIT_RAM_LOCK       1
@@ -285,11 +273,10 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #endif
 #endif
 
+#define CONFIG_CMD_NAND
 #define CONFIG_SYS_NAND_BASE_LIST      {CONFIG_SYS_NAND_BASE}
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
-#define NAND_MAX_CHIPS                 1
 #define CONFIG_MTD_NAND_VERIFY_WRITE
-#define CONFIG_CMD_NAND                        1
 #define CONFIG_NAND_FSL_ELBC           1
 #define CONFIG_SYS_NAND_BLOCK_SIZE     (16 * 1024)
 
@@ -367,9 +354,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 
 /* Use the HUSH parser */
 #define CONFIG_SYS_HUSH_PARSER
-#ifdef CONFIG_SYS_HUSH_PARSER
-#define CONFIG_SYS_PROMPT_HUSH_PS2 "> "
-#endif
 
 /*
  * Pass open firmware flat tree
@@ -410,6 +394,15 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_RTC_DS1337
 #define CONFIG_SYS_RTC_DS1337_NOOSC
 #define CONFIG_SYS_I2C_RTC_ADDR                0x68
+
+/* eSPI - Enhanced SPI */
+#define CONFIG_FSL_ESPI
+#define CONFIG_SPI_FLASH
+#define CONFIG_SPI_FLASH_SPANSION
+#define CONFIG_CMD_SF
+#define CONFIG_SF_DEFAULT_SPEED                10000000
+#define CONFIG_SF_DEFAULT_MODE         SPI_MODE_0
+
 /*
  * General PCI
  * Memory space is mapped 1-1, but I/O space must start from 0.
@@ -474,7 +467,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 
 #endif /* CONFIG_PCI */
 
-#define CONFIG_NET_MULTI       1
 
 #if defined(CONFIG_TSEC_ENET)
 #define CONFIG_MII             1       /* MII PHY management */
@@ -521,9 +513,19 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
        #define CONFIG_ENV_IS_IN_NAND   1
        #define CONFIG_ENV_SIZE         CONFIG_SYS_NAND_BLOCK_SIZE
        #define CONFIG_ENV_OFFSET       ((512 * 1024) + CONFIG_SYS_NAND_BLOCK_SIZE)
-#elif defined(CONFIG_RAMBOOT_SDCARD) || defined(CONFIG_RAMBOOT_SPIFLASH)
-       #define CONFIG_ENV_IS_NOWHERE   1       /* Store ENV in memory only */
-       #define CONFIG_ENV_ADDR         (CONFIG_SYS_MONITOR_BASE - 0x1000)
+#elif defined(CONFIG_RAMBOOT_SDCARD)
+#define CONFIG_ENV_IS_IN_MMC
+#define CONFIG_FSL_FIXED_MMC_LOCATION
+#define CONFIG_ENV_SIZE                        0x2000
+#define CONFIG_SYS_MMC_ENV_DEV         0
+#elif defined(CONFIG_RAMBOOT_SPIFLASH)
+       #define CONFIG_ENV_IS_IN_SPI_FLASH
+       #define CONFIG_ENV_SPI_BUS      0
+       #define CONFIG_ENV_SPI_CS       0
+       #define CONFIG_ENV_SPI_MAX_HZ   10000000
+       #define CONFIG_ENV_SPI_MODE     0
+       #define CONFIG_ENV_OFFSET       0x100000        /* 1MB */
+       #define CONFIG_ENV_SECT_SIZE    0x10000
        #define CONFIG_ENV_SIZE         0x2000
 #endif
 #else
@@ -575,6 +577,9 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #endif
 #endif
 
+#define CONFIG_HAS_FSL_DR_USB
+
+#if defined(CONFIG_HAS_FSL_DR_USB)
 #define CONFIG_USB_EHCI
 
 #ifdef CONFIG_USB_EHCI
@@ -583,6 +588,7 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_USB_EHCI_FSL
 #define CONFIG_USB_STORAGE
 #endif
+#endif
 
 #if defined(CONFIG_MMC) || defined(CONFIG_USB_EHCI)
 #define CONFIG_CMD_EXT2
@@ -611,11 +617,11 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 
 /*
  * For booting Linux, the board info and command line data
- * have to be in the first 16 MB of memory, since this is
+ * have to be in the first 64 MB of memory, since this is
  * the maximum mapped by the Linux kernel during initialization.
  */
-#define CONFIG_SYS_BOOTMAPSZ   (16 << 20)/* Initial Memory map for Linux*/
-#define CONFIG_SYS_BOOTM_LEN   (16 << 20)      /* Increase max gunzip size */
+#define CONFIG_SYS_BOOTMAPSZ   (64 << 20)/* Initial Memory map for Linux*/
+#define CONFIG_SYS_BOOTM_LEN   (64 << 20)      /* Increase max gunzip size */
 
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE   230400  /* speed to run kgdb serial port */
@@ -633,8 +639,8 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #endif
 
 #define CONFIG_HOSTNAME                P2020RDB
-#define CONFIG_ROOTPATH                /opt/nfsroot
-#define CONFIG_BOOTFILE                uImage
+#define CONFIG_ROOTPATH                "/opt/nfsroot"
+#define CONFIG_BOOTFILE                "uImage"
 #define CONFIG_UBOOTPATH       u-boot.bin/* U-Boot image on TFTP server */
 
 /* default location for tftp and bootm */
@@ -669,7 +675,7 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
        "nandfdtaddr=80000\0"           \
        "nandimgsize=400000\0"          \
        "nandfdtsize=80000\0"           \
-       "usb_phy_type=ulpi\0"           \
+       "hwconfig=usb1:dr_mode=host,phy_type=ulpi\0"    \
        "vscfw_addr=ef000000\0" \
        "othbootargs=ramdisk_size=600000\0" \
        "usbfatboot=setenv bootargs root=/dev/ram rw "  \