serial: Remove CONFIG_SERIAL_MULTI from config files

[platform/kernel/u-boot.git] / include / configs / P1_P2_RDB.h

diff --git a/include/configs/P1_P2_RDB.h b/include/configs/P1_P2_RDB.h
index df88b79..a57d9dd 100644 (file)
--- a/include/configs/P1_P2_RDB.h
+++ b/include/configs/P1_P2_RDB.h
@@ -148,24 +148,11 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_L2_SIZE             (512 << 10)
 #define CONFIG_SYS_INIT_L2_END         (CONFIG_SYS_INIT_L2_ADDR + CONFIG_SYS_L2_SIZE)
 
-/*
- * Base addresses -- Note these are effective addresses where the
- * actual resources get mapped (not physical addresses)
- */
-#define CONFIG_SYS_CCSRBAR             0xffe00000      /* relocated CCSRBAR */
-#ifdef CONFIG_PHYS_64BIT
-#define CONFIG_SYS_CCSRBAR_PHYS        0xfffe00000ull
-#else
-#define CONFIG_SYS_CCSRBAR_PHYS        CONFIG_SYS_CCSRBAR
-#endif
-                                                       /* CCSRBAR */
-#define CONFIG_SYS_IMMR                CONFIG_SYS_CCSRBAR      /* PQII uses */
-                                                       /* CONFIG_SYS_IMMR */
+#define CONFIG_SYS_CCSRBAR             0xffe00000
+#define CONFIG_SYS_CCSRBAR_PHYS_LOW    CONFIG_SYS_CCSRBAR
 
-#if defined(CONFIG_RAMBOOT_NAND) && !defined(CONFIG_NAND_SPL)
-#define CONFIG_SYS_CCSRBAR_DEFAULT     CONFIG_SYS_CCSRBAR
-#else
-#define CONFIG_SYS_CCSRBAR_DEFAULT     0xff700000      /* CCSRBAR Default */
+#if defined(CONFIG_NAND_SPL)
+#define CONFIG_SYS_CCSR_DO_NOT_RELOCATE
 #endif
 
 /* DDR Setup */
@@ -286,11 +273,10 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #endif
 #endif
 
+#define CONFIG_CMD_NAND
 #define CONFIG_SYS_NAND_BASE_LIST      {CONFIG_SYS_NAND_BASE}
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
-#define NAND_MAX_CHIPS                 1
 #define CONFIG_MTD_NAND_VERIFY_WRITE
-#define CONFIG_CMD_NAND                        1
 #define CONFIG_NAND_FSL_ELBC           1
 #define CONFIG_SYS_NAND_BLOCK_SIZE     (16 * 1024)
 
@@ -357,7 +343,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_NS16550_MIN_FUNCTIONS
 #endif
 
-#define CONFIG_SERIAL_MULTI    1 /* Enable both serial ports */
 #define CONFIG_SYS_CONSOLE_IS_IN_ENV   /* determine from environment */
 
 #define CONFIG_SYS_BAUDRATE_TABLE      \
@@ -368,9 +353,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 
 /* Use the HUSH parser */
 #define CONFIG_SYS_HUSH_PARSER
-#ifdef CONFIG_SYS_HUSH_PARSER
-#define CONFIG_SYS_PROMPT_HUSH_PS2 "> "
-#endif
 
 /*
  * Pass open firmware flat tree
@@ -484,7 +466,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 
 #endif /* CONFIG_PCI */
 
-#define CONFIG_NET_MULTI       1
 
 #if defined(CONFIG_TSEC_ENET)
 #define CONFIG_MII             1       /* MII PHY management */
@@ -533,6 +514,7 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
        #define CONFIG_ENV_OFFSET       ((512 * 1024) + CONFIG_SYS_NAND_BLOCK_SIZE)
 #elif defined(CONFIG_RAMBOOT_SDCARD)
 #define CONFIG_ENV_IS_IN_MMC
+#define CONFIG_FSL_FIXED_MMC_LOCATION
 #define CONFIG_ENV_SIZE                        0x2000
 #define CONFIG_SYS_MMC_ENV_DEV         0
 #elif defined(CONFIG_RAMBOOT_SPIFLASH)
@@ -594,6 +576,9 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #endif
 #endif
 
+#define CONFIG_HAS_FSL_DR_USB
+
+#if defined(CONFIG_HAS_FSL_DR_USB)
 #define CONFIG_USB_EHCI
 
 #ifdef CONFIG_USB_EHCI
@@ -601,7 +586,7 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
 #define CONFIG_USB_STORAGE
-#define CONFIG_HAS_FSL_DR_USB
+#endif
 #endif
 
 #if defined(CONFIG_MMC) || defined(CONFIG_USB_EHCI)
@@ -653,8 +638,8 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #endif
 
 #define CONFIG_HOSTNAME                P2020RDB
-#define CONFIG_ROOTPATH                /opt/nfsroot
-#define CONFIG_BOOTFILE                uImage
+#define CONFIG_ROOTPATH                "/opt/nfsroot"
+#define CONFIG_BOOTFILE                "uImage"
 #define CONFIG_UBOOTPATH       u-boot.bin/* U-Boot image on TFTP server */
 
 /* default location for tftp and bootm */
@@ -667,14 +652,19 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
        "netdev=eth0\0"                                         \
-       "uboot=" MK_STR(CONFIG_UBOOTPATH) "\0"                          \
-       "loadaddr=1000000\0"                    \
+       "uboot=" __stringify(CONFIG_UBOOTPATH) "\0"             \
+       "loadaddr=1000000\0"                                    \
        "tftpflash=tftpboot $loadaddr $uboot; "                 \
-               "protect off " MK_STR(CONFIG_SYS_TEXT_BASE) " +$filesize; "     \
-               "erase " MK_STR(CONFIG_SYS_TEXT_BASE) " +$filesize; "           \
-               "cp.b $loadaddr " MK_STR(CONFIG_SYS_TEXT_BASE) " $filesize; "   \
-               "protect on " MK_STR(CONFIG_SYS_TEXT_BASE) " +$filesize; "              \
-               "cmp.b $loadaddr " MK_STR(CONFIG_SYS_TEXT_BASE) " $filesize\0"  \
+               "protect off " __stringify(CONFIG_SYS_TEXT_BASE)        \
+                       " +$filesize; " \
+               "erase " __stringify(CONFIG_SYS_TEXT_BASE)              \
+                       " +$filesize; " \
+               "cp.b $loadaddr " __stringify(CONFIG_SYS_TEXT_BASE)     \
+                       " $filesize; "  \
+               "protect on " __stringify(CONFIG_SYS_TEXT_BASE)         \
+                       " +$filesize; " \
+               "cmp.b $loadaddr " __stringify(CONFIG_SYS_TEXT_BASE)    \
+                       " $filesize\0"  \
        "consoledev=ttyS0\0"                            \
        "ramdiskaddr=2000000\0"                 \
        "ramdiskfile=rootfs.ext2.gz.uboot\0"            \