Convert CONFIG_CMD_REGINFO to Kconfig

[platform/kernel/u-boot.git] / include / configs / P1010RDB.h

diff --git a/include/configs/P1010RDB.h b/include/configs/P1010RDB.h
index 78e0064..384027c 100644 (file)
--- a/include/configs/P1010RDB.h
+++ b/include/configs/P1010RDB.h
@@ -11,7 +11,6 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
-#define CONFIG_E500                    /* BOOKE e500 family */
 #include <asm/config_mpc85xx.h>
 #define CONFIG_NAND_FSL_IFC
 
@@ -131,10 +130,6 @@
 #endif
 
 /* High Level Configuration Options */
-#define CONFIG_BOOKE                   /* BOOKE */
-#define CONFIG_E500                    /* BOOKE e500 family */
-#define CONFIG_FSL_IFC                 /* Enable IFC Support */
-#define CONFIG_FSL_CAAM                        /* Enable SEC/CAAM */
 #define CONFIG_SYS_HAS_SERDES          /* common SERDES init code */
 
 #if defined(CONFIG_PCI)
@@ -145,8 +140,6 @@
 #define CONFIG_FSL_PCIE_RESET          /* need PCIe reset errata */
 #define CONFIG_SYS_PCI_64BIT           /* enable 64-bit PCI resources */
 
-#define CONFIG_CMD_PCI
-
 /*
  * PCI Windows
  * Memory space is mapped 1-1, but I/O space must start from 0.
@@ -196,7 +189,6 @@
 #endif
 
 #define CONFIG_PCI_SCAN_SHOW           /* show pci devices on startup */
-#define CONFIG_DOS_PARTITION
 #endif
 
 #define CONFIG_TSEC_ENET
@@ -227,7 +219,6 @@
 #define CONFIG_PANIC_HANG              /* do not reset board on panic */
 
 /* DDR Setup */
-#define CONFIG_SYS_FSL_DDR3
 #define CONFIG_SYS_DDR_RAW_TIMING
 #define CONFIG_DDR_SPD
 #define CONFIG_SYS_SPD_BUS_NUM         1
@@ -309,9 +300,6 @@ extern unsigned long get_sdram_size(void);
  * IFC Definitions
  */
 /* NOR Flash on IFC */
-#ifdef CONFIG_SPL_BUILD
-#define CONFIG_SYS_NO_FLASH
-#endif
 
 #define CONFIG_SYS_FLASH_BASE          0xee000000
 #define CONFIG_SYS_MAX_FLASH_SECT      256     /* 32M */
@@ -364,7 +352,6 @@ extern unsigned long get_sdram_size(void);
 
 #define CONFIG_MTD_DEVICE
 #define CONFIG_MTD_PARTITION
-#define CONFIG_CMD_MTDPARTS
 #define MTDIDS_DEFAULT                 "nand0=ff800000.flash"
 #define MTDPARTS_DEFAULT               \
        "mtdparts=ff800000.flash:2m(uboot-env),1m(dtb),5m(kernel),56m(fs),-(usr)"
@@ -399,7 +386,6 @@ extern unsigned long get_sdram_size(void);
 
 #define CONFIG_SYS_NAND_BASE_LIST      { CONFIG_SYS_NAND_BASE }
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
-#define CONFIG_CMD_NAND
 
 #if defined(CONFIG_TARGET_P1010RDB_PA)
 /* NAND Flash Timing Params */
@@ -508,7 +494,6 @@ extern unsigned long get_sdram_size(void);
 #endif
 #endif
 
-#define CONFIG_BOARD_EARLY_INIT_F      /* Call board_pre_init */
 #define CONFIG_BOARD_EARLY_INIT_R
 
 #define CONFIG_SYS_INIT_RAM_LOCK
@@ -600,7 +585,6 @@ extern unsigned long get_sdram_size(void);
 #define MAX_NUM_PORTS                  9 /* for 128Bytes EEPROM */
 #endif
 /* enable read and write access to EEPROM */
-#define CONFIG_CMD_EEPROM
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -643,8 +627,6 @@ extern unsigned long get_sdram_size(void);
 
 #define CONFIG_ETHPRIME                "eTSEC1"
 
-#define CONFIG_PHY_GIGE                /* Include GbE speed/duplex detection */
-
 /* TBI PHY configuration for SGMII mode */
 #define CONFIG_TSEC_TBICR_SETTINGS ( \
                TBICR_PHY_RESET \
@@ -669,24 +651,18 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_SATA2               CONFIG_SYS_MPC85xx_SATA2_ADDR
 #define CONFIG_SYS_SATA2_FLAGS         FLAGS_DMA
 
-#define CONFIG_CMD_SATA
 #define CONFIG_LBA48
 #endif /* #ifdef CONFIG_FSL_SATA  */
 
-#define CONFIG_MMC
 #ifdef CONFIG_MMC
-#define CONFIG_DOS_PARTITION
 #define CONFIG_FSL_ESDHC
-#define CONFIG_GENERIC_MMC
 #define CONFIG_SYS_FSL_ESDHC_ADDR      CONFIG_SYS_MPC85xx_ESDHC_ADDR
 #endif
 
 #define CONFIG_HAS_FSL_DR_USB
 
 #if defined(CONFIG_HAS_FSL_DR_USB)
-#define CONFIG_USB_EHCI
-
-#ifdef CONFIG_USB_EHCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
 #endif
@@ -696,12 +672,10 @@ extern unsigned long get_sdram_size(void);
  * Environment
  */
 #if defined(CONFIG_SDCARD)
-#define CONFIG_ENV_IS_IN_MMC
 #define CONFIG_FSL_FIXED_MMC_LOCATION
 #define CONFIG_SYS_MMC_ENV_DEV         0
 #define CONFIG_ENV_SIZE                        0x2000
 #elif defined(CONFIG_SPIFLASH)
-#define CONFIG_ENV_IS_IN_SPI_FLASH
 #define CONFIG_ENV_SPI_BUS     0
 #define CONFIG_ENV_SPI_CS      0
 #define CONFIG_ENV_SPI_MAX_HZ  10000000
@@ -710,7 +684,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_ENV_SECT_SIZE   0x10000
 #define CONFIG_ENV_SIZE                0x2000
 #elif defined(CONFIG_NAND)
-#define CONFIG_ENV_IS_IN_NAND
 #ifdef CONFIG_TPL_BUILD
 #define CONFIG_ENV_SIZE                0x2000
 #define CONFIG_ENV_ADDR                (CONFIG_SYS_INIT_L2_ADDR + (160 << 10))
@@ -725,11 +698,9 @@ extern unsigned long get_sdram_size(void);
 #endif
 #define CONFIG_ENV_OFFSET      (1024 * 1024)
 #elif defined(CONFIG_SYS_RAMBOOT)
-#define CONFIG_ENV_IS_NOWHERE          /* Store ENV in memory only */
 #define CONFIG_ENV_ADDR                        (CONFIG_SYS_MONITOR_BASE - 0x1000)
 #define CONFIG_ENV_SIZE                        0x2000
 #else
-#define CONFIG_ENV_IS_IN_FLASH
 #define CONFIG_ENV_ADDR        (CONFIG_SYS_MONITOR_BASE - CONFIG_ENV_SECT_SIZE)
 #define CONFIG_ENV_SIZE                0x2000
 #define CONFIG_ENV_SECT_SIZE   0x20000 /* 128K (one sector) */
@@ -738,25 +709,10 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_LOADS_ECHO              /* echo on for serial download */
 #define CONFIG_SYS_LOADS_BAUD_CHANGE   /* allow baudrate change */
 
-/*
- * Command line configuration.
- */
-#define CONFIG_CMD_DATE
-#define CONFIG_CMD_ERRATA
-#define CONFIG_CMD_IRQ
-#define CONFIG_CMD_REGINFO
-
 #undef CONFIG_WATCHDOG                 /* watchdog disabled */
 
-#if defined(CONFIG_MMC) || defined(CONFIG_USB_EHCI) \
+#if defined(CONFIG_MMC) || defined(CONFIG_USB_EHCI_HCD) \
                 || defined(CONFIG_FSL_SATA)
-#define CONFIG_DOS_PARTITION
-#endif
-
-/* Hash command with SHA acceleration supported in hardware */
-#ifdef CONFIG_FSL_CAAM
-#define CONFIG_CMD_HASH
-#define CONFIG_SHA_HW_ACCEL
 #endif
 
 /*
@@ -808,8 +764,6 @@ extern unsigned long get_sdram_size(void);
 
 #undef  CONFIG_BOOTARGS                /* the boot command will set bootargs */
 
-#define CONFIG_BAUDRATE                115200
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
        "hwconfig=" __stringify(CONFIG_DEF_HWCONFIG)  "\0"      \
        "netdev=eth0\0"                                         \