*/
#define CONFIG_E300 1
#define CONFIG_MPC83xx 1
-#define CONFIG_MPC834X 1
+#define CONFIG_MPC834x 1
#define CONFIG_MPC8343 1
+#define CONFIG_SYS_TEXT_BASE 0xFFF00000
+
#define CONFIG_SYS_IMMR 0xE0000000
#define CONFIG_PCI
-#define CONFIG_83XX_GENERIC_PCI
#define CONFIG_PCI_SKIP_HOST_BRIDGE
#define CONFIG_HARD_I2C
#define CONFIG_TSEC_ENET
#define CONFIG_MPC8XXX_SPI
#define CONFIG_HARD_SPI
#define MVBLM7_MMC_CS 0x04000000
+#define CONFIG_MISC_INIT_R
/* I2C */
-#undef CONFIG_SOFT_I2C
-
#define CONFIG_FSL_I2C
#define CONFIG_I2C_MULTI_BUS
#define CONFIG_SYS_I2C_OFFSET 0x3000
/*
* DDR Setup
*/
+#undef CONFIG_SPD_EEPROM
+
#define CONFIG_SYS_DDR_BASE 0x00000000
#define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_BASE
#define CONFIG_SYS_DDR_SDRAM_BASE CONFIG_SYS_DDR_BASE
#define CONFIG_SYS_83XX_DDR_USES_CS0 1
#define CONFIG_SYS_MEMTEST_START (60<<20)
#define CONFIG_SYS_MEMTEST_END (70<<20)
+#define CONFIG_VERY_BIG_RAM
-#define CONFIG_SYS_DDR_SDRAM_CLK_CNTL (DDR_SDRAM_CLK_CNTL_SS_EN | \
- DDR_SDRAM_CLK_CNTL_CLK_ADJUST_05
+#define CONFIG_SYS_DDRCDR 0x22000001
+#define CONFIG_SYS_DDR_SDRAM_CLK_CNTL DDR_SDRAM_CLK_CNTL_CLK_ADJUST_05
-#define CONFIG_SYS_DDR_SIZE 256
+#define CONFIG_SYS_DDR_SIZE 512
-/* HC, 75Ohm, DDR-II, DRQ */
-#define CONFIG_SYS_DDRCDR 0x80000001
-/* EN, ODT_WR, 3BA, 14row, 10col */
-#define CONFIG_SYS_DDR_CS0_CONFIG 0x80014102
-#define CONFIG_SYS_DDR_CS1_CONFIG 0x0
-#define CONFIG_SYS_DDR_CS2_CONFIG 0x0
-#define CONFIG_SYS_DDR_CS3_CONFIG 0x0
+#define CONFIG_SYS_DDR_CS0_CONFIG 0x80014202
-#define CONFIG_SYS_DDR_CS0_BNDS 0x0000000f
-#define CONFIG_SYS_DDR_CS1_BNDS 0x0
-#define CONFIG_SYS_DDR_CS2_BNDS 0x0
-#define CONFIG_SYS_DDR_CS3_BNDS 0x0
+#define CONFIG_SYS_DDR_CS0_BNDS 0x0000003f
-#define CONFIG_SYS_DDR_CLK_CNTL 0x02000000
+#define CONFIG_SYS_DDR_TIMING_0 0x00260802
+#define CONFIG_SYS_DDR_TIMING_1 0x3837c322
+#define CONFIG_SYS_DDR_TIMING_2 0x0f9848c6
+#define CONFIG_SYS_DDR_TIMING_3 0x00000000
-#define CONFIG_SYS_DDR_TIMING_0 0x00260802
-#define CONFIG_SYS_DDR_TIMING_1 0x2625b221
-#define CONFIG_SYS_DDR_TIMING_2 0x1f9820c7
-#define CONFIG_SYS_DDR_TIMING_3 0x00000000
-
-/* ~MEM_EN, SREN, DDR-II, 32_BE */
-#define CONFIG_SYS_DDR_SDRAM_CFG 0x43080000
+#define CONFIG_SYS_DDR_SDRAM_CFG 0x43080008
#define CONFIG_SYS_DDR_SDRAM_CFG2 0x00401000
-#define CONFIG_SYS_DDR_INTERVAL 0x04060100
+#define CONFIG_SYS_DDR_INTERVAL 0x02000100
-#define CONFIG_SYS_DDR_MODE 0x078e0232
+#define CONFIG_SYS_DDR_MODE 0x04040242
+#define CONFIG_SYS_DDR_MODE2 0x00800000
/* Flash */
#define CONFIG_SYS_FLASH_CFI
/*
* U-Boot memory configuration
*/
-#define CONFIG_SYS_MONITOR_BASE TEXT_BASE
+#define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_TEXT_BASE
#undef CONFIG_SYS_RAMBOOT
#define CONFIG_SYS_INIT_RAM_LOCK
* External Local Bus rate is
* CLKIN * HRCWL_CSB_TO_CLKIN / HRCWL_LCL_BUS_TO_SCB_CLK / LCRR_CLKDIV
*/
-#define CONFIG_SYS_LCRR (LCRR_DBYP | LCRR_CLKDIV_4)
+#define CONFIG_SYS_LCRR_DBYP LCRR_DBYP
+#define CONFIG_SYS_LCRR_CLKDIV LCRR_CLKDIV_4
#define CONFIG_SYS_LBC_LBCR 0x00000000
/* LB sdram refresh timer, about 6us */
* Serial Port
*/
#define CONFIG_CONS_INDEX 1
-#undef CONFIG_SERIAL_SOFTWARE_FIFO
#define CONFIG_SYS_NS16550
#define CONFIG_SYS_NS16550_SERIAL
#define CONFIG_SYS_NS16550_REG_SIZE 1
#define CONFIG_SYS_PCI1_IO_PHYS 0xE2000000
#define CONFIG_SYS_PCI1_IO_SIZE 0x01000000
-#define _IO_BASE 0x00000000
-
#define CONFIG_NET_MULTI 1
#define CONFIG_NET_RETRY_COUNT 3
-#define PCI_66M
+#define CONFIG_PCI_66M
#define CONFIG_83XX_CLKIN 66666667
#define CONFIG_PCI_PNP
#define CONFIG_PCI_SCAN_SHOW
#define CONFIG_BOOTP_SEND_HOSTNAME
/* USB */
+#define CONFIG_SYS_USB_HOST
+#define CONFIG_USB_EHCI
+#define CONFIG_USB_EHCI_FSL
#define CONFIG_HAS_FSL_DR_USB
+#define CONFIG_EHCI_HCD_INIT_AFTER_RESET
/*
* Environment
#define CONFIG_CMD_PCI
#define CONFIG_CMD_I2C
#define CONFIG_CMD_FPGA
+#define CONFIG_CMD_USB
+#define CONFIG_DOS_PARTITION
#undef CONFIG_WATCHDOG
*/
#define CONFIG_SYS_LONGHELP
#define CONFIG_CMDLINE_EDITING
+#define CONFIG_AUTO_COMPLETE /* add autocompletion support */
#define CONFIG_SYS_HUSH_PARSER
#define CONFIG_SYS_PROMPT_HUSH_PS2 "> "
/*
* For booting Linux, the board info and command line data
- * have to be in the first 8 MB of memory, since this is
+ * have to be in the first 256 MB of memory, since this is
* the maximum mapped by the Linux kernel during initialization.
*/
-#define CONFIG_SYS_BOOTMAPSZ (8 << 20) /* Initial Memory map for Linux*/
+#define CONFIG_SYS_BOOTMAPSZ (256 << 20) /* Initial Memory map for Linux*/
#define CONFIG_SYS_HRCW_LOW 0x0
#define CONFIG_SYS_HRCW_HIGH 0x0
#define CONFIG_SYS_SICRL (SICRL_LDP_A | SICRL_USB1 | SICRL_USB0)
#define CONFIG_SYS_HID0_INIT 0x000000000
-#define CONFIG_SYS_HID0_FINAL CONFIG_SYS_HID0_INIT
+#define CONFIG_SYS_HID0_FINAL (CONFIG_SYS_HID0_INIT | \
+ HID0_ENABLE_INSTRUCTION_CACHE)
#define CONFIG_SYS_HID2 HID2_HBE
#define CONFIG_HIGH_BATS 1
#define CONFIG_SYS_DBAT7U CONFIG_SYS_IBAT7U
/*
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD 0x01 /* Normal Power-On: Boot from FLASH */
-#define BOOTFLAG_WARM 0x02 /* Software reboot */
-
-
-/*
* Environment Configuration
*/
#define CONFIG_ENV_OVERWRITE
#define MV_CI mvBL-M7
#define MV_VCI mvBL-M7
-#define MV_FPGA_DATA 0xfff80000
-#define MV_FPGA_SIZE 0x00076ca2
+#define MV_FPGA_DATA 0xfff40000
+#define MV_FPGA_SIZE 0
#define MV_KERNEL_ADDR 0xff810000
#define MV_INITRD_ADDR 0xffb00000
-#define MV_SOURCE_ADDR 0xff804000
-#define MV_SOURCE_ADDR2 0xff806000
+#define MV_SCRIPT_ADDR 0xff804000
+#define MV_SCRIPT_ADDR2 0xff806000
#define MV_DTB_ADDR 0xff808000
#define MV_INITRD_LENGTH 0x00400000
#define MV_DTB_ADDR_RAM 0x00600000
#define MV_INITRD_ADDR_RAM 0x01000000
-#define CONFIG_BOOTCOMMAND "if imi ${autoscr_addr}; \
- then source ${autoscr_addr}; \
- else source ${autoscr_addr2}; \
+#define CONFIG_BOOTCOMMAND "if imi ${script_addr}; \
+ then source ${script_addr}; \
+ else source ${script_addr2}; \
fi;"
#define CONFIG_BOOTARGS "root=/dev/ram ro rootfstype=squashfs"
"fpga=0\0" \
"fpgadata=" MK_STR(MV_FPGA_DATA) "\0" \
"fpgadatasize=" MK_STR(MV_FPGA_SIZE) "\0" \
- "autoscr_addr=" MK_STR(MV_SOURCE_ADDR) "\0" \
- "autoscr_addr2=" MK_STR(MV_SOURCE_ADDR2) "\0" \
+ "script_addr=" MK_STR(MV_SCRIPT_ADDR) "\0" \
+ "script_addr2=" MK_STR(MV_SCRIPT_ADDR2) "\0" \
"mv_kernel_addr=" MK_STR(MV_KERNEL_ADDR) "\0" \
"mv_kernel_addr_ram=" MK_STR(MV_KERNEL_ADDR_RAM) "\0" \
"mv_initrd_addr=" MK_STR(MV_INITRD_ADDR) "\0" \
"static_ipaddr=192.168.90.10\0" \
"static_netmask=255.255.255.0\0" \
"static_gateway=0.0.0.0\0" \
- "initrd_name=uInitrd.mvblm7-xenorfs\0" \
+ "initrd_name=uInitrd.mvBL-M7-rfs\0" \
"zcip=no\0" \
"netboot=yes\0" \
"mvtest=Ff\0" \
projects / platform / kernel / u-boot.git / blobdiff