Convert CONFIG_CMD_REGINFO to Kconfig

[platform/kernel/u-boot.git] / include / configs / MPC8572DS.h

diff --git a/include/configs/MPC8572DS.h b/include/configs/MPC8572DS.h
index 2e6989f..0960ff5 100644 (file)
--- a/include/configs/MPC8572DS.h
+++ b/include/configs/MPC8572DS.h
@@ -11,14 +11,8 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
-#define CONFIG_DISPLAY_BOARDINFO
-
 #include "../board/freescale/common/ics307_clk.h"
 
-#ifdef CONFIG_36BIT
-#define CONFIG_PHYS_64BIT
-#endif
-
 #ifndef CONFIG_SYS_TEXT_BASE
 #define CONFIG_SYS_TEXT_BASE   0xeff40000
 #endif
@@ -32,14 +26,8 @@
 #endif
 
 /* High Level Configuration Options */
-#define CONFIG_BOOKE           1       /* BOOKE */
-#define CONFIG_E500            1       /* BOOKE e500 family */
-#define CONFIG_MPC8572         1
-#define CONFIG_MPC8572DS       1
 #define CONFIG_MP              1       /* support multiple processors */
 
-#define CONFIG_FSL_ELBC                1       /* Has Enhanced localbus controller */
-#define CONFIG_PCI             1       /* Enable PCI/PCIE */
 #define CONFIG_PCIE1           1       /* PCIE controller 1 (slot 1) */
 #define CONFIG_PCIE2           1       /* PCIE controller 2 (slot 2) */
 #define CONFIG_PCIE3           1       /* PCIE controller 3 (ULI bridge) */
@@ -48,8 +36,6 @@
 #define CONFIG_FSL_PCIE_RESET  1       /* need PCIe reset errata */
 #define CONFIG_SYS_PCI_64BIT   1       /* enable 64-bit PCI resources */
 
-#define CONFIG_FSL_LAW         1       /* Use common FSL init code */
-
 #define CONFIG_TSEC_ENET               /* tsec ethernet support */
 #define CONFIG_ENV_OVERWRITE
 
@@ -95,7 +81,6 @@
 
 /* DDR Setup */
 #define CONFIG_VERY_BIG_RAM
-#define CONFIG_SYS_FSL_DDR2
 #undef CONFIG_FSL_DDR_INTERACTIVE
 #define CONFIG_SPD_EEPROM              /* Use SPD EEPROM for DDR setup */
 #define CONFIG_DDR_SPD
@@ -107,7 +92,6 @@
 #define CONFIG_SYS_DDR_SDRAM_BASE      0x00000000
 #define CONFIG_SYS_SDRAM_BASE          CONFIG_SYS_DDR_SDRAM_BASE
 
-#define CONFIG_NUM_DDR_CONTROLLERS     2
 #define CONFIG_DIMM_SLOTS_PER_CTLR     1
 #define CONFIG_CHIP_SELECTS_PER_CTRL   2
 
@@ -301,7 +285,6 @@
                                CONFIG_SYS_NAND_BASE + 0x80000,\
                                CONFIG_SYS_NAND_BASE + 0xC0000}
 #define CONFIG_SYS_MAX_NAND_DEVICE    4
-#define CONFIG_CMD_NAND                1
 #define CONFIG_NAND_FSL_ELBC   1
 #define CONFIG_SYS_NAND_BLOCK_SIZE    (128 * 1024)
 #define CONFIG_SYS_NAND_MAX_OOBFREE    5
@@ -468,20 +451,14 @@
 #define VIDEO_IO_OFFSET                CONFIG_SYS_PCIE1_IO_VIRT
 
 /* video */
-#define CONFIG_VIDEO
 
 #if defined(CONFIG_VIDEO)
 #define CONFIG_BIOSEMU
-#define CONFIG_CFB_CONSOLE
-#define CONFIG_VIDEO_SW_CURSOR
-#define CONFIG_VGA_AS_SINGLE_DEVICE
 #define CONFIG_ATI_RADEON_FB
 #define CONFIG_VIDEO_LOGO
 #define CONFIG_SYS_ISA_IO_BASE_ADDRESS VIDEO_IO_OFFSET
 #endif
 
-#define CONFIG_PCI_PNP                 /* do pci plug-and-play */
-
 #undef CONFIG_EEPRO100
 #undef CONFIG_TULIP
 
@@ -492,7 +469,6 @@
 #endif
 
 #define CONFIG_PCI_SCAN_SHOW           /* show pci devices on startup */
-#define CONFIG_DOS_PARTITION
 #define CONFIG_SCSI_AHCI
 
 #ifdef CONFIG_SCSI_AHCI
@@ -543,8 +519,6 @@
 #define TSEC4_PHYIDX           0
 
 #define CONFIG_ETHPRIME                "eTSEC1"
-
-#define CONFIG_PHY_GIGE                1       /* Include GbE speed/duplex detection */
 #endif /* CONFIG_TSEC_ENET */
 
 /*
@@ -554,7 +528,6 @@
 #if defined(CONFIG_SYS_RAMBOOT)
 
 #else
-       #define CONFIG_ENV_IS_IN_FLASH  1
        #if CONFIG_SYS_MONITOR_BASE > 0xfff80000
        #define CONFIG_ENV_ADDR 0xfff80000
        #else
@@ -568,28 +541,13 @@
 #define CONFIG_SYS_LOADS_BAUD_CHANGE   1       /* allow baudrate change */
 
 /*
- * Command line configuration.
- */
-#define CONFIG_CMD_ERRATA
-#define CONFIG_CMD_IRQ
-#define CONFIG_CMD_REGINFO
-
-#if defined(CONFIG_PCI)
-#define CONFIG_CMD_PCI
-#define CONFIG_SCSI
-#endif
-
-/*
  * USB
  */
-#define CONFIG_USB_EHCI
 
-#ifdef CONFIG_USB_EHCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_USB_EHCI_PCI
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
-#define CONFIG_USB_STORAGE
 #define CONFIG_PCI_EHCI_DEVICE                 0
-#define CONFIG_SYS_USB_EHCI_MAX_ROOT_PORTS     2
 #endif
 
 #undef CONFIG_WATCHDOG                 /* watchdog disabled */
@@ -648,8 +606,6 @@
 
 #undef  CONFIG_BOOTARGS                /* the boot command will set bootargs */
 
-#define CONFIG_BAUDRATE        115200
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
 "hwconfig=fsl_ddr:ctlr_intlv=bank,bank_intlv=cs0_cs1,ecc=off\0"                \
 "netdev=eth0\0"                                                \
@@ -668,7 +624,7 @@
 "consoledev=ttyS0\0"                           \
 "ramdiskaddr=2000000\0"                        \
 "ramdiskfile=8572ds/ramdisk.uboot\0"           \
-"fdtaddr=c00000\0"                             \
+"fdtaddr=1e00000\0"                            \
 "fdtfile=8572ds/mpc8572ds.dtb\0"               \
 "bdev=sda3\0"