powerpc/p4080ds: Move ICS refclk define into P4080DS.h

[platform/kernel/u-boot.git] / include / configs / ERIC.h

diff --git a/include/configs/ERIC.h b/include/configs/ERIC.h
index e07f9a1..8a0f850 100644 (file)
--- a/include/configs/ERIC.h
+++ b/include/configs/ERIC.h
@@ -37,6 +37,8 @@
 #define CONFIG_4xx             1       /* ...member of PPC4xx family   */
 #define CONFIG_ERIC            1       /* ...on a ERIC board   */
 
+#define        CONFIG_SYS_TEXT_BASE    0xFFFC0000
+
 #define        CONFIG_BOARD_EARLY_INIT_F 1     /* run board_early_init_f() */
 
 #define CONFIG_SYS_CLK_FREQ    33333333 /* external frequency to pll   */
@@ -139,6 +141,12 @@
 #define CONFIG_SYS_MEMTEST_START       0x0400000       /* memtest works on     */
 #define CONFIG_SYS_MEMTEST_END         0x0C00000       /* 4 ... 12 MB in DRAM  */
 
+#define CONFIG_CONS_INDEX      1
+#define CONFIG_SYS_NS16550
+#define CONFIG_SYS_NS16550_SERIAL
+#define CONFIG_SYS_NS16550_REG_SIZE    1
+#define CONFIG_SYS_NS16550_CLK         get_serial_clock()
+
 #define         CONFIG_SYS_EXT_SERIAL_CLOCK     14318180
 
 /* The following table includes the supported baudrates */
@@ -344,9 +352,8 @@
  * Definitions for initial stack pointer and data area (in DPRAM)
  */
 #define CONFIG_SYS_INIT_RAM_ADDR       0x00df0000  /* inside of SDRAM                 */
-#define CONFIG_SYS_INIT_RAM_END        0x0f00  /* End of used area in RAM             */
-#define CONFIG_SYS_GBL_DATA_SIZE       64  /* size in bytes reserved for initial data */
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_INIT_RAM_SIZE       0x0f00  /* Size of used area in RAM            */
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET      CONFIG_SYS_GBL_DATA_OFFSET
 
 /*-----------------------------------------------------------------------
@@ -355,14 +362,6 @@
  */
 #define SPD_EEPROM_ADDRESS      0x50
 
-/*
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD  0x01            /* Normal Power-On: Boot from FLASH     */
-#define BOOTFLAG_WARM  0x02            /* Software reboot                      */
-
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE   230400  /* speed to run kgdb serial port */
 #define CONFIG_KGDB_SER_INDEX  2       /* which serial port to use */