* (easy to change)
*/
+#define CONFIG_SYS_TEXT_BASE 0xFFF00000
+
/* these hardware addresses are pretty bogus, please change them to
suit your needs */
* Definitions for initial stack pointer and data area
*/
#define CONFIG_SYS_INIT_RAM_ADDR 0x00fd0000 /* above the memtest region */
-#define CONFIG_SYS_INIT_RAM_END 0x4000
-#define CONFIG_SYS_GBL_DATA_SIZE 64 /* size in bytes reserved for init data */
-#define CONFIG_SYS_GBL_DATA_OFFSET (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_INIT_RAM_SIZE 0x4000
+#define CONFIG_SYS_GBL_DATA_OFFSET (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
#define CONFIG_SYS_INIT_SP_OFFSET CONFIG_SYS_GBL_DATA_OFFSET
/*
*
*/
/* No command line, one static partition, whole device */
-#undef CONFIG_JFFS2_CMDLINE
+#undef CONFIG_CMD_MTDPARTS
#define CONFIG_JFFS2_DEV "nor0"
#define CONFIG_JFFS2_PART_SIZE 0xFFFFFFFF
#define CONFIG_JFFS2_PART_OFFSET 0x00000000
/* mtdparts command line support */
/* Note: fake mtd_id used, no linux mtd map file */
/*
-#define CONFIG_JFFS2_CMDLINE
+#define CONFIG_CMD_MTDPARTS
#define MTDIDS_DEFAULT "nor0=elppc-0,nor1=elppc-1"
#define MTDPARTS_DEFAULT "mtdparts=elppc-0:-(jffs2),elppc-1:-(user)"
*/
/*
* Speed settings are board specific
*/
-#define CONFIG_SYS_BUS_HZ 100000000
-#define CONFIG_SYS_CPU_CLK 400000000
-#define CONFIG_SYS_BUS_CLK CONFIG_SYS_BUS_HZ
+#define CONFIG_SYS_BUS_CLK 100000000
+#define CONFIG_SYS_CPU_CLK 400000000
/*
* For booting Linux, the board info and command line data
#endif
#define L2_ENABLE (L2_INIT | L2CR_L2E)
-/*
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD 0x01 /* Normal Power-On: Boot from FLASH */
-#define BOOTFLAG_WARM 0x02 /* Software reboot */
-
-#define CONFIG_NET_MULTI /* Multi ethernet cards support */
#define CONFIG_EEPRO100
#define CONFIG_SYS_RX_ETH_BUFFER 8 /* use 8 rx buffer on eepro100 */
#define CONFIG_EEPRO100_SROM_WRITE