Makefile: move all Power Architecture boards into boards.cfg

[platform/kernel/u-boot.git] / include / configs / CPCI405DT.h

diff --git a/include/configs/CPCI405DT.h b/include/configs/CPCI405DT.h
index 4e94dfc..342bcc3 100644 (file)
--- a/include/configs/CPCI405DT.h
+++ b/include/configs/CPCI405DT.h
@@ -38,7 +38,10 @@
 #define CONFIG_CPCI405         1       /* ...on a CPCI405 board        */
 #define CONFIG_CPCI405_VER2    1       /* ...version 2                 */
 
+#define        CONFIG_SYS_TEXT_BASE    0xFFFC0000
+
 #define CONFIG_BOARD_EARLY_INIT_F 1    /* call board_early_init_f()    */
+#define CONFIG_MISC_INIT_R      1      /* call misc_init_r()           */
 
 #define CONFIG_SYS_CLK_FREQ    33330000 /* external frequency to pll   */
 
@@ -53,6 +56,7 @@
 #define CONFIG_LOADS_ECHO      1       /* echo on for serial download  */
 #define CONFIG_SYS_LOADS_BAUD_CHANGE   1       /* allow baudrate change        */
 
+#define CONFIG_PPC4xx_EMAC
 #define CONFIG_MII             1       /* MII PHY management           */
 #define CONFIG_PHY_ADDR                0       /* PHY address                  */
 #define CONFIG_LXT971_NO_SLEEP  1       /* disable sleep mode in LXT971 */
@@ -133,8 +137,13 @@
 #define CONFIG_SYS_MEMTEST_START       0x0400000       /* memtest works on     */
 #define CONFIG_SYS_MEMTEST_END         0x0C00000       /* 4 ... 12 MB in DRAM  */
 
+#define CONFIG_CONS_INDEX      1       /* Use UART0                    */
+#define CONFIG_SYS_NS16550
+#define CONFIG_SYS_NS16550_SERIAL
+#define CONFIG_SYS_NS16550_REG_SIZE    1
+#define CONFIG_SYS_NS16550_CLK         get_serial_clock()
+
 #undef CONFIG_SYS_EXT_SERIAL_CLOCK            /* no external serial clock used */
-#define CONFIG_SYS_IGNORE_405_UART_ERRATA_59   /* ignore ppc405gp errata #59   */
 #define CONFIG_SYS_BASE_BAUD       691200
 
 /* The following table includes the supported baudrates */
@@ -193,6 +202,8 @@
 #define CONFIG_SYS_PCI_PTM2MS  0xffc00001      /* 4MB, enable                  */
 #define CONFIG_SYS_PCI_PTM2PCI 0x04000000      /* Host: use this pci address   */
 
+#define CONFIG_PCI_4xx_PTM_OVERWRITE   1 /* overwrite PTMx settings by env */
+
 /*-----------------------------------------------------------------------
  * IDE/ATA stuff
  *-----------------------------------------------------------------------
@@ -275,6 +286,7 @@
  * I2C EEPROM (CAT24WC16) for environment
  */
 #define CONFIG_HARD_I2C                        /* I2c with hardware support */
+#define CONFIG_PPC4XX_I2C              /* use PPC4xx driver            */
 #define CONFIG_SYS_I2C_SPEED           400000  /* I2C speed and slave address */
 #define CONFIG_SYS_I2C_SLAVE           0x7F