Convert CONFIG_CMD_ERRATA to Kconfig

[platform/kernel/u-boot.git] / include / configs / BSC9132QDS.h

diff --git a/include/configs/BSC9132QDS.h b/include/configs/BSC9132QDS.h
index f336f28..933a156 100644 (file)
--- a/include/configs/BSC9132QDS.h
+++ b/include/configs/BSC9132QDS.h
@@ -68,8 +68,6 @@
 #endif
 
 /* High Level Configuration Options */
-#define CONFIG_FSL_IFC                 /* Enable IFC Support */
-#define CONFIG_FSL_CAAM                        /* Enable SEC/CAAM */
 #define CONFIG_SYS_HAS_SERDES          /* common SERDES init code */
 
 #if defined(CONFIG_PCI)
@@ -220,9 +218,6 @@ combinations. this should be removed later
  */
 /* NOR Flash on IFC */
 
-#ifdef CONFIG_SPL_BUILD
-#define CONFIG_SYS_NO_FLASH
-#endif
 #define CONFIG_SYS_FLASH_BASE          0x88000000
 #define CONFIG_SYS_MAX_FLASH_SECT      1024    /* Max number of sector: 32M */
 
@@ -422,7 +417,6 @@ combinations. this should be removed later
 #define CONFIG_SYS_EEPROM_BUS_NUM      0
 
 /* enable read and write access to EEPROM */
-#define CONFIG_CMD_EEPROM
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -478,12 +472,10 @@ combinations. this should be removed later
 
 #ifdef CONFIG_MMC
 #define CONFIG_FSL_ESDHC
-#define CONFIG_GENERIC_MMC
 #define CONFIG_SYS_FSL_ESDHC_ADDR      CONFIG_SYS_MPC85xx_ESDHC_ADDR
 #endif
 
-#define CONFIG_USB_EHCI  /* USB */
-#ifdef CONFIG_USB_EHCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
 #define CONFIG_HAS_FSL_DR_USB
@@ -528,15 +520,12 @@ combinations. this should be removed later
 /*
  * Command line configuration.
  */
-#define CONFIG_CMD_DATE
-#define CONFIG_CMD_ERRATA
 #define CONFIG_CMD_IRQ
 #define CONFIG_CMD_REGINFO
 
 /* Hash command with SHA acceleration supported in hardware */
 #ifdef CONFIG_FSL_CAAM
 #define CONFIG_CMD_HASH
-#define CONFIG_SHA_HW_ACCEL
 #endif
 
 /*
@@ -572,7 +561,7 @@ combinations. this should be removed later
 /*
  * Dynamic MTD Partition support with mtdparts
  */
-#ifndef CONFIG_SYS_NO_FLASH
+#ifdef CONFIG_MTD_NOR_FLASH
 #define CONFIG_MTD_DEVICE
 #define CONFIG_MTD_PARTITIONS
 #define CONFIG_CMD_MTDPARTS
@@ -596,8 +585,6 @@ combinations. this should be removed later
 #define CONFIG_BOOTFILE                "uImage"
 #define CONFIG_UBOOTPATH       "u-boot.bin"
 
-#define CONFIG_BAUDRATE                115200
-
 #ifdef CONFIG_SDCARD
 #define CONFIG_DEF_HWCONFIG    "hwconfig=usb1:dr_mode=host,phy_type=ulpi\0"
 #else