configs: Migrate RBTREE, LZO, CMD_MTDPARTS, CMD_UBI and CMD_UBIFS

[platform/kernel/u-boot.git] / include / configs / BSC9132QDS.h

diff --git a/include/configs/BSC9132QDS.h b/include/configs/BSC9132QDS.h
index 942123b..5491c47 100644 (file)
--- a/include/configs/BSC9132QDS.h
+++ b/include/configs/BSC9132QDS.h
@@ -68,7 +68,6 @@
 #endif
 
 /* High Level Configuration Options */
-#define CONFIG_FSL_CAAM                        /* Enable SEC/CAAM */
 #define CONFIG_SYS_HAS_SERDES          /* common SERDES init code */
 
 #if defined(CONFIG_PCI)
@@ -219,9 +218,6 @@ combinations. this should be removed later
  */
 /* NOR Flash on IFC */
 
-#ifdef CONFIG_SPL_BUILD
-#define CONFIG_SYS_NO_FLASH
-#endif
 #define CONFIG_SYS_FLASH_BASE          0x88000000
 #define CONFIG_SYS_MAX_FLASH_SECT      1024    /* Max number of sector: 32M */
 
@@ -421,7 +417,6 @@ combinations. this should be removed later
 #define CONFIG_SYS_EEPROM_BUS_NUM      0
 
 /* enable read and write access to EEPROM */
-#define CONFIG_CMD_EEPROM
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -480,8 +475,7 @@ combinations. this should be removed later
 #define CONFIG_SYS_FSL_ESDHC_ADDR      CONFIG_SYS_MPC85xx_ESDHC_ADDR
 #endif
 
-#define CONFIG_USB_EHCI  /* USB */
-#ifdef CONFIG_USB_EHCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
 #define CONFIG_HAS_FSL_DR_USB
@@ -526,17 +520,8 @@ combinations. this should be removed later
 /*
  * Command line configuration.
  */
-#define CONFIG_CMD_DATE
-#define CONFIG_CMD_ERRATA
-#define CONFIG_CMD_IRQ
 #define CONFIG_CMD_REGINFO
 
-/* Hash command with SHA acceleration supported in hardware */
-#ifdef CONFIG_FSL_CAAM
-#define CONFIG_CMD_HASH
-#define CONFIG_SHA_HW_ACCEL
-#endif
-
 /*
  * Miscellaneous configurable options
  */
@@ -570,10 +555,9 @@ combinations. this should be removed later
 /*
  * Dynamic MTD Partition support with mtdparts
  */
-#ifndef CONFIG_SYS_NO_FLASH
+#ifdef CONFIG_MTD_NOR_FLASH
 #define CONFIG_MTD_DEVICE
 #define CONFIG_MTD_PARTITIONS
-#define CONFIG_CMD_MTDPARTS
 #define CONFIG_FLASH_CFI_MTD
 #define MTDIDS_DEFAULT "nor0=88000000.nor,nand0=ff800000.flash,"
 #define MTDPARTS_DEFAULT "mtdparts=88000000.nor:256k(dtb),7m(kernel)," \
@@ -594,8 +578,6 @@ combinations. this should be removed later
 #define CONFIG_BOOTFILE                "uImage"
 #define CONFIG_UBOOTPATH       "u-boot.bin"
 
-#define CONFIG_BAUDRATE                115200
-
 #ifdef CONFIG_SDCARD
 #define CONFIG_DEF_HWCONFIG    "hwconfig=usb1:dr_mode=host,phy_type=ulpi\0"
 #else