Convert CONFIG_CMD_HASH to Kconfig

[platform/kernel/u-boot.git] / include / configs / BSC9131RDB.h

diff --git a/include/configs/BSC9131RDB.h b/include/configs/BSC9131RDB.h
index a6f73f2..fba25fb 100644 (file)
--- a/include/configs/BSC9131RDB.h
+++ b/include/configs/BSC9131RDB.h
@@ -46,8 +46,6 @@
 #endif
 
 /* High Level Configuration Options */
-#define CONFIG_FSL_IFC                 /* Enable IFC Support */
-#define CONFIG_FSL_CAAM                        /* Enable SEC/CAAM */
 
 #define CONFIG_TSEC_ENET
 #define CONFIG_ENV_OVERWRITE
@@ -148,7 +146,6 @@ extern unsigned long get_sdram_size(void);
 /*
  * IFC Definitions
  */
-#define CONFIG_SYS_NO_FLASH
 
 /* NAND Flash on IFC */
 #define CONFIG_SYS_NAND_BASE           0xff800000
@@ -198,8 +195,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_CS0_FTIM2           CONFIG_SYS_NAND_FTIM2
 #define CONFIG_SYS_CS0_FTIM3           CONFIG_SYS_NAND_FTIM3
 
-#define CONFIG_BOARD_EARLY_INIT_F      /* Call board_pre_init */
-
 #define CONFIG_SYS_INIT_RAM_LOCK
 #define CONFIG_SYS_INIT_RAM_ADDR       0xffd00000      /* stack in RAM */
 #define CONFIG_SYS_INIT_RAM_SIZE       0x00004000/* End of used area in RAM */
@@ -233,7 +228,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_SYS_FSL_I2C_OFFSET      0x3000
 
 /* I2C EEPROM */
-#define CONFIG_CMD_EEPROM
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
@@ -299,9 +293,7 @@ extern unsigned long get_sdram_size(void);
 /*
  * Command line configuration.
  */
-#define CONFIG_CMD_ERRATA
 #define CONFIG_CMD_IRQ
-#define CONFIG_DOS_PARTITION
 #define CONFIG_CMD_REGINFO
 
 /*
@@ -334,15 +326,7 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_KGDB_BAUDRATE   230400  /* speed to run kgdb serial port */
 #endif
 
-/* Hash command with SHA acceleration supported in hardware */
-#ifdef CONFIG_FSL_CAAM
-#define CONFIG_CMD_HASH
-#define CONFIG_SHA_HW_ACCEL
-#endif
-
-#define CONFIG_USB_EHCI
-
-#ifdef CONFIG_USB_EHCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
 #define CONFIG_HAS_FSL_DR_USB
@@ -371,8 +355,6 @@ extern unsigned long get_sdram_size(void);
 #define CONFIG_BOOTFILE                "uImage"
 #define CONFIG_UBOOTPATH       "u-boot.bin" /* U-Boot image on TFTP server */
 
-#define CONFIG_BAUDRATE                115200
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
        "netdev=eth0\0"                                         \
        "uboot=" CONFIG_UBOOTPATH "\0"                          \