#define __CONFIG_H
/*
- * If we are developing, we might want to start armboot from ram
- * so we MUST NOT initialize critical regs like mem-timing ...
- */
-#define CONFIG_INIT_CRITICAL /* undef for developing */
-
-/*
* High Level Configuration Options
* (easy to change)
*/
#define CONFIG_ARM7 1 /* This is a ARM7 CPU */
#define CONFIG_B2 1 /* on an B2 Board */
#define CONFIG_ARM_THUMB 1 /* this is an ARM7TDMI */
-#undef CONFIG_ARM7_REVD /* disable ARM720 REV.D Workarounds */
+#undef CONFIG_ARM7_REVD /* disable ARM720 REV.D Workarounds */
#define CONFIG_S3C44B0_CLOCK_SPEED 75 /* we have a 75Mhz S3C44B0*/
* Size of malloc() pool
*/
#define CFG_MONITOR_LEN (256 * 1024) /* Reserve 256 kB for Monitor */
-#define CFG_ENV_SIZE 1024 /* 1024 bytes may be used for env vars*/
-#define CFG_MALLOC_LEN (CFG_ENV_SIZE + 128*1024 )
+#define CONFIG_ENV_SIZE 1024 /* 1024 bytes may be used for env vars*/
+#define CFG_MALLOC_LEN (CONFIG_ENV_SIZE + 128*1024 )
#define CFG_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */
/*
#define CONFIG_BAUDRATE 115200
-#define CONFIG_BOOTP_MASK (CONFIG_BOOTP_DEFAULT|CONFIG_BOOTP_BOOTFILESIZE)
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_SUBNETMASK
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_BOOTFILESIZE
+
+
+/*
+ * Command line configuration.
+ */
+#include <config_cmd_default.h>
-#define CONFIG_COMMANDS ( CONFIG_CMD_DFL | \
- CFG_CMD_DATE | \
- CFG_CMD_ELF | \
- CFG_CMD_EEPROM | \
- CFG_CMD_I2C )
+#define CONFIG_CMD_DATE
+#define CONFIG_CMD_ELF
+#define CONFIG_CMD_EEPROM
+#define CONFIG_CMD_I2C
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
#define CONFIG_BOOTDELAY 5
#define CONFIG_ETHADDR 00:50:c2:1e:af:fb
/*-----------------------------------------------------------------------
* Environment Variable setup
*/
-#define CFG_ENV_IS_IN_EEPROM 1 /* use EEPROM for environment vars */
-#define CFG_ENV_OFFSET 0x0 /* environment starts at the beginning of the EEPROM */
+#define CONFIG_ENV_IS_IN_EEPROM 1 /* use EEPROM for environment vars */
+#define CONFIG_ENV_OFFSET 0x0 /* environment starts at the beginning of the EEPROM */
/*-----------------------------------------------------------------------
* I2C EEPROM (STM24C02W6) for environment
/* 16 byte page write mode using*/
/* last 4 bits of the address */
#define CFG_EEPROM_PAGE_WRITE_DELAY_MS 10 /* and takes up to 10 msec */
-#define CFG_EEPROM_PAGE_WRITE_ENABLE
/* Flash banks JFFS2 should use */
/*