* FEC_PHYIDX
*/
static struct tsec_info_struct tsec_info[] = {
-#if defined(CONFIG_MPC85XX_TSEC1) || defined(CONFIG_MPC83XX_TSEC1)
-#if defined(CONFIG_MPC8544DS)
+#if defined(CONFIG_TSEC1)
+#if defined(CONFIG_MPC8544DS) || defined(CONFIG_MPC8641HPCN)
{TSEC1_PHY_ADDR, TSEC_GIGABIT | TSEC_REDUCED, TSEC1_PHYIDX},
#else
{TSEC1_PHY_ADDR, TSEC_GIGABIT, TSEC1_PHYIDX},
#endif
-#elif defined(CONFIG_MPC86XX_TSEC1)
- {TSEC1_PHY_ADDR, TSEC_GIGABIT | TSEC_REDUCED, TSEC1_PHYIDX},
#else
{0, 0, 0},
#endif
-#if defined(CONFIG_MPC85XX_TSEC2) || defined(CONFIG_MPC83XX_TSEC2)
- {TSEC2_PHY_ADDR, TSEC_GIGABIT, TSEC2_PHYIDX},
-#elif defined(CONFIG_MPC86XX_TSEC2)
+#if defined(CONFIG_TSEC2)
+#if defined(CONFIG_MPC8641HPCN)
{TSEC2_PHY_ADDR, TSEC_GIGABIT | TSEC_REDUCED, TSEC2_PHYIDX},
#else
+ {TSEC2_PHY_ADDR, TSEC_GIGABIT, TSEC2_PHYIDX},
+#endif
+#else
{0, 0, 0},
#endif
#ifdef CONFIG_MPC85XX_FEC
{FEC_PHY_ADDR, 0, FEC_PHYIDX},
#else
-#if defined(CONFIG_MPC85XX_TSEC3) || defined(CONFIG_MPC83XX_TSEC3) || defined(CONFIG_MPC86XX_TSEC3)
+#if defined(CONFIG_TSEC3)
{TSEC3_PHY_ADDR, TSEC_GIGABIT | TSEC_REDUCED, TSEC3_PHYIDX},
#else
{0, 0, 0},
#endif
-#if defined(CONFIG_MPC85XX_TSEC4) || defined(CONFIG_MPC83XX_TSEC4) || defined(CONFIG_MPC86XX_TSEC4)
+#if defined(CONFIG_TSEC4)
{TSEC4_PHY_ADDR, TSEC_GIGABIT | TSEC_REDUCED, TSEC4_PHYIDX},
#else
{0, 0, 0},
unsigned char reg, unsigned short value);
static int tsec_miiphy_read(char *devname, unsigned char addr,
unsigned char reg, unsigned short *value);
+#ifdef CONFIG_MCAST_TFTP
+static int tsec_mcast_addr (struct eth_device *dev, u8 mcast_mac, u8 set);
+#endif
/* Initialize device structure. Returns success if PHY
* initialization succeeded (i.e. if it recognizes the PHY)
dev->halt = tsec_halt;
dev->send = tsec_send;
dev->recv = tsec_recv;
+#ifdef CONFIG_MCAST_TFTP
+ dev->mcast = tsec_mcast_addr;
+#endif
/* Tell u-boot to get the addr from the env */
for (i = 0; i < 6; i++)
priv->regs->maccfg1 |= MACCFG1_SOFT_RESET;
priv->regs->maccfg1 &= ~(MACCFG1_SOFT_RESET);
-#if defined(CONFIG_MII) || (CONFIG_COMMANDS & CFG_CMD_MII) \
+#if defined(CONFIG_MII) || defined(CONFIG_CMD_MII) \
&& !defined(BITBANGMII)
miiphy_register(dev->name, tsec_miiphy_read, tsec_miiphy_write);
#endif
volatile tsec_t *regs = (volatile tsec_t *)(TSEC_BASE_ADDR);
/* Assign a Physical address to the TBI */
- regs->tbipa = TBIPA_VALUE;
+ regs->tbipa = CFG_TBIPA_VALUE;
regs = (volatile tsec_t *)(TSEC_BASE_ADDR + TSEC_SIZE);
- regs->tbipa = TBIPA_VALUE;
+ regs->tbipa = CFG_TBIPA_VALUE;
asm("sync");
/* Reset MII (due to new addresses) */
phy_run_commands(priv, priv->phyinfo->shutdown);
}
+struct phy_info phy_info_M88E1149S = {
+ 0x1410ca,
+ "Marvell 88E1149S",
+ 4,
+ (struct phy_cmd[]){ /* config */
+ /* Reset and configure the PHY */
+ {MIIM_CONTROL, MIIM_CONTROL_RESET, NULL},
+ {0x1d, 0x1f, NULL},
+ {0x1e, 0x200c, NULL},
+ {0x1d, 0x5, NULL},
+ {0x1e, 0x0, NULL},
+ {0x1e, 0x100, NULL},
+ {MIIM_GBIT_CONTROL, MIIM_GBIT_CONTROL_INIT, NULL},
+ {MIIM_ANAR, MIIM_ANAR_INIT, NULL},
+ {MIIM_CONTROL, MIIM_CONTROL_RESET, NULL},
+ {MIIM_CONTROL, MIIM_CONTROL_INIT, &mii_cr_init},
+ {miim_end,}
+ },
+ (struct phy_cmd[]){ /* startup */
+ /* Status is read once to clear old link state */
+ {MIIM_STATUS, miim_read, NULL},
+ /* Auto-negotiate */
+ {MIIM_STATUS, miim_read, &mii_parse_sr},
+ /* Read the status */
+ {MIIM_88E1011_PHY_STATUS, miim_read,
+ &mii_parse_88E1011_psr},
+ {miim_end,}
+ },
+ (struct phy_cmd[]){ /* shutdown */
+ {miim_end,}
+ },
+};
+
/* The 5411 id is 0x206070, the 5421 is 0x2060e0 */
struct phy_info phy_info_BCM5461S = {
0x02060c1, /* 5461 ID */
},
};
+struct phy_info phy_info_BCM5464S = {
+ 0x02060b1, /* 5464 ID */
+ "Broadcom BCM5464S",
+ 0, /* not clear to me what minor revisions we can shift away */
+ (struct phy_cmd[]) { /* config */
+ /* Reset and configure the PHY */
+ {MIIM_CONTROL, MIIM_CONTROL_RESET, NULL},
+ {MIIM_GBIT_CONTROL, MIIM_GBIT_CONTROL_INIT, NULL},
+ {MIIM_ANAR, MIIM_ANAR_INIT, NULL},
+ {MIIM_CONTROL, MIIM_CONTROL_RESET, NULL},
+ {MIIM_CONTROL, MIIM_CONTROL_INIT, &mii_cr_init},
+ {miim_end,}
+ },
+ (struct phy_cmd[]) { /* startup */
+ /* Status is read once to clear old link state */
+ {MIIM_STATUS, miim_read, NULL},
+ /* Auto-negotiate */
+ {MIIM_STATUS, miim_read, &mii_parse_sr},
+ /* Read the status */
+ {MIIM_BCM54xx_AUXSTATUS, miim_read, &mii_parse_BCM54xx_sr},
+ {miim_end,}
+ },
+ (struct phy_cmd[]) { /* shutdown */
+ {miim_end,}
+ },
+};
+
struct phy_info phy_info_M88E1011S = {
0x01410c6,
"Marvell 88E1011S",
(struct phy_cmd[]){ /* config */
/* Reset and configure the PHY */
{MIIM_CONTROL, MIIM_CONTROL_RESET, NULL},
- {0x1d, 0x1f, NULL},
- {0x1e, 0x200c, NULL},
- {0x1d, 0x5, NULL},
- {0x1e, 0x0, NULL},
- {0x1e, 0x100, NULL},
{0x14, 0x0cd2, NULL}, /* Delay RGMII TX and RX */
{MIIM_GBIT_CONTROL, MIIM_GBIT_CONTROL_INIT, NULL},
{MIIM_ANAR, MIIM_ANAR_INIT, NULL},
"Marvell 88E1145",
4,
(struct phy_cmd[]){ /* config */
+ /* Reset the PHY */
+ {MIIM_CONTROL, MIIM_CONTROL_RESET, NULL},
+
/* Errata E0, E1 */
{29, 0x001b, NULL},
{30, 0x418f, NULL},
{29, 0x0016, NULL},
{30, 0xa2da, NULL},
- /* Reset and configure the PHY */
- {MIIM_CONTROL, MIIM_CONTROL_RESET, NULL},
+ /* Configure the PHY */
{MIIM_GBIT_CONTROL, MIIM_GBIT_CONTROL_INIT, NULL},
{MIIM_ANAR, MIIM_ANAR_INIT, NULL},
{MIIM_88E1011_PHY_SCR, MIIM_88E1011_PHY_MDI_X_AUTO,
&phy_info_cis8204,
&phy_info_cis8201,
&phy_info_BCM5461S,
+ &phy_info_BCM5464S,
&phy_info_M88E1011S,
&phy_info_M88E1111S,
&phy_info_M88E1145,
+ &phy_info_M88E1149S,
&phy_info_dm9161,
&phy_info_lxt971,
&phy_info_VSC8244,
/* loop through all the known PHY types, and find one that */
/* matches the ID we read from the PHY. */
for (i = 0; phy_info[i]; i++) {
- if (phy_info[i]->id == (phy_ID >> phy_info[i]->shift))
+ if (phy_info[i]->id == (phy_ID >> phy_info[i]->shift)) {
theInfo = phy_info[i];
+ break;
+ }
}
if (theInfo == NULL) {
relocated = 1;
}
-#if defined(CONFIG_MII) || (CONFIG_COMMANDS & CFG_CMD_MII) \
+#if defined(CONFIG_MII) || defined(CONFIG_CMD_MII) \
&& !defined(BITBANGMII)
struct tsec_private *get_priv_for_phy(unsigned char phyaddr)
return 0;
}
-#endif /* defined(CONFIG_MII) || (CONFIG_COMMANDS & CFG_CMD_MII)
- && !defined(BITBANGMII) */
+#endif
+
+#ifdef CONFIG_MCAST_TFTP
+
+/* CREDITS: linux gianfar driver, slightly adjusted... thanx. */
+
+/* Set the appropriate hash bit for the given addr */
+
+/* The algorithm works like so:
+ * 1) Take the Destination Address (ie the multicast address), and
+ * do a CRC on it (little endian), and reverse the bits of the
+ * result.
+ * 2) Use the 8 most significant bits as a hash into a 256-entry
+ * table. The table is controlled through 8 32-bit registers:
+ * gaddr0-7. gaddr0's MSB is entry 0, and gaddr7's LSB is
+ * gaddr7. This means that the 3 most significant bits in the
+ * hash index which gaddr register to use, and the 5 other bits
+ * indicate which bit (assuming an IBM numbering scheme, which
+ * for PowerPC (tm) is usually the case) in the tregister holds
+ * the entry. */
+static int
+tsec_mcast_addr (struct eth_device *dev, u8 mcast_mac, u8 set)
+{
+ struct tsec_private *priv = privlist[1];
+ volatile tsec_t *regs = priv->regs;
+ volatile u32 *reg_array, value;
+ u8 result, whichbit, whichreg;
+
+ result = (u8)((ether_crc(MAC_ADDR_LEN,mcast_mac) >> 24) & 0xff);
+ whichbit = result & 0x1f; /* the 5 LSB = which bit to set */
+ whichreg = result >> 5; /* the 3 MSB = which reg to set it in */
+ value = (1 << (31-whichbit));
+
+ reg_array = &(regs->hash.gaddr0);
+
+ if (set) {
+ reg_array[whichreg] |= value;
+ } else {
+ reg_array[whichreg] &= ~value;
+ }
+ return 0;
+}
+#endif /* Multicast TFTP ? */
#endif /* CONFIG_TSEC_ENET */
projects / platform / kernel / u-boot.git / blobdiff