region type. This helps to add support for SoC's like OcteonTX/TX2
where every peripheral is on the PCI bus.
+config PCI_CONFIG_HOST_BRIDGE
+ bool "Configure PCI host bridges"
+ default y if X86
+
config PCI_MAP_SYSTEM_MEMORY
bool "Map local system memory from a virtual base address"
depends on MIPS
support on PCI devices. This helps to skip some devices in BDF
scan that are not present.
+config PCI_SCAN_SHOW
+ bool "Show PCI devices during startup"
+ depends on PCIE_IMX
+
config PCIE_ECAM_GENERIC
bool "Generic ECAM-based PCI host controller support"
help
Note that this must be configured when boot because Linux driver
expects the PCIe RC has been configured in the bootloader.
+config PCI_GT64120
+ bool "GT64120 PCI support"
+ depends on MIPS
+
config PCI_PHYTIUM
bool "Phytium PCIe support"
help
Say Y here if you want to enable PCI controller support on FSL
PowerPC MPC85xx SoC.
+config PCI_MSC01
+ bool "MSC01 PCI support"
+ depends on TARGET_MALTA
+
config PCI_RCAR_GEN2
bool "Renesas RCar Gen2 PCIe driver"
depends on RCAR_32
the device tree but the normal PCI scan technique is used to find
then.
+config SH7751_PCI
+ bool "SH7751 PCI controller support"
+ depends on SH
+ help
+ SuperH PCI Bridge Configuration
+
config PCI_TEGRA
bool "Tegra PCI support"
depends on ARCH_TEGRA