#include <linux/etherdevice.h>
#include <linux/skbuff.h>
#include <linux/slab.h>
-#include <linux/sched.h>
#include <linux/spinlock.h>
#include <linux/delay.h>
#include <linux/crc32.h>
unsigned int phy; /* Index of PHY for this interface */
unsigned int irq_num;
unsigned int id;
+ unsigned int phy_type;
struct timer_list timer;/* Timer that triggers the check phy function */
unsigned int rxtail; /* Next entry in rxring to read */
printk(".\n");
}
- skb->dev = dev;
skb_put(skb, data->rxring[rx].len);
skb->protocol = eth_type_trans(skb, dev);
netif_receive_skb(skb);
if (i == 0)
printk(KERN_ERR "%s function time out \n", __FUNCTION__);
-#if (TSI108_PHY_TYPE == PHY_BCM54XX) /* Broadcom BCM54xx PHY */
- tsi108_write_mii(data, 0x09, 0x0300);
- tsi108_write_mii(data, 0x10, 0x1020);
- tsi108_write_mii(data, 0x1c, 0x8c00);
-#endif
+ if (data->phy_type == TSI108_PHY_BCM54XX) {
+ tsi108_write_mii(data, 0x09, 0x0300);
+ tsi108_write_mii(data, 0x10, 0x1020);
+ tsi108_write_mii(data, 0x1c, 0x8c00);
+ }
tsi108_write_mii(data,
MII_BMCR,
data->mii_if.supports_gmii = mii_check_gmii_support(&data->mii_if);
data->phy = einfo->phy;
+ data->phy_type = einfo->phy_type;
data->irq_num = einfo->irq_num;
data->id = pdev->id;
dev->open = tsi108_open;