Merge branch 'master' of git://git.denx.de/u-boot-arm

[platform/kernel/u-boot.git] / drivers / net / fec_mxc.c

diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c
index 97bf8fe..ec5b9db 100644 (file)
--- a/drivers/net/fec_mxc.c
+++ b/drivers/net/fec_mxc.c
@@ -737,6 +737,28 @@ static int fec_send(struct eth_device *dev, void *packet, int length)
        flush_dcache_range(addr, addr + size);
 
        /*
+        * Below we read the DMA descriptor's last four bytes back from the
+        * DRAM. This is important in order to make sure that all WRITE
+        * operations on the bus that were triggered by previous cache FLUSH
+        * have completed.
+        *
+        * Otherwise, on MX28, it is possible to observe a corruption of the
+        * DMA descriptors. Please refer to schematic "Figure 1-2" in MX28RM
+        * for the bus structure of MX28. The scenario is as follows:
+        *
+        * 1) ARM core triggers a series of WRITEs on the AHB_ARB2 bus going
+        *    to DRAM due to flush_dcache_range()
+        * 2) ARM core writes the FEC registers via AHB_ARB2
+        * 3) FEC DMA starts reading/writing from/to DRAM via AHB_ARB3
+        *
+        * Note that 2) does sometimes finish before 1) due to reordering of
+        * WRITE accesses on the AHB bus, therefore triggering 3) before the
+        * DMA descriptor is fully written into DRAM. This results in occasional
+        * corruption of the DMA descriptor.
+        */
+       readl(addr + size - 4);
+
+       /*
         * Enable SmartDMA transmit task
         */
        fec_tx_task_enable(fec);