by the BCM_SF2_ETH driver.
Say Y to any bcmcygnus based platforms.
+config BCM6348_ETH
+ bool "BCM6348 EMAC support"
+ depends on DM_ETH && ARCH_BMIPS
+ select DMA
+ select DMA_CHANNELS
+ select MII
+ select PHYLIB
+ help
+ This driver supports the BCM6348 Ethernet MAC.
+
+config BCM6368_ETH
+ bool "BCM6368 EMAC support"
+ depends on DM_ETH && ARCH_BMIPS
+ select DMA
+ select MII
+ help
+ This driver supports the BCM6368 Ethernet MAC.
+
config DWC_ETH_QOS
bool "Synopsys DWC Ethernet QOS device support"
depends on DM_ETH
config ETH_DESIGNWARE
bool "Synopsys Designware Ethernet MAC"
select PHYLIB
+ imply ETH_DESIGNWARE_SOCFPGA if ARCH_SOCFPGA
help
This MAC is present in SoCs from various vendors. It supports
100Mbit and 1 Gbit operation. You must enable CONFIG_PHYLIB to
provide the PHY (physical media interface).
config ETH_DESIGNWARE_SOCFPGA
+ select REGMAP
+ select SYSCON
bool "Altera SoCFPGA extras for Synopsys Designware Ethernet MAC"
depends on DM_ETH && ETH_DESIGNWARE
help
config FEC_MXC
bool "FEC Ethernet controller"
- depends on MX5 || MX6 || MX7 || IMX8
+ depends on MX5 || MX6 || MX7 || IMX8 || VF610
help
This driver supports the 10/100 Fast Ethernet controller for
NXP i.MX processors.
+config FMAN_ENET
+ bool "Freescale FMan ethernet support"
+ depends on ARM || PPC
+ help
+ This driver support the Freescale FMan Ethernet controller
+
config FTMAC100
bool "Ftmac100 Ethernet Support"
help
config MT7628_ETH
bool "MediaTek MT7628 Ethernet Interface"
- depends on ARCH_MT7620
+ depends on SOC_MT7628
help
The MediaTek MT7628 ethernet interface is used on MT7628 and
MT7688 based boards.
This driver implements support for the Socionext AVE Ethernet
controller, as found on the Socionext UniPhier family.
+source "drivers/net/mscc_eswitch/Kconfig"
+
config ETHER_ON_FEC1
bool "FEC1"
depends on MPC8XX_FEC
This driver implements support for the (Enhanced) Three-Speed
Ethernet Controller found on Freescale SoCs.
+config MEDIATEK_ETH
+ bool "MediaTek Ethernet GMAC Driver"
+ depends on DM_ETH
+ select PHYLIB
+ select DM_GPIO
+ select DM_RESET
+ help
+ This Driver support MediaTek Ethernet GMAC
+ Say Y to enable support for the MediaTek Ethernet GMAC.
+
+config HIGMACV300_ETH
+ bool "HiSilicon Gigabit Ethernet Controller"
+ depends on DM_ETH
+ select DM_RESET
+ select PHYLIB
+ help
+ This driver supports HIGMACV300 Ethernet controller found on
+ HiSilicon SoCs.
+
endif # NETDEVICES