NAND FLASH commands and notes
+
+See NOTE below!!!
+
+
# (C) Copyright 2003
# Dave Ellis, SIXNET, dge@sixnetio.com
#
#define NAND_ChipID_UNKNOWN 0x00
#define NAND_MAX_FLOORS 1
#define NAND_MAX_CHIPS 1
+
+
+
+NOTE:
+=====
+
+We now use a complete rewrite of the NAND code based on what is in
+2.6.12 Linux kernel.
+
+The old NAND handling code has been re-factored and is now confined
+to only board-specific files and - unfortunately - to the DoC code
+(see below). A new configuration variable has been introduced:
+CFG_NAND_LEGACY, which has to be defined in the board config file if
+that board uses legacy code. If CFG_NAND_LEGACY is defined, the board
+specific config.mk file should also have "BOARDLIBS =
+drivers/nand_legacy/libnand_legacy.a". For boards using the new NAND
+approach (PPChameleon and netstar at the moment) no variable is
+necessary, but the config.mk should have "BOARDLIBS =
+drivers/nand/libnand.a".
+
+The necessary changes have been made to all affected boards, and no
+build breakage has been introduced, except for NETTA and NETTA_ISDN
+targets from MAKEALL. This is due to the fact that these two boards
+use JFFS, which has been adopted to use the new NAND, and at the same
+time use NAND in legacy mode. The breakage will disappear when the
+board-specific code is changed to the new NAND.
+
+As mentioned above, the legacy code is still used by the DoC subsystem.
+The consequence of this is that the legacy NAND can't be removed from
+the tree until the DoC is ported to use the new NAND support (or boards
+with DoC will break).