/*----------------------------------------------------------------------- */
/* Enable two 128MB cachable regions. */
/*----------------------------------------------------------------------- */
- addis r1,r0,0x8000
+ addis r1,r0,0xc000
addi r1,r1,0x0001
mticcr r1 /* instruction cache */
/*****************************************************************************/
#if defined(CONFIG_405GP) || defined(CONFIG_405CR) || \
defined(CONFIG_405EP) || defined(CONFIG_405EZ) || \
- defined(CONFIG_405)
+ defined(CONFIG_405EX) || defined(CONFIG_405)
/*----------------------------------------------------------------------- */
/* Clear and set up some registers. */
/*----------------------------------------------------------------------- */
addi r4,r0,0x0000
+#if !defined(CONFIG_405EX)
mtspr sgr,r4
+#else
+ /*
+ * On 405EX, completely clearing the SGR leads to PPC hangup
+ * upon PCIe configuration access. The PCIe memory regions
+ * need to be guarded!
+ */
+ lis r3,0x0000
+ ori r3,r3,0x7FFC
+ mtspr sgr,r3
+#endif
mtspr dcwr,r4
mtesr r4 /* clear Exception Syndrome Reg */
mttcr r4 /* clear Timer Control Reg */
/*----------------------------------------------------------------------- */
/* Enable two 128MB cachable regions. */
/*----------------------------------------------------------------------- */
- lis r4,0x8000
+ lis r4,0xc000
ori r4,r4,0x0001
mticcr r4 /* instruction cache */
isync
ori r4,r4,0x0000
mtdccr r4 /* data cache */
-#if !(defined(CFG_EBC_PB0AP) && defined(CFG_EBC_PB0CR))
+#if !(defined(CFG_EBC_PB0AP) && defined(CFG_EBC_PB0CR)) || defined(CONFIG_405EX)
/*----------------------------------------------------------------------- */
/* Tune the speed and size for flash CS0 */
/*----------------------------------------------------------------------- */
bl ext_bus_cntlr_init
#endif
+#if !(defined(CFG_INIT_DCACHE_CS) || defined(CFG_TEMP_STACK_OCM))
+ /*
+ * Boards like the Kilauea (405EX) don't have OCM and can't use
+ * DCache for init-ram. So setup stack here directly after the
+ * SDRAM is initialized.
+ */
+ lis r1, CFG_INIT_RAM_ADDR@h
+ ori r1,r1,CFG_INIT_SP_OFFSET /* set up the stack in SDRAM */
+
+ li r0, 0 /* Make room for stack frame header and */
+ stwu r0, -4(r1) /* clear final stack frame so that */
+ stwu r0, -4(r1) /* stack backtraces terminate cleanly */
+ /*
+ * Set up a dummy frame to store reset vector as return address.
+ * this causes stack underflow to reset board.
+ */
+ stwu r1, -8(r1) /* Save back chain and move SP */
+ lis r0, RESET_VECTOR@h /* Address of reset vector */
+ ori r0, r0, RESET_VECTOR@l
+ stwu r1, -8(r1) /* Save back chain and move SP */
+ stw r0, +12(r1) /* Save return addr (underflow vect) */
+#endif /* !(CFG_INIT_DCACHE_CS || !CFG_TEM_STACK_OCM) */
#if defined(CONFIG_405EP)
/*----------------------------------------------------------------------- */
ori r4,r4,0xa000
mtdcr ebccfgd,r4
- /* turn on data chache for this region */
+ /* turn on data cache for this region */
lis r4,0x0080
mtdccr r4
/*----------------------------------------------------------------------- */
bl sdram_init
- /*
- * Setup temporary stack pointer only for boards
- * that do not use SDRAM SPD I2C stuff since it
- * is already initialized to use DCACHE or OCM
- * stacks.
- */
-#if !(defined(CFG_INIT_DCACHE_CS) || defined(CFG_TEMP_STACK_OCM))
- lis r1, CFG_INIT_RAM_ADDR@h
- ori r1,r1,CFG_INIT_SP_OFFSET /* set up the stack in SDRAM */
-
- li r0, 0 /* Make room for stack frame header and */
- stwu r0, -4(r1) /* clear final stack frame so that */
- stwu r0, -4(r1) /* stack backtraces terminate cleanly */
- /*
- * Set up a dummy frame to store reset vector as return address.
- * this causes stack underflow to reset board.
- */
- stwu r1, -8(r1) /* Save back chain and move SP */
- lis r0, RESET_VECTOR@h /* Address of reset vector */
- ori r0, r0, RESET_VECTOR@l
- stwu r1, -8(r1) /* Save back chain and move SP */
- stw r0, +12(r1) /* Save return addr (underflow vect) */
-#endif /* !(CFG_INIT_DCACHE_CS || !CFG_TEM_STACK_OCM) */
-
#ifdef CONFIG_NAND_SPL
bl nand_boot /* will not return */
#else
#endif /* CONFIG_440 */
-/*
- * Cache functions.
- *
- * NOTE: currently the 440s run with dcache _disabled_ once relocated to DRAM,
- * although for some cache-ralated calls stubs have to be provided to satisfy
- * symbols resolution.
- * Icache-related functions are used in POST framework.
- *
- */
-#ifdef CONFIG_440
- .globl dcache_disable
- .globl icache_disable
- .globl icache_enable
-dcache_disable:
-icache_disable:
-icache_enable:
- blr
-
- .globl dcache_status
- .globl icache_status
-dcache_status:
-icache_status:
- mr r3, 0
- blr
-#else
-flush_dcache:
- addis r9,r0,0x0002 /* set mask for EE and CE msr bits */
- ori r9,r9,0x8000
- mfmsr r12 /* save msr */
- andc r9,r12,r9
- mtmsr r9 /* disable EE and CE */
- addi r10,r0,0x0001 /* enable data cache for unused memory */
- mfdccr r9 /* region 0xF8000000-0xFFFFFFFF via */
- or r10,r10,r9 /* bit 31 in dccr */
- mtdccr r10
-
- /* do loop for # of congruence classes. */
- lis r10,(CFG_DCACHE_SIZE / CFG_CACHELINE_SIZE / 2)@ha /* TBS: for large cache sizes */
- ori r10,r10,(CFG_DCACHE_SIZE / CFG_CACHELINE_SIZE / 2)@l
- lis r11,(CFG_DCACHE_SIZE / 2)@ha /* D cache set size - 2 way sets */
- ori r11,r11,(CFG_DCACHE_SIZE / 2)@l /* D cache set size - 2 way sets */
- mtctr r10
- addi r10,r0,(0xE000-0x10000) /* start at 0xFFFFE000 */
- add r11,r10,r11 /* add to get to other side of cache line */
-..flush_dcache_loop:
- lwz r3,0(r10) /* least recently used side */
- lwz r3,0(r11) /* the other side */
- dccci r0,r11 /* invalidate both sides */
- addi r10,r10,CFG_CACHELINE_SIZE /* bump to next line */
- addi r11,r11,CFG_CACHELINE_SIZE /* bump to next line */
- bdnz ..flush_dcache_loop
- sync /* allow memory access to complete */
- mtdccr r9 /* restore dccr */
- mtmsr r12 /* restore msr */
- blr
-
- .globl icache_enable
-icache_enable:
- mflr r8
- bl invalidate_icache
- mtlr r8
- isync
- addis r3,r0, 0x8000 /* set bit 0 */
- mticcr r3
- blr
-
- .globl icache_disable
-icache_disable:
- addis r3,r0, 0x0000 /* clear bit 0 */
- mticcr r3
- isync
- blr
-
- .globl icache_status
-icache_status:
- mficcr r3
- srwi r3, r3, 31 /* >>31 => select bit 0 */
- blr
-
- .globl dcache_enable
-dcache_enable:
- mflr r8
- bl invalidate_dcache
- mtlr r8
- isync
- addis r3,r0, 0x8000 /* set bit 0 */
- mtdccr r3
- blr
-
- .globl dcache_disable
-dcache_disable:
- mflr r8
- bl flush_dcache
- mtlr r8
- addis r3,r0, 0x0000 /* clear bit 0 */
- mtdccr r3
- blr
-
- .globl dcache_status
-dcache_status:
- mfdccr r3
- srwi r3, r3, 31 /* >>31 => select bit 0 */
- blr
-#endif
-
.globl get_pvr
get_pvr:
mfspr r3, PVR
*/
.globl relocate_code
relocate_code:
+#ifdef CONFIG_4xx_DCACHE
+ /*
+ * We need to flush the Init Data before the dcache will be
+ * invalidated
+ */
+
+ /* save regs */
+ mr r9,r3
+ mr r10,r4
+ mr r11,r5
+
+ mr r3,r4
+ addi r4,r4,0x200 /* should be enough for init data */
+ bl flush_dcache_range
+
+ /* restore regs */
+ mr r3,r9
+ mr r4,r10
+ mr r5,r11
+#endif
#if defined(CONFIG_440EP) || defined(CONFIG_440GR) || \
defined(CONFIG_440EPX) || defined(CONFIG_440GRX) || \
defined(CONFIG_440SP) || defined(CONFIG_440SPE)
dccci 0,0 /* Invalidate data cache, now no longer our stack */
sync
isync
- addi r1,r0,0x0000 /* TLB entry #0 */
+#ifdef CFG_TLB_FOR_BOOT_FLASH
+ addi r1,r0,CFG_TLB_FOR_BOOT_FLASH /* Use defined TLB */
+#else
+ addi r1,r0,0x0000 /* Default TLB entry is #0 */
+#endif
tlbre r0,r1,0x0002 /* Read contents */
ori r0,r0,0x0c00 /* Or in the inhibit, write through bit */
tlbwe r0,r1,0x0002 /* Save it out */
ori r4, r4, CFG_MONITOR_BASE@l
lwz r5, GOT(__init_end)
sub r5, r5, r4
- li r6, CFG_CACHELINE_SIZE /* Cache Line Size */
+ li r6, L1_CACHE_BYTES /* Cache Line Size */
/*
* Fix GOT pointer:
lwz r4,GOT(_end)
cmplw 0, r3, r4
- beq 6f
+ beq 7f
li r0, 0
-5:
+
+ andi. r5, r4, 3
+ beq 6f
+ sub r4, r4, r5
+ mtctr r5
+ mr r5, r4
+5: stb r0, 0(r5)
+ addi r5, r5, 1
+ bdnz 5b
+6:
stw r0, 0(r3)
addi r3, r3, 4
cmplw 0, r3, r4
- bne 5b
-6:
+ bne 6b
+7:
mr r3, r9 /* Init Data pointer */
mr r4, r10 /* Destination Address */
bl board_init_r
lwz 3,0x0000(3)
blr
-invalidate_icache:
- iccci r0,r0 /* for 405, iccci invalidates the */
- blr /* entire I cache */
-
-invalidate_dcache:
- addi r6,0,0x0000 /* clear GPR 6 */
- /* Do loop for # of dcache congruence classes. */
- lis r7, (CFG_DCACHE_SIZE / CFG_CACHELINE_SIZE / 2)@ha /* TBS for large sized cache */
- ori r7, r7, (CFG_DCACHE_SIZE / CFG_CACHELINE_SIZE / 2)@l
- /* NOTE: dccci invalidates both */
- mtctr r7 /* ways in the D cache */
-..dcloop:
- dccci 0,r6 /* invalidate line */
- addi r6,r6, CFG_CACHELINE_SIZE /* bump to next line */
- bdnz ..dcloop
- blr
-
/**************************************************************************/
/* PPC405EP specific stuff */
/**************************************************************************/
projects / platform / kernel / u-boot.git / blobdiff