#include <i2c.h>
#include <spd.h>
#include <asm/mmu.h>
-
+#include <asm/fsl_law.h>
#if defined(CONFIG_DDR_ECC) && !defined(CONFIG_ECC_INIT_VIA_DDRCONTROLLER)
extern void dma_init(void);
#define CFG_SUPER_BANK_INTERLEAVING 0
/*
- * Convert picoseconds into clock cycles (rounding up if needed).
+ * Convert picoseconds into DRAM clock cycles (rounding up if needed).
*/
-int
-picos_to_clk(int picos)
+static unsigned int
+picos_to_clk(unsigned int picos)
{
- int clks;
-
- clks = picos / (2000000000 / (get_bus_freq(0) / 1000));
- if (picos % (2000000000 / (get_bus_freq(0) / 1000)) != 0) {
+ /* use unsigned long long to avoid rounding errors */
+ const unsigned long long ULL_2e12 = 2000000000000ULL;
+ unsigned long long clks;
+ unsigned long long clks_temp;
+
+ if (! picos)
+ return 0;
+
+ clks = get_bus_freq(0) * (unsigned long long) picos;
+ clks_temp = clks;
+ clks = clks / ULL_2e12;
+ if (clks_temp % ULL_2e12) {
clks++;
}
- return clks;
+ if (clks > 0xFFFFFFFFULL) {
+ clks = 0xFFFFFFFFULL;
+ }
+
+ return (unsigned int) clks;
}
spd_eeprom_t spd;
unsigned int n_ranks;
unsigned int rank_density;
- unsigned int odt_rd_cfg, odt_wr_cfg;
+ unsigned int odt_rd_cfg, odt_wr_cfg, ba_bits;
unsigned int odt_cfg, mode_odt_enable;
unsigned int refresh_clk;
#ifdef MPC86xx_DDR_SDRAM_CLK_CNTL
odt_wr_cfg = 1; /* Assert ODT on writes to CS0 */
}
+ ba_bits = 0;
+ if (spd.nbanks == 0x8)
+ ba_bits = 1;
+
#ifdef CONFIG_DDR_INTERLEAVE
if (dimm_num != 1) {
#endif
| (odt_rd_cfg << 20)
| (odt_wr_cfg << 16)
+ | (ba_bits << 14)
| (spd.nrow_addr - 12) << 8
| (spd.ncol_addr - 8) );
ddr->cs0_config = ( 1 << 31
| (odt_rd_cfg << 20)
| (odt_wr_cfg << 16)
+ | (ba_bits << 14)
| (spd.nrow_addr - 12) << 8
| (spd.ncol_addr - 8) );
ddr->cs1_config = ( 1<<31
| (odt_rd_cfg << 20)
| (odt_wr_cfg << 16)
+ | (ba_bits << 14)
| (spd.nrow_addr - 12) << 8
| (spd.ncol_addr - 8) );
debug("DDR: cs1_bnds = 0x%08x\n", ddr->cs1_bnds);
ddr->cs2_config = ( 1 << 31
| (odt_rd_cfg << 20)
| (odt_wr_cfg << 16)
+ | (ba_bits << 14)
| (spd.nrow_addr - 12) << 8
| (spd.ncol_addr - 8) );
ddr->cs3_config = ( 1<<31
| (odt_rd_cfg << 20)
| (odt_wr_cfg << 16)
+ | (ba_bits << 14)
| (spd.nrow_addr - 12) << 8
| (spd.ncol_addr - 8) );
debug("DDR: cs3_bnds = 0x%08x\n", ddr->cs3_bnds);
caslat -= 1;
else if (busfreq > max_data_rate) {
printf("DDR: Bus freq %d MHz is not fit for DDR rate %d MHz\n",
- busfreq, max_data_rate);
+ busfreq, max_data_rate);
return 0;
}
}
/*
* Sneak in some Extended Refresh Recovery.
*/
- ddr->ext_refrec = (trfc_high << 16);
- debug("DDR: ext_refrec = 0x%08x\n", ddr->ext_refrec);
+ ddr->timing_cfg_3 = (trfc_high << 16);
+ debug("DDR: timing_cfg_3 = 0x%08x\n", ddr->timing_cfg_3);
ddr->timing_cfg_1 =
(0
spd_eeprom_t spd1,spd2;
volatile ccsr_ddr_t *ddr;
unsigned sdram_cfg_1;
- unsigned char sdram_type, mem_type, config, mod_attr;
+ unsigned char sdram_type, mem_type, mod_attr;
unsigned char d_init;
unsigned int no_dimm1=0, no_dimm2=0;
* Read both dimm slots and decide whether
* or not to enable this controller.
*/
- memset((void *)&spd1,0,sizeof(spd1));
- memset((void *)&spd2,0,sizeof(spd2));
+ memset((void *)&spd1, 0, sizeof(spd1));
+ memset((void *)&spd2, 0, sizeof(spd2));
if (ddr_num == 1) {
CFG_READ_SPD(SPD_EEPROM_ADDRESS1,
0, 1, (uchar *) &spd1, sizeof(spd1));
+#if defined(SPD_EEPROM_ADDRESS2)
CFG_READ_SPD(SPD_EEPROM_ADDRESS2,
0, 1, (uchar *) &spd2, sizeof(spd2));
+#endif
} else {
+#if defined(SPD_EEPROM_ADDRESS3)
CFG_READ_SPD(SPD_EEPROM_ADDRESS3,
0, 1, (uchar *) &spd1, sizeof(spd1));
+#endif
+#if defined(SPD_EEPROM_ADDRESS4)
CFG_READ_SPD(SPD_EEPROM_ADDRESS4,
0, 1, (uchar *) &spd2, sizeof(spd2));
+#endif
}
/*
printf("No memory modules found for DDR controller %d!!\n", ddr_num);
return 0;
} else {
+
+#if defined(CONFIG_DDR_ECC)
+ unsigned char config;
+#endif
mem_type = no_dimm2 ? spd1.mem_type : spd2.mem_type;
/*
{
int memsize_ddr1_dimm1 = 0;
int memsize_ddr1_dimm2 = 0;
+ int memsize_ddr1 = 0;
+ unsigned int law_size_ddr1;
+#ifdef CONFIG_DDR_INTERLEAVE
+ volatile immap_t *immap = (immap_t *)CFG_IMMR;
+ volatile ccsr_ddr_t *ddr1 = &immap->im_ddr1;
+#endif
+
+#if (CONFIG_NUM_DDR_CONTROLLERS > 1)
int memsize_ddr2_dimm1 = 0;
int memsize_ddr2_dimm2 = 0;
- int memsize_total = 0;
- int memsize_ddr1 = 0;
int memsize_ddr2 = 0;
+ unsigned int law_size_ddr2;
+#endif
+
unsigned int ddr1_enabled = 0;
unsigned int ddr2_enabled = 0;
- unsigned int law_size_ddr1;
- unsigned int law_size_ddr2;
- volatile immap_t *immap = (immap_t *)CFG_IMMR;
- volatile ccsr_local_mcm_t *mcm = &immap->im_local_mcm;
+ int memsize_total = 0;
#ifdef CONFIG_DDR_INTERLEAVE
unsigned int law_size_interleaved;
- volatile ccsr_ddr_t *ddr1 = &immap->im_ddr1;
volatile ccsr_ddr_t *ddr2 = &immap->im_ddr2;
memsize_ddr1_dimm1 = spd_init(SPD_EEPROM_ADDRESS1,
/*
* Set up LAWBAR for DDR 1 space.
*/
- mcm->lawbar1 = ((CFG_DDR_SDRAM_BASE >> 12) & 0xfffff);
- mcm->lawar1 = (LAWAR_EN
- | LAWAR_TRGT_IF_DDR_INTERLEAVED
- | (LAWAR_SIZE & law_size_interleaved));
- debug("DDR: LAWBAR1=0x%08x\n", mcm->lawbar1);
- debug("DDR: LAWAR1=0x%08x\n", mcm->lawar1);
+#ifdef CONFIG_FSL_LAW
+ set_next_law(CFG_DDR_SDRAM_BASE, law_size_interleaved, LAW_TRGT_IF_DDR_INTRLV);
+#endif
debug("Interleaved memory size is 0x%08lx\n", memsize_total);
-#ifdef CONFIG_DDR_INTERLEAVE
#if (CFG_PAGE_INTERLEAVING == 1)
printf("Page ");
#elif (CFG_BANK_INTERLEAVING == 1)
#else
printf("Cache-line ");
#endif
-#endif
printf("Interleaved");
return memsize_total * 1024 * 1024;
} else {
(unsigned int)memsize_total * 1024*1024);
memsize_total += memsize_ddr1_dimm1;
+#if defined(SPD_EEPROM_ADDRESS2)
memsize_ddr1_dimm2 = spd_init(SPD_EEPROM_ADDRESS2,
1, 2,
(unsigned int)memsize_total * 1024*1024);
+#endif
memsize_total += memsize_ddr1_dimm2;
/*
/*
* Set up LAWBAR for DDR 1 space.
*/
- mcm->lawbar1 = ((CFG_DDR_SDRAM_BASE >> 12) & 0xfffff);
- mcm->lawar1 = (LAWAR_EN
- | LAWAR_TRGT_IF_DDR1
- | (LAWAR_SIZE & law_size_ddr1));
- debug("DDR: LAWBAR1=0x%08x\n", mcm->lawbar1);
- debug("DDR: LAWAR1=0x%08x\n", mcm->lawar1);
+#ifdef CONFIG_FSL_LAW
+ set_next_law(CFG_DDR_SDRAM_BASE, law_size_ddr1, LAW_TRGT_IF_DDR_1);
+#endif
}
#if (CONFIG_NUM_DDR_CONTROLLERS > 1)
/*
* Set up LAWBAR for DDR 2 space.
*/
- if (ddr1_enabled)
- mcm->lawbar8 = (((memsize_ddr1 * 1024 * 1024) >> 12)
- & 0xfffff);
- else
- mcm->lawbar8 = ((CFG_DDR_SDRAM_BASE >> 12) & 0xfffff);
-
- mcm->lawar8 = (LAWAR_EN
- | LAWAR_TRGT_IF_DDR2
- | (LAWAR_SIZE & law_size_ddr2));
- debug("\nDDR: LAWBAR8=0x%08x\n", mcm->lawbar8);
- debug("DDR: LAWAR8=0x%08x\n", mcm->lawar8);
+#ifdef CONFIG_FSL_LAW
+ set_next_law(
+ (ddr1_enabled ? (memsize_ddr1 * 1024 * 1024) : CFG_DDR_SDRAM_BASE),
+ law_size_ddr2, LAW_TRGT_IF_DDR_2);
+#endif
}
+
+ debug("\nMemory size of DDR2 = 0x%08lx\n", memsize_ddr2);
+
#endif /* CONFIG_NUM_DDR_CONTROLLERS > 1 */
- debug("\nMemory sizes are DDR1 = 0x%08lx, DDR2 = 0x%08lx\n",
- memsize_ddr1, memsize_ddr2);
+ debug("\nMemory size of DDR1 = 0x%08lx\n", memsize_ddr1);
/*
* If neither DDR controller is enabled return 0.
projects / platform / kernel / u-boot.git / blobdiff