doc: board: ti: Move documentation from README to .rst

[platform/kernel/u-boot.git] / configs / pico-imx8mq_defconfig

diff --git a/configs/pico-imx8mq_defconfig b/configs/pico-imx8mq_defconfig
index 6d4bebd..4ee9b88 100644 (file)
--- a/configs/pico-imx8mq_defconfig
+++ b/configs/pico-imx8mq_defconfig
@@ -1,6 +1,6 @@
 CONFIG_ARM=y
 CONFIG_ARCH_IMX8M=y
-CONFIG_SYS_TEXT_BASE=0x40200000
+CONFIG_TEXT_BASE=0x40200000
 CONFIG_SYS_MALLOC_LEN=0x600000
 CONFIG_SPL_GPIO=y
 CONFIG_SPL_LIBCOMMON_SUPPORT=y
@@ -14,9 +14,12 @@ CONFIG_DM_GPIO=y
 CONFIG_DEFAULT_DEVICE_TREE="imx8mq-pico-pi"
 CONFIG_SPL_TEXT_BASE=0x7E1000
 CONFIG_TARGET_PICO_IMX8MQ=y
+CONFIG_DM_RESET=y
+CONFIG_SYS_MONITOR_LEN=524288
 CONFIG_SPL_MMC=y
 CONFIG_SPL_SERIAL=y
 CONFIG_SPL_DRIVERS_MISC=y
+CONFIG_SPL_STACK=0x187ff0
 CONFIG_SPL=y
 CONFIG_IMX_BOOTAUX=y
 CONFIG_SYS_LOAD_ADDR=0x40480000
@@ -24,7 +27,6 @@ CONFIG_REMAKE_ELF=y
 CONFIG_FIT=y
 CONFIG_FIT_EXTERNAL_OFFSET=0x3000
 CONFIG_SPL_LOAD_FIT=y
-# CONFIG_USE_SPL_FIT_GENERATOR is not set
 CONFIG_OF_SYSTEM_SETUP=y
 CONFIG_USE_BOOTCOMMAND=y
 CONFIG_BOOTCOMMAND="mmc dev ${mmcdev}; if mmc rescan; then if run loadbootscript; then run bootscript; else if run loadimage; then run mmcboot; else run netboot; fi; fi; else booti ${loadaddr} - ${fdt_addr}; fi"
@@ -36,7 +38,6 @@ CONFIG_SPL_BSS_START_ADDR=0x180000
 CONFIG_SPL_BSS_MAX_SIZE=0x2000
 CONFIG_SPL_BOARD_INIT=y
 # CONFIG_SPL_SHARES_INIT_SP_ADDR is not set
-CONFIG_SPL_STACK=0x187ff0
 CONFIG_SYS_SPL_MALLOC=y
 CONFIG_HAS_CUSTOM_SPL_MALLOC_START=y
 CONFIG_CUSTOM_SYS_SPL_MALLOC_ADDR=0x42200000
@@ -81,7 +82,6 @@ CONFIG_SUPPORT_EMMC_BOOT=y
 CONFIG_FSL_USDHC=y
 CONFIG_PHYLIB=y
 CONFIG_PHY_ATHEROS=y
-CONFIG_DM_ETH=y
 CONFIG_PHY_GIGE=y
 CONFIG_FEC_MXC=y
 CONFIG_MII=y
@@ -94,7 +94,6 @@ CONFIG_DM_REGULATOR=y
 CONFIG_DM_REGULATOR_FIXED=y
 CONFIG_DM_REGULATOR_GPIO=y
 CONFIG_SPL_POWER_I2C=y
-CONFIG_DM_RESET=y
 CONFIG_DM_SERIAL=y
 CONFIG_MXC_UART=y
 CONFIG_DM_THERMAL=y