configs: Migrate CONFIG_SYS_MAX_FLASH_BANKS to Kconfig

[platform/kernel/u-boot.git] / configs / ls1088aqds_tfa_defconfig

diff --git a/configs/ls1088aqds_tfa_defconfig b/configs/ls1088aqds_tfa_defconfig
index eeb4313..ae00387 100644 (file)
--- a/configs/ls1088aqds_tfa_defconfig
+++ b/configs/ls1088aqds_tfa_defconfig
@@ -14,6 +14,11 @@ CONFIG_ENV_SECT_SIZE=0x40000
 CONFIG_DM_GPIO=y
 CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1088a-qds"
 CONFIG_FSL_USE_PCA9547_MUX=y
+CONFIG_VID=y
+CONFIG_SPL_VID=y
+CONFIG_VID_FLS_ENV="ls1088aqds_vdd_mv"
+CONFIG_VOL_MONITOR_LTC3882_READ=y
+CONFIG_VOL_MONITOR_LTC3882_SET=y
 CONFIG_QSPI_AHB_INIT=y
 CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y
 CONFIG_SEC_FIRMWARE_ARMV8_PSCI=y
@@ -22,9 +27,9 @@ CONFIG_DISTRO_DEFAULTS=y
 CONFIG_FIT_VERBOSE=y
 CONFIG_OF_BOARD_SETUP=y
 CONFIG_OF_STDOUT_VIA_ALIAS=y
+CONFIG_DYNAMIC_SYS_CLK_FREQ=y
 CONFIG_USE_BOOTARGS=y
 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 ramdisk_size=0x3000000 default_hugepagesz=2m hugepagesz=2m hugepages=256"
-# CONFIG_USE_BOOTCOMMAND is not set
 # CONFIG_DISPLAY_BOARDINFO is not set
 CONFIG_DISPLAY_BOARDINFO_LATE=y
 CONFIG_MISC_INIT_R=y
@@ -59,6 +64,7 @@ CONFIG_SATA_CEVA=y
 CONFIG_DYNAMIC_DDR_CLK_FREQ=y
 CONFIG_DDR_ECC=y
 CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
+CONFIG_MPC8XXX_GPIO=y
 CONFIG_DM_I2C=y
 CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
 CONFIG_I2C_MUX=y
@@ -70,12 +76,16 @@ CONFIG_MTD_NOR_FLASH=y
 CONFIG_FLASH_CFI_DRIVER=y
 CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
 CONFIG_SYS_FLASH_CFI=y
+CONFIG_SYS_MAX_FLASH_BANKS=2
 CONFIG_MTD_RAW_NAND=y
 CONFIG_NAND_FSL_IFC=y
 CONFIG_SYS_NAND_ONFI_DETECTION=y
 CONFIG_DM_SPI_FLASH=y
 # CONFIG_SPI_FLASH_BAR is not set
+CONFIG_SPI_FLASH_EON=y
 CONFIG_SPI_FLASH_SPANSION=y
+CONFIG_SPI_FLASH_STMICRO=y
+CONFIG_SPI_FLASH_SST=y
 # CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
 CONFIG_PHYLIB=y
 CONFIG_PHYLIB_10G=y