CONFIG_ARM=y
+CONFIG_SKIP_LOWLEVEL_INIT=y
CONFIG_GIC_V3_ITS=y
CONFIG_TARGET_LS1028AQDS=y
CONFIG_TFABOOT=y
CONFIG_SYS_MEMTEST_END=0x9fffffff
CONFIG_ENV_SIZE=0x2000
CONFIG_ENV_OFFSET=0x500000
-CONFIG_ENV_SECT_SIZE=0x40000
+CONFIG_ENV_SECT_SIZE=0x20000
+CONFIG_SYS_MALLOC_LEN=0x202000
CONFIG_DM_GPIO=y
+CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1028a-qds-duart"
CONFIG_FSPI_AHB_EN_4BYTE=y
CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y
CONFIG_SEC_FIRMWARE_ARMV8_PSCI=y
-CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1028a-qds-duart"
CONFIG_AHCI=y
CONFIG_DISTRO_DEFAULTS=y
CONFIG_FIT_VERBOSE=y
CONFIG_USE_BOOTARGS=y
CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 ramdisk_size=0x2000000 default_hugepagesz=2m hugepagesz=2m hugepages=256 video=1920x1080-32@60 cma=256M"
CONFIG_MISC_INIT_R=y
+CONFIG_ID_EEPROM=y
CONFIG_CMD_GREPENV=y
+CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
CONFIG_CMD_MEMTEST=y
CONFIG_CMD_DM=y
CONFIG_CMD_GPIO=y
CONFIG_SCSI_AHCI=y
CONFIG_SATA_CEVA=y
CONFIG_FSL_CAAM=y
+# CONFIG_DDR_SPD is not set
CONFIG_DM_I2C=y
CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
-CONFIG_I2C_DEFAULT_BUS_NUMBER=0
CONFIG_I2C_MUX=y
CONFIG_I2C_MUX_PCA954x=y
-CONFIG_DM_MMC=y
+CONFIG_SYS_I2C_EEPROM_ADDR=0x57
CONFIG_FSL_ESDHC=y
CONFIG_MTD=y
CONFIG_DM_SPI_FLASH=y
-CONFIG_SPI_FLASH_SPANSION=y
+CONFIG_SPI_FLASH_EON=y
CONFIG_SPI_FLASH_STMICRO=y
+CONFIG_SPI_FLASH_SST=y
# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHYLIB=y
CONFIG_PHY_AQUANTIA=y
CONFIG_PHY_ATHEROS=y
CONFIG_PHY_VITESSE=y
+CONFIG_PHY_FIXED=y
CONFIG_DM_ETH=y
CONFIG_DM_MDIO=y
CONFIG_DM_MDIO_MUX=y
-CONFIG_E1000=y
-CONFIG_FSL_ENETC=y
-CONFIG_MDIO_MUX_I2CREG=y
-CONFIG_PHY_FIXED=y
CONFIG_DM_DSA=y
+CONFIG_E1000=y
CONFIG_MSCC_FELIX_SWITCH=y
+CONFIG_MDIO_MUX_I2CREG=y
CONFIG_NVME=y
CONFIG_PCI=y
-CONFIG_DM_PCI=y
-CONFIG_DM_PCI_COMPAT=y
CONFIG_PCIE_ECAM_GENERIC=y
CONFIG_PCIE_LAYERSCAPE_RC=y
CONFIG_DM_RTC=y
CONFIG_FSL_DSPI=y
CONFIG_NXP_FSPI=y
CONFIG_USB=y
-CONFIG_DM_USB=y
CONFIG_USB_XHCI_HCD=y
CONFIG_USB_XHCI_DWC3=y
CONFIG_WDT=y