image_header_t *hdr;
int rcode = 0;
#if defined(CONFIG_FIT)
- const void *fit_hdr;
+ const void *fit_hdr = NULL;
#endif
show_boot_progress (41);
#if defined(CONFIG_FIT)
case IMAGE_FORMAT_FIT:
fit_hdr = (const void *)addr;
- if (!fit_check_format (fit_hdr)) {
- show_boot_progress (-140);
- puts ("** Bad FIT image format\n");
- return 1;
- }
- show_boot_progress (141);
puts ("Fit image detected...\n");
cnt = fit_get_size (fit_hdr);
#if defined(CONFIG_FIT)
/* This cannot be done earlier, we need complete FIT image in RAM first */
- if (genimg_get_format ((void *)addr) == IMAGE_FORMAT_FIT)
- fit_print_contents ((const void *)addr);
+ if (genimg_get_format ((void *)addr) == IMAGE_FORMAT_FIT) {
+ if (!fit_check_format (fit_hdr)) {
+ show_boot_progress (-140);
+ puts ("** Bad FIT image format\n");
+ return 1;
+ }
+ show_boot_progress (141);
+ fit_print_contents (fit_hdr);
+ }
#endif
/* Loading ok, update default load address */
dev_desc->blksz=ATA_BLOCKSIZE;
dev_desc->lun=0; /* just to fill something in... */
-#if 0 /* only used to test the powersaving mode,
+#if 0 /* only used to test the powersaving mode,
* if enabled, the drive goes after 5 sec
* in standby mode */
ide_outb (device, ATA_DEV_HD, ATA_LBA | ATA_DEVICE(device));
}
output_data_shorts (device, (unsigned short *)ccb,ccblen/2); /* write command block */
- /* ATAPI Command written wait for completition */
+ /* ATAPI Command written wait for completition */
udelay (5000); /* device must set bsy */
mask = ATA_STAT_DRQ|ATA_STAT_BUSY|ATA_STAT_ERR;
* returns, an request_sense will be issued
*/
-#define ATAPI_DRIVE_NOT_READY 100
+#define ATAPI_DRIVE_NOT_READY 100
#define ATAPI_UNIT_ATTN 10
unsigned char atapi_issue_autoreq (int device,