return -EEXIST;
/*
- * Now there will be no overflap, delete the hole and re-add the
+ * Now there will be no overlap, delete the hole and re-add the
* split(s) if they exists.
*/
if (start > hole->start) {
if (errors & REF_ERR_DUP_INODE_REF)
fprintf(stderr, ", dup inode ref");
if (errors & REF_ERR_INDEX_UNMATCH)
- fprintf(stderr, ", index unmatch");
+ fprintf(stderr, ", index mismatch");
if (errors & REF_ERR_FILETYPE_UNMATCH)
- fprintf(stderr, ", filetype unmatch");
+ fprintf(stderr, ", filetype mismatch");
if (errors & REF_ERR_NAME_TOO_LONG)
fprintf(stderr, ", name too long");
if (errors & REF_ERR_NO_ROOT_REF)
type_recovered = 1;
filetype = BTRFS_FT_REG_FILE;
} else{
- printf("Can't determint the filetype for inode %llu, assume it is a normal file\n",
+ printf("Can't determine the filetype for inode %llu, assume it is a normal file\n",
rec->ino);
type_recovered = 1;
filetype = BTRFS_FT_REG_FILE;
/*
* We need to record the highest inode number for later 'lost+found'
* dir creation.
- * We must select a ino not used/refered by any existing inode, or
+ * We must select an ino not used/referred by any existing inode, or
* 'lost+found' ino may be a missing ino in a corrupted leaf,
* this may cause 'lost+found' dir has wrong nlinks.
*/
} else {
/*
* Signal to callers we need to start the scan over
- * again since we'll have cow'ed blocks.
+ * again since we'll have cowed blocks.
*/
ret = -EAGAIN;
}
ret = verify_space_cache(root, cache);
if (ret) {
- fprintf(stderr, "cache appears valid but isnt %Lu\n",
+ fprintf(stderr, "cache appears valid but isn't %Lu\n",
cache->key.objectid);
error++;
}
path = btrfs_alloc_path();
if (!path) {
- fprintf(stderr, "Error allocing path\n");
+ fprintf(stderr, "Error allocating path\n");
return -ENOMEM;
}
/*
* Block group items come before extent items if they have the same
- * bytenr, so walk back one more just in case. Dear future traveler,
+ * bytenr, so walk back one more just in case. Dear future traveller,
* first congrats on mastering time travel. Now if it's not too much
* trouble could you go back to 2006 and tell Chris to make the
* BLOCK_GROUP_ITEM_KEY (and BTRFS_*_REF_KEY) lower than the
* 1) If BTRFS_HEADER_FLAG_RELOC is set then we have FULL_BACKREF set.
* 2) If btrfs_header_owner(buf) no longer points to buf then we have
* FULL_BACKREF set.
- * 3) We cow'ed the block walking down a reloc tree. This is impossible to tell
+ * 3) We cowed the block walking down a reloc tree. This is impossible to tell
* if it happened after the relocation occurred since we'll have dropped the
* reloc root, so it's entirely possible to have FULL_BACKREF set on buf and
* have no real way to know for sure.
if (tmp->start + tmp->nr < good->start + good->nr) {
fprintf(stderr, "Ok we have overlapping extents that "
- "aren't completely covered by eachother, this "
+ "aren't completely covered by each other, this "
"is going to require more careful thought. "
"The extents are [%Lu-%Lu] and [%Lu-%Lu]\n",
tmp->start, tmp->nr, good->start, good->nr);
ret = reset_balance(trans, fs_info);
if (ret)
- fprintf(stderr, "error reseting the pending balance\n");
+ fprintf(stderr, "error resetting the pending balance\n");
return ret;
}
const char * const cmd_check_usage[] = {
"btrfs check [options] <device>",
- "Check structural inegrity of a filesystem (unmounted).",
- "Check structural inegrity of an unmounted filesystem. Verify internal",
+ "Check structural integrity of a filesystem (unmounted).",
+ "Check structural integrity of an unmounted filesystem. Verify internal",
"trees' consistency and item connectivity. In the repair mode try to",
"fix the problems found.",
"WARNING: the repair mode is considered dangerous",
"--readonly run in read-only mode (default)",
"--init-csum-tree create a new CRC tree",
"--init-extent-tree create a new extent tree",
- "--check-data-csum verify checkums of data blocks",
+ "--check-data-csum verify checksums of data blocks",
"-Q|--qgroup-report print a report on qgroup consistency",
"-E|--subvol-extents <subvolid>",
" print subvolume extents and sharing state",