help
Print GPL license text
+config CMD_REGINFO
+ bool "reginfo"
+ depends on PPC
+ help
+ Register dump
+
endmenu
menu "Boot commands"
help
Poweroff/Shutdown the system
+config CMD_SPL
+ bool "spl export - Export boot information for Falcon boot"
+ depends on SPL
+ help
+ Falcon mode allows booting directly from SPL into an Operating
+ System such as Linux, thus skipping U-Boot proper. See
+ doc/README.falcon for full information about how to use this
+ command.
+
endmenu
menu "Environment commands"
about 1990. These devices are typically removable memory or network
cards using a standard 68-pin connector.
+config CMD_READ
+ bool "read - Read binary data from a partition"
+ help
+ Provides low-level access to the data in a partition.
+
config CMD_REMOTEPROC
bool "remoteproc"
depends on REMOTEPROC
Attachment, where AT refers to an IBM AT (Advanced Technology)
computer released in 1984.
+config CMD_SAVES
+ bool "saves - Save a file over serial in S-Record format"
+ help
+ Provides a way to save a binary file using the Motorola S-Record
+ format over the serial line.
+
+config CMD_SDRAM
+ bool "sdram - Print SDRAM configuration information"
+ help
+ Provides information about attached SDRAM. This assumed that the
+ SDRAM has an EEPROM with information that can be read using the
+ I2C bus. This is only available on some boards.
+
config CMD_SF
bool "sf"
help
SPI Flash support
+config CMD_SF_TEST
+ bool "sf test - Allow testing of SPI flash"
+ help
+ Provides a way to test that SPI flash is working correctly. The
+ test is destructive, in that an area of SPI flash must be provided
+ for the test to use. Performance information is also provided,
+ measuring the performance of reading, writing and erasing in
+ Mbps (Million Bits Per Second). This value should approximately
+ equal the SPI bus speed for a single-bit-wide SPI bus, assuming
+ everything is working properly.
+
config CMD_SPI
bool "sspi"
help
at least as large as the size specified in the mtdparts variable and
2) each partition starts on a good block.
+config CMD_REISER
+ bool "reiser - Access to reiserfs filesystems"
+ help
+ This provides two commands which operate on a resierfs filesystem,
+ commonly used some years ago:
+
+ reiserls - list files
+ reiserload - load a file
+
+config CMD_SCSI
+ bool "scsi - Access to SCSI devices"
+ default y if SCSI
+ help
+ This provides a 'scsi' command which provides access to SCSI (Small
+ Computer System Interface) devices. The command provides a way to
+ scan the bus, reset the bus, read and write data and get information
+ about devices.
+
endmenu
menu "Debug commands"