Extract a part of a multi-image.
config CMD_POWEROFF
- bool
+ bool "poweroff"
+ help
+ Poweroff/Shutdown the system
endmenu
help
Compute CRC32.
+config CRC32_VERIFY
+ bool "crc32 -v"
+ depends on CMD_CRC32
+ help
+ Add -v option to verify data against a crc32 checksum.
+
config CMD_EEPROM
bool "eeprom - EEPROM subsystem"
help
help
Compute MD5 checksum.
-config MD5SUM_VERFIY
+config MD5SUM_VERIFY
bool "md5sum -v"
default n
depends on CMD_MD5SUM
help
Add -v option to verify data against an MD5 checksum.
+config CMD_SHA1SUM
+ bool "sha1sum"
+ select SHA1
+ help
+ Compute SHA1 checksum.
+
+config SHA1SUM_VERIFY
+ bool "sha1sum -v"
+ depends on CMD_SHA1SUM
+ help
+ Add -v option to verify data against a SHA1 checksum.
+
config LOOPW
bool "loopw"
help
help
Display memory information.
+endmenu
+
+menu "Compression commands"
+
+config CMD_LZMADEC
+ bool "lzmadec"
+ select LZMA
+ help
+ Support decompressing an LZMA (Lempel-Ziv-Markov chain algorithm)
+ image from memory.
+
config CMD_UNZIP
bool "unzip"
help
saved to memory or to an environment variable. It is also possible
to verify a hash against data in memory.
+config HASH_VERIFY
+ bool "hash -v"
+ depends on CMD_HASH
+ help
+ Add -v option to verify data against a hash.
+
config CMD_TPM
bool "Enable the 'tpm' command"
depends on TPM
config CMD_FAT
bool "FAT command support"
+ select FS_FAT
help
Support for the FAT fs
help
Enables fsuuid command for filesystem UUID.
+config CMD_JFFS2
+ bool "jffs2 command"
+ select FS_JFFS2
+ help
+ Enables commands to support the JFFS2 (Journalling Flash File System
+ version 2) filesystem. This enables fsload, ls and fsinfo which
+ provide the ability to load files, list directories and obtain
+ filesystem information.
+
config CMD_MTDPARTS
depends on ARCH_SUNXI
bool "MTD partition support"
available tests and running either all the tests, or specific tests
identified by name.
+config CMD_IRQ
+ bool "irq - Show information about interrupts"
+ depends on !ARM && !MIPS && !SH
+ help
+ This enables two commands:
+
+ interrupts - enable or disable interrupts
+ irqinfo - print device-specific interrupt information
+
+config CMD_KGDB
+ bool "kgdb - Allow debugging of U-Boot with gdb"
+ help
+ This enables a 'kgdb' command which allows gdb to connect to U-Boot
+ over a serial link for debugging purposes. This allows
+ single-stepping, inspecting variables, etc. This is supported only
+ on PowerPC at present.
+
endmenu
config CMD_UBI