POST cleanup.

[platform/kernel/u-boot.git] / board / tqc / tqm5200 / tqm5200.c

diff --git a/board/tqc/tqm5200/tqm5200.c b/board/tqc/tqm5200/tqm5200.c
index faa2e02..263a2af 100644 (file)
--- a/board/tqc/tqm5200/tqm5200.c
+++ b/board/tqc/tqm5200/tqm5200.c
@@ -358,11 +358,9 @@ int post_hotkeys_pressed(void)
        gpio = (struct mpc5xxx_gpio*) MPC5XXX_GPIO;
 
        /*
-        * Configure PSC6_1 and PSC6_3 as GPIO. PSC6 then couldn't be used in
-        * CODEC or UART mode. Consumer IrDA should still be possible.
+        * Configure PSC6_0 through PSC6_3 as GPIO.
         */
-       gpio->port_config &= ~(0x07000000);
-       gpio->port_config |=   0x03000000;
+       gpio->port_config &= ~(0x00700000);
 
        /* Enable GPIO for GPIO_IRDA_1 (IR_USB_CLK pin) = PSC6_3 */
        gpio->simple_gpioe |= 0x20000000;
@@ -377,25 +375,6 @@ int post_hotkeys_pressed(void)
 }
 #endif
 
-#if defined(CONFIG_POST) || defined(CONFIG_LOGBUFFER)
-
-void post_word_store (ulong a)
-{
-       volatile ulong *save_addr =
-               (volatile ulong *)(MPC5XXX_SRAM + MPC5XXX_SRAM_POST_SIZE);
-
-       *save_addr = a;
-}
-
-ulong post_word_load (void)
-{
-       volatile ulong *save_addr =
-               (volatile ulong *)(MPC5XXX_SRAM + MPC5XXX_SRAM_POST_SIZE);
-
-       return *save_addr;
-}
-#endif /* CONFIG_POST || CONFIG_LOGBUFFER*/
-
 #ifdef CONFIG_BOARD_EARLY_INIT_R
 int board_early_init_r (void)
 {
@@ -747,7 +726,6 @@ int board_get_height (void)
 void ft_board_setup(void *blob, bd_t *bd)
 {
        ft_cpu_setup(blob, bd);
-       fdt_fixup_memory(blob, (u64)bd->bi_memstart, (u64)bd->bi_memsize);
 }
 #endif /* defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP) */