ARM: keystone2: Rename u-boot-nand.gph to MLO

[platform/kernel/u-boot.git] / board / ti / ks2_evm / README

diff --git a/board/ti/ks2_evm/README b/board/ti/ks2_evm/README
index 6586fab..b824725 100644 (file)
--- a/board/ti/ks2_evm/README
+++ b/board/ti/ks2_evm/README
@@ -61,7 +61,7 @@ Supported image formats:
  - u-boot.bin: for loading and running u-boot.bin through Texas instruments
                code composure studio (CCS)
  - u-boot-spi.gph: gpimage for programming SPI NOR flash for SPI NOR boot
- - u-boot-nand.gph: gpimage for programming AEMIF NAND flash for NAND boot
+ - MLO: gpimage for programming AEMIF NAND flash for NAND boot
 
 Build instructions:
 ===================
@@ -76,9 +76,9 @@ To build u-boot-spi.gph
   >make k2hk_evm_defconfig
   >make u-boot-spi.gph
 
-To build u-boot-nand.gph
+To build MLO
   >make k2hk_evm_defconfig
-  >make u-boot-nand.gph
+  >make MLO
 
 Load and Run U-Boot on keystone EVMs using CCS
 =========================================
@@ -157,12 +157,12 @@ instructions:
 1. Start CCS and run U-boot as described above.
 2. Suspend Target. Select Run -> Suspend from top level menu
    CortexA15_1 (Free Running)"
-3. Load u-boot-nand.gph binary from build folder on to DDR address 0x87000000
+3. Load MLO binary from build folder on to DDR address 0x87000000
    through CCS as described in step 2 of "Load and Run U-Boot on K2HK EVM
    using CCS", but using address 0x87000000.
 4. Free Run the target as described earlier (step 4) to get u-boot prompt
 5. At the U-Boot console type following to setup u-boot environment variables.
-   setenv filesize <size in hex of u-boot-nand.gph rounded to hex 0x10000>
+   setenv filesize <size in hex of MLO rounded to hex 0x10000>
    run burn_uboot_nand
    Once u-boot prompt is available, Power OFF the EVM. Set the SW1 dip switch
    to "ARM NAND Boot mode" as per instruction at