void hcu_led_set(u32 value);
void dcbz_area(u32 start_address, u32 num_bytes);
-#define DDR_DCR_BASE 0x10
-#define ddrcfga (DDR_DCR_BASE+0x0) /* DDR configuration address reg */
-#define ddrcfgd (DDR_DCR_BASE+0x1) /* DDR configuration data reg */
-
-#define DDR0_01_INT_MASK_MASK 0x000000FF
-#define DDR0_00_INT_ACK_ALL 0x7F000000
-#define DDR0_01_INT_MASK_ALL_ON 0x000000FF
-#define DDR0_01_INT_MASK_ALL_OFF 0x00000000
-
-#define DDR0_17_DLLLOCKREG_MASK 0x00010000 /* Read only */
-#define DDR0_17_DLLLOCKREG_UNLOCKED 0x00000000
-#define DDR0_17_DLLLOCKREG_LOCKED 0x00010000
-
-#define DDR0_22 0x16
-/* ECC */
-#define DDR0_22_CTRL_RAW_MASK 0x03000000
-#define DDR0_22_CTRL_RAW_ECC_DISABLE 0x00000000 /* ECC not enabled */
-#define DDR0_22_CTRL_RAW_ECC_CHECK_ONLY 0x01000000 /* ECC no correction */
-#define DDR0_22_CTRL_RAW_NO_ECC_RAM 0x02000000 /* Not a ECC RAM*/
-#define DDR0_22_CTRL_RAW_ECC_ENABLE 0x03000000 /* ECC correcting on */
-#define DDR0_03_CASLAT_DECODE(n) ((((unsigned long)(n))>>16)&0x7)
-
#define ECC_RAM 0x03267F0B
#define NO_ECC_RAM 0x00267F0B
/* -----------------------------------------------------------+
* Wait for the DCC master delay line to finish calibration
* ----------------------------------------------------------*/
- mtdcr(ddrcfga, DDR0_17);
+ mtdcr(memcfga, DDR0_17);
val = DDR0_17_DLLLOCKREG_UNLOCKED;
while (wait != 0xffff) {
- val = mfdcr(ddrcfgd);
+ val = mfdcr(memcfgd);
if ((val & DDR0_17_DLLLOCKREG_MASK) ==
DDR0_17_DLLLOCKREG_LOCKED)
/* dlllockreg bit on */