unsigned char sz; /* log binary => Size = (4MByte<<sz) 5 = 128, 4 = 64, 3 = 32, 2 = 16, 1=8 */
unsigned char ecc; /* if true, ecc is enabled */
} sdram_t;
-#if defined(CONFIG_MIP405T)
+#if defined(CONFIG_TARGET_MIP405T)
const sdram_t sdram_table[] = {
{ 0x0F, /* MIP405T Rev A, 64MByte -1 Board */
3, /* Case Latenty = 3 */
0xff,
0xff }
};
-#endif /*CONFIG_MIP405T */
+#endif /*CONFIG_TARGET_MIP405T */
void SDRAM_err (const char *s)
{
#ifndef SDRAM_DEBUG
#endif
/* check board */
bc = in8 (PLD_PART_REG);
-#if defined(CONFIG_MIP405T)
+#if defined(CONFIG_TARGET_MIP405T)
if((bc & 0x80)==0)
SDRAM_err ("U-Boot configured for a MIP405T not for a MIP405!!!\n");
#else
void get_pcbrev_var(unsigned char *pcbrev, unsigned char *var)
{
-#if !defined(CONFIG_MIP405T)
+#if !defined(CONFIG_TARGET_MIP405T)
unsigned char bc,rc,tmp;
int i;
* Check Board Identity:
*/
/* serial String: "MIP405_1000" OR "MIP405T_1000" */
-#if !defined(CONFIG_MIP405T)
+#if !defined(CONFIG_TARGET_MIP405T)
#define BOARD_NAME "MIP405"
#else
#define BOARD_NAME "MIP405T"
(cfg >> 1) & 0x1, (cfg >> 2) & 0x1, (cfg >> 3) & 0x1);
printf ("User LED %s\n", (com_mode & 0x4) ? "on" : "off");
printf ("UART Clocks %d\n", (com_mode >> 4) & 0x3);
-#if !defined(CONFIG_MIP405T)
+#if !defined(CONFIG_TARGET_MIP405T)
printf ("User Config Switch %d %d %d %d %d %d %d %d\n",
(ext) & 0x1, (ext >> 1) & 0x1, (ext >> 2) & 0x1,
(ext >> 3) & 0x1, (ext >> 4) & 0x1, (ext >> 5) & 0x1,
printf ("IDE Reset %s\n", (ext & 0x01) ? "asserted" : "not asserted");
printf ("IRQs:\n");
printf (" PIIX INTR: %s\n", (irq_reg & 0x80) ? "inactive" : "active");
-#if !defined(CONFIG_MIP405T)
+#if !defined(CONFIG_TARGET_MIP405T)
printf (" UART0 IRQ: %s\n", (irq_reg & 0x40) ? "inactive" : "active");
printf (" UART1 IRQ: %s\n", (irq_reg & 0x20) ? "inactive" : "active");
#endif