*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
- * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
gd->flags = 0;
+#ifdef CONFIG_CM_REMAP
+extern void cm_remap(void);
+ cm_remap(); /* remaps writeable memory to 0x00000000 */
+#endif
+
icache_enable ();
flash__init ();
/* V3 access routines */
#define _V3Write16(o,v) (*(volatile unsigned short *)(PCI_V3_BASE + (unsigned int)(o)) = (unsigned short)(v))
-#define _V3Read16(o) (*(volatile unsigned short *)(PCI_V3_BASE + (unsigned int)(o)))
+#define _V3Read16(o) (*(volatile unsigned short *)(PCI_V3_BASE + (unsigned int)(o)))
#define _V3Write32(o,v) (*(volatile unsigned int *)(PCI_V3_BASE + (unsigned int)(o)) = (unsigned int)(v))
-#define _V3Read32(o) (*(volatile unsigned int *)(PCI_V3_BASE + (unsigned int)(o)))
+#define _V3Read32(o) (*(volatile unsigned int *)(PCI_V3_BASE + (unsigned int)(o)))
/* Compute address necessary to access PCI config space for the given */
/* bus and device. */
#define PCI_CONFIG_ADDRESS( __bus, __devfn, __offset ) ({ \
unsigned int __address, __devicebit; \
unsigned short __mapaddress; \
- unsigned int __dev = PCI_DEV (__devfn); /* FIXME to check!! (slot?) */ \
+ unsigned int __dev = PCI_DEV (__devfn); /* FIXME to check!! (slot?) */ \
\
if (__bus == 0) { \
/* local bus segment so need a type 0 config cycle */ \
/* A31-A24 are don't care (so clear to 0) */ \
__mapaddress = 0x000B; /* 101=>config cycle, 1=>A1&A0 from PCI_CFG */ \
__address = PCI_CONFIG_BASE; \
- __address |= ((__bus & 0xFF) << 16); /* bits 23..16 = bus number */ \
- __address |= ((__dev & 0x1F) << 11); /* bits 15..11 = device number */ \
+ __address |= ((__bus & 0xFF) << 16); /* bits 23..16 = bus number */ \
+ __address |= ((__dev & 0x1F) << 11); /* bits 15..11 = device number */ \
__address |= ((__devfn & 0x07) << 8); /* bits 10..8 = function number */ \
- __address |= __offset & 0xFF; /* bits 7..0 = register number */ \
+ __address |= __offset & 0xFF; /* bits 7..0 = register number */ \
} \
_V3Write16 (V3_LB_MAP1, __mapaddress); \
__address; \
/*************************************************************
Routine:ether__init
Description: take the Ethernet controller out of reset and wait
- for the EEPROM load to complete.
+ for the EEPROM load to complete.
*************************************************************/
void ether__init (void)
{
******************************/
int dram_init (void)
{
+ DECLARE_GLOBAL_DATA_PTR;
+
+ gd->bd->bi_dram[0].start = PHYS_SDRAM_1;
+ gd->bd->bi_dram[0].size = PHYS_SDRAM_1_SIZE;
+
+#ifdef CONFIG_CM_SPD_DETECT
+ {
+extern void dram_query(void);
+ unsigned long cm_reg_sdram;
+ unsigned long sdram_shift;
+
+ dram_query(); /* Assembler accesses to CM registers */
+ /* Queries the SPD values */
+
+ /* Obtain the SDRAM size from the CM SDRAM register */
+
+ cm_reg_sdram = *(volatile ulong *)(CM_BASE + OS_SDRAM);
+ /* Register SDRAM size
+ *
+ * 0xXXXXXXbbb000bb 16 MB
+ * 0xXXXXXXbbb001bb 32 MB
+ * 0xXXXXXXbbb010bb 64 MB
+ * 0xXXXXXXbbb011bb 128 MB
+ * 0xXXXXXXbbb100bb 256 MB
+ *
+ */
+ sdram_shift = ((cm_reg_sdram & 0x0000001C)/4)%4;
+ gd->bd->bi_dram[0].size = 0x01000000 << sdram_shift;
+
+ }
+#endif /* CM_SPD_DETECT */
+
return 0;
}
+
+/* The Integrator/AP timer1 is clocked at 24MHz
+ * can be divided by 16 or 256
+ * and is a 16-bit counter
+ */
+/* U-Boot expects a 32 bit timer running at CFG_HZ*/
+static ulong timestamp; /* U-Boot ticks since startup */
+static ulong total_count = 0; /* Total timer count */
+static ulong lastdec; /* Timer reading at last call */
+static ulong div_clock = 256; /* Divisor applied to the timer clock */
+static ulong div_timer = 1; /* Divisor to convert timer reading
+ * change to U-Boot ticks
+ */
+/* CFG_HZ = CFG_HZ_CLOCK/(div_clock * div_timer) */
+
+#define TIMER_LOAD_VAL 0x0000FFFFL
+#define READ_TIMER ((*(volatile ulong *)(CFG_TIMERBASE+4)) & 0x0000FFFFL)
+
+/* all function return values in U-Boot ticks i.e. (1/CFG_HZ) sec
+ * - unless otherwise stated
+ */
+
+/* starts a counter
+ * - the Integrator/AP timer issues an interrupt
+ * each time it reaches zero
+ */
+int interrupt_init (void)
+{
+ /* Load timer with initial value */
+ *(volatile ulong *)(CFG_TIMERBASE + 0) = TIMER_LOAD_VAL;
+ /* Set timer to be
+ * enabled 1
+ * free-running 0
+ * XX 00
+ * divider 256 10
+ * XX 00
+ */
+ *(volatile ulong *)(CFG_TIMERBASE + 8) = 0x00000088;
+ total_count = 0;
+ /* init the timestamp and lastdec value */
+ reset_timer_masked();
+
+ div_timer = CFG_HZ_CLOCK / CFG_HZ;
+ div_timer /= div_clock;
+
+ return (0);
+}
+
+/*
+ * timer without interrupts
+ */
+void reset_timer (void)
+{
+ reset_timer_masked ();
+}
+
+ulong get_timer (ulong base_ticks)
+{
+ return get_timer_masked () - base_ticks;
+}
+
+void set_timer (ulong ticks)
+{
+ timestamp = ticks;
+ total_count = ticks * div_timer;
+ reset_timer_masked();
+}
+
+/* delay x useconds */
+void udelay (unsigned long usec)
+{
+ ulong tmo, tmp;
+
+ /* Convert to U-Boot ticks */
+ tmo = usec * CFG_HZ;
+ tmo /= (1000000L);
+
+ tmp = get_timer_masked(); /* get current timestamp */
+ tmo += tmp; /* wake up timestamp */
+
+ while (get_timer_masked () < tmo) { /* loop till event */
+ /*NOP*/;
+ }
+}
+
+void reset_timer_masked (void)
+{
+ /* reset time */
+ lastdec = READ_TIMER; /* capture current decrementer value */
+ timestamp = 0; /* start "advancing" time stamp from 0 */
+}
+
+/* converts the timer reading to U-Boot ticks */
+/* the timestamp is the number of ticks since reset */
+/* This routine does not detect wraps unless called regularly
+ ASSUMES a call at least every 16 seconds to detect every reload */
+ulong get_timer_masked (void)
+{
+ ulong now = READ_TIMER; /* current count */
+
+ if (now > lastdec) {
+ /* Must have wrapped */
+ total_count += lastdec + TIMER_LOAD_VAL + 1 - now;
+ } else {
+ total_count += lastdec - now;
+ }
+ lastdec = now;
+ timestamp = total_count/div_timer;
+
+ return timestamp;
+}
+
+/* waits specified delay value and resets timestamp */
+void udelay_masked (unsigned long usec)
+{
+ udelay(usec);
+}
+
+/*
+ * This function is derived from PowerPC code (read timebase as long long).
+ * On ARM it just returns the timer value.
+ */
+unsigned long long get_ticks(void)
+{
+ return get_timer(0);
+}
+
+/*
+ * Return the timebase clock frequency
+ * i.e. how often the timer decrements
+ */
+ulong get_tbclk (void)
+{
+ return CFG_HZ_CLOCK/div_clock;
+}