+// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright 2014 Freescale Semiconductor, Inc.
- *
- * SPDX-License-Identifier: GPL-2.0+
+ * Copyright 2019, 2021 NXP
*/
#include <common.h>
+#include <clock_legacy.h>
+#include <fdt_support.h>
#include <i2c.h>
+#include <init.h>
+#include <log.h>
#include <asm/io.h>
#include <asm/arch/immap_ls102xa.h>
#include <asm/arch/clock.h>
#include <asm/arch/fsl_serdes.h>
-#include <asm/arch/ls102xa_stream_id.h>
#include <asm/arch/ls102xa_soc.h>
#include <asm/arch/ls102xa_devdis.h>
-#include <asm/arch/ls102xa_sata.h>
#include <hwconfig.h>
#include <mmc.h>
#include <fsl_csu.h>
-#include <fsl_esdhc.h>
#include <fsl_ifc.h>
-#include <fsl_sec.h>
#include <spl.h>
#include <fsl_devdis.h>
#include <fsl_validate.h>
-
+#include <fsl_ddr.h>
+#include "../common/i2c_mux.h"
#include "../common/sleep.h"
#include "../common/qixis.h"
#include "ls1021aqds_qixis.h"
#ifdef CONFIG_U_QE
-#include "../../../drivers/qe/qe.h"
+#include <fsl_qe.h>
#endif
#define PIN_MUX_SEL_CAN 0x03
#define SET_SDHC_MUX_SEL(reg, value) ((reg & 0x0f) | value)
#define SET_EC_MUX_SEL(reg, value) ((reg & 0xf0) | value)
-DECLARE_GLOBAL_DATA_PTR;
-
enum {
MUX_TYPE_CAN,
MUX_TYPE_IIC2,
int checkboard(void)
{
-#ifndef CONFIG_QSPI_BOOT
+#if !defined(CONFIG_QSPI_BOOT) && !defined(CONFIG_SD_BOOT_QSPI)
char buf[64];
#endif
#if !defined(CONFIG_SD_BOOT) && !defined(CONFIG_QSPI_BOOT)
printf("invalid setting of SW%u\n", QIXIS_LBMAP_SWITCH);
#endif
-#ifndef CONFIG_QSPI_BOOT
+#if !defined(CONFIG_QSPI_BOOT) && !defined(CONFIG_SD_BOOT_QSPI)
printf("Sys ID:0x%02x, Sys Ver: 0x%02x\n",
QIXIS_READ(id), QIXIS_READ(arch));
return 0;
}
+#ifdef CONFIG_DYNAMIC_SYS_CLK_FREQ
unsigned long get_board_sys_clk(void)
{
u8 sysclk_conf = QIXIS_READ(brdcfg[1]);
}
return 66666666;
}
+#endif
+#ifdef CONFIG_DYNAMIC_DDR_CLK_FREQ
unsigned long get_board_ddr_clk(void)
{
u8 ddrclk_conf = QIXIS_READ(brdcfg[1]);
}
return 66666666;
}
-
-int select_i2c_ch_pca9547(u8 ch)
-{
- int ret;
-
- ret = i2c_write(I2C_MUX_PCA_ADDR_PRI, 0, 1, &ch, 1);
- if (ret) {
- puts("PCA: failed to select proper channel\n");
- return ret;
- }
-
- return 0;
-}
+#endif
int dram_init(void)
{
* When resuming from deep sleep, the I2C channel may not be
* in the default channel. So, switch to the default channel
* before accessing DDR SPD.
+ *
+ * PCA9547(0x77) mount on I2C1 bus
*/
- select_i2c_ch_pca9547(I2C_MUX_CH_DEFAULT);
- gd->ram_size = initdram(0);
-
- return 0;
-}
-
-#ifdef CONFIG_FSL_ESDHC
-struct fsl_esdhc_cfg esdhc_cfg[1] = {
- {CONFIG_SYS_FSL_ESDHC_ADDR},
-};
-
-int board_mmc_init(bd_t *bis)
-{
- esdhc_cfg[0].sdhc_clk = mxc_get_clock(MXC_ESDHC_CLK);
-
- return fsl_esdhc_initialize(bis, &esdhc_cfg[0]);
+ select_i2c_ch_pca9547(I2C_MUX_CH_DEFAULT, 0);
+ return fsl_initdram();
}
-#endif
int board_early_init_f(void)
{
- struct ccsr_scfg *scfg = (struct ccsr_scfg *)CONFIG_SYS_FSL_SCFG_ADDR;
+ struct ccsr_scfg *scfg = (struct ccsr_scfg *)CFG_SYS_FSL_SCFG_ADDR;
#ifdef CONFIG_TSEC_ENET
/* clear BD & FR bits for BE BD's and frame data */
#ifdef CONFIG_SPL_BUILD
void board_init_f(ulong dummy)
{
- struct ccsr_cci400 *cci = (struct ccsr_cci400 *)CONFIG_SYS_CCI400_ADDR;
- unsigned int major;
-
#ifdef CONFIG_NAND_BOOT
- struct ccsr_gur __iomem *gur = (void *)CONFIG_SYS_FSL_GUTS_ADDR;
+ struct ccsr_gur __iomem *gur = (void *)CFG_SYS_FSL_GUTS_ADDR;
u32 porsr1, pinctl;
/*
preloader_console_init();
-#ifdef CONFIG_SPL_I2C_SUPPORT
+#ifdef CONFIG_SPL_I2C
i2c_init_all();
#endif
- major = get_soc_major_rev();
- if (major == SOC_MAJOR_VER_1_0)
- out_le32(&cci->ctrl_ord, CCI400_CTRLORD_TERM_BARRIER);
-
+ timer_init();
dram_init();
/* Allow OCRAM access permission as R/W */
void config_etseccm_source(int etsec_gtx_125_mux)
{
- struct ccsr_scfg *scfg = (struct ccsr_scfg *)CONFIG_SYS_FSL_SCFG_ADDR;
+ struct ccsr_scfg *scfg = (struct ccsr_scfg *)CFG_SYS_FSL_SCFG_ADDR;
switch (etsec_gtx_125_mux) {
case GE0_CLK125:
int config_serdes_mux(void)
{
- struct ccsr_gur *gur = (struct ccsr_gur *)CONFIG_SYS_FSL_GUTS_ADDR;
+ struct ccsr_gur *gur = (struct ccsr_gur *)CFG_SYS_FSL_GUTS_ADDR;
u32 cfg;
cfg = in_be32(&gur->rcwsr[4]) & RCWSR4_SRDS1_PRTCL_MASK;
#ifdef CONFIG_BOARD_LATE_INIT
int board_late_init(void)
{
-#ifdef CONFIG_SCSI_AHCI_PLAT
- ls1021a_sata_init();
-#endif
#ifdef CONFIG_CHAIN_OF_TRUST
fsl_setenv_chain_of_trust();
#endif
#ifdef CONFIG_FSL_DEVICE_DISABLE
device_disable(devdis_tbl, ARRAY_SIZE(devdis_tbl));
#endif
-#ifdef CONFIG_FSL_CAAM
- return sec_init();
-#endif
return 0;
}
-struct liodn_id_table sec_liodn_tbl[] = {
- SET_SEC_JR_LIODN_ENTRY(0, 0x10, 0x10),
- SET_SEC_JR_LIODN_ENTRY(1, 0x10, 0x10),
- SET_SEC_JR_LIODN_ENTRY(2, 0x10, 0x10),
- SET_SEC_JR_LIODN_ENTRY(3, 0x10, 0x10),
- SET_SEC_RTIC_LIODN_ENTRY(a, 0x10),
- SET_SEC_RTIC_LIODN_ENTRY(b, 0x10),
- SET_SEC_RTIC_LIODN_ENTRY(c, 0x10),
- SET_SEC_RTIC_LIODN_ENTRY(d, 0x10),
- SET_SEC_DECO_LIODN_ENTRY(0, 0x10, 0x10),
- SET_SEC_DECO_LIODN_ENTRY(1, 0x10, 0x10),
- SET_SEC_DECO_LIODN_ENTRY(2, 0x10, 0x10),
- SET_SEC_DECO_LIODN_ENTRY(3, 0x10, 0x10),
- SET_SEC_DECO_LIODN_ENTRY(4, 0x10, 0x10),
- SET_SEC_DECO_LIODN_ENTRY(5, 0x10, 0x10),
- SET_SEC_DECO_LIODN_ENTRY(6, 0x10, 0x10),
- SET_SEC_DECO_LIODN_ENTRY(7, 0x10, 0x10),
-};
-
-struct smmu_stream_id dev_stream_id[] = {
- { 0x100, 0x01, "ETSEC MAC1" },
- { 0x104, 0x02, "ETSEC MAC2" },
- { 0x108, 0x03, "ETSEC MAC3" },
- { 0x10c, 0x04, "PEX1" },
- { 0x110, 0x05, "PEX2" },
- { 0x114, 0x06, "qDMA" },
- { 0x118, 0x07, "SATA" },
- { 0x11c, 0x08, "USB3" },
- { 0x120, 0x09, "QE" },
- { 0x124, 0x0a, "eSDHC" },
- { 0x128, 0x0b, "eMA" },
- { 0x14c, 0x0c, "2D-ACE" },
- { 0x150, 0x0d, "USB2" },
- { 0x18c, 0x0e, "DEBUG" },
-};
-
int board_init(void)
{
- struct ccsr_cci400 *cci = (struct ccsr_cci400 *)CONFIG_SYS_CCI400_ADDR;
- unsigned int major;
-
- major = get_soc_major_rev();
- if (major == SOC_MAJOR_VER_1_0) {
- /* Set CCI-400 control override register to
- * enable barrier transaction */
- out_le32(&cci->ctrl_ord, CCI400_CTRLORD_EN_BARRIER);
- }
+#ifdef CONFIG_SYS_FSL_ERRATUM_A010315
+ erratum_a010315();
+#endif
+#ifdef CONFIG_SYS_FSL_ERRATUM_A009942
+ erratum_a009942_check_cpo();
+#endif
- select_i2c_ch_pca9547(I2C_MUX_CH_DEFAULT);
+ select_i2c_ch_pca9547(I2C_MUX_CH_DEFAULT, 0);
#ifndef CONFIG_SYS_FSL_NO_SERDES
fsl_serdes_init();
config_serdes_mux();
#endif
- ls1021x_config_caam_stream_id(sec_liodn_tbl,
- ARRAY_SIZE(sec_liodn_tbl));
- ls102xa_config_smmu_stream_id(dev_stream_id,
- ARRAY_SIZE(dev_stream_id));
-
-#ifdef CONFIG_LAYERSCAPE_NS_ACCESS
- enable_layerscape_ns_access();
-#endif
+ ls102xa_smmu_stream_id_init();
#ifdef CONFIG_U_QE
u_qe_init();
#if defined(CONFIG_DEEP_SLEEP)
void board_sleep_prepare(void)
{
- struct ccsr_cci400 __iomem *cci = (void *)CONFIG_SYS_CCI400_ADDR;
- unsigned int major;
-
- major = get_soc_major_rev();
- if (major == SOC_MAJOR_VER_1_0) {
- /* Set CCI-400 control override register to
- * enable barrier transaction */
- out_le32(&cci->ctrl_ord, CCI400_CTRLORD_EN_BARRIER);
- }
-
-
#ifdef CONFIG_LAYERSCAPE_NS_ACCESS
enable_layerscape_ns_access();
#endif
}
#endif
-int ft_board_setup(void *blob, bd_t *bd)
+int ft_board_setup(void *blob, struct bd_info *bd)
{
ft_cpu_setup(blob, bd);