+// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright 2015-2016 Freescale Semiconductor, Inc.
* Copyright 2017 NXP
- *
- * SPDX-License-Identifier:GPL-2.0+
*/
#include <common.h>
#include <dm.h>
+#include <net.h>
#include <asm/io.h>
#include <netdev.h>
#include <fm_eth.h>
#include <asm/arch-fsl-layerscape/config.h>
#include <asm/arch-fsl-layerscape/immap_lsch2.h>
#include <asm/arch/fsl_serdes.h>
+#include <linux/delay.h>
#include <net/pfe_eth/pfe_eth.h>
#include <dm/platform_data/pfe_dm_eth.h>
#include <i2c.h>
{
#ifdef CONFIG_TARGET_LS1012ARDB
/* Through reset IO expander reset both RGMII and SGMII PHYs */
+#ifdef CONFIG_DM_I2C
+ struct udevice *dev;
+ int ret;
+
+ /*
+ * The I2C IO-expander PCAL9555A is mouted on I2C1 bus(bus number is 0).
+ */
+ ret = i2c_get_chip_for_busnum(0, I2C_MUX_IO2_ADDR,
+ 1, &dev);
+ if (ret) {
+ printf("%s: Cannot find udev for a bus %d\n", __func__,
+ 0);
+ return;
+ }
+ /* Config port 0
+ * - config pin IOXP_RST_ETH1_B and IOXP_RST_ETH2_B
+ * are enabled as an output.
+ */
+ dm_i2c_reg_write(dev, 6, __PHY_MASK);
+
+ /*
+ * Set port 0 output a value to reset ETH2 interface
+ * - pin IOXP_RST_ETH2_B output 0b0
+ */
+ dm_i2c_reg_write(dev, 2, __PHY_ETH2_MASK);
+ mdelay(10);
+ dm_i2c_reg_write(dev, 2, __PHY_ETH1_MASK);
+ /*
+ * Set port 0 output a value to reset ETH1 interface
+ * - pin IOXP_RST_ETH1_B output 0b0
+ */
+ mdelay(10);
+ dm_i2c_reg_write(dev, 2, 0xFF);
+#else
i2c_reg_write(I2C_MUX_IO2_ADDR, 6, __PHY_MASK);
i2c_reg_write(I2C_MUX_IO2_ADDR, 2, __PHY_ETH2_MASK);
mdelay(10);
i2c_reg_write(I2C_MUX_IO2_ADDR, 2, __PHY_ETH1_MASK);
mdelay(10);
i2c_reg_write(I2C_MUX_IO2_ADDR, 2, 0xFF);
+#endif
mdelay(50);
#endif
}
/* MAC2 */
pfe_set_phy_address_mode(priv->gemac_port,
CONFIG_PFE_EMAC2_PHY_ADDR,
- PHY_INTERFACE_MODE_RGMII_TXID);
+ PHY_INTERFACE_MODE_RGMII_ID);
}
break;
case 0x2208: