#include <common.h>
#include <cpu_func.h>
+#include <init.h>
+#include <log.h>
#include <mmc.h>
#include <i2c.h>
#include <serial.h>
#include <spl.h>
+#include <asm/cache.h>
#include <asm/gpio.h>
#include <asm/io.h>
#include <asm/arch/clock.h>
-#include <asm/arch/gpio.h>
#include <asm/arch/spl.h>
#include <asm/arch/sys_proto.h>
#include <asm/arch/timer.h>
uint32_t cr;
};
-struct fel_stash fel_stash __attribute__((section(".data")));
+struct fel_stash fel_stash __section(".data");
#ifdef CONFIG_ARM64
#include <asm/armv8/mmu.h>
/* RAM */
.virt = 0x40000000UL,
.phys = 0x40000000UL,
- .size = 0xC0000000UL,
+ .size = CONFIG_SUNXI_DRAM_MAX_SIZE,
.attrs = PTE_BLOCK_MEMTYPE(MT_NORMAL) |
PTE_BLOCK_INNER_SHARE
}, {
}
};
struct mm_region *mem_map = sunxi_mem_map;
+
+ulong board_get_usable_ram_top(ulong total_size)
+{
+ /* Some devices (like the EMAC) have a 32-bit DMA limit. */
+ if (gd->ram_top > (1ULL << 32))
+ return 1ULL << 32;
+
+ return gd->ram_top;
+}
#endif
static int gpio_init(void)
sunxi_gpio_set_cfgpin(SUNXI_GPH(0), SUN50I_H6_GPH_UART0);
sunxi_gpio_set_cfgpin(SUNXI_GPH(1), SUN50I_H6_GPH_UART0);
sunxi_gpio_set_pull(SUNXI_GPH(1), SUNXI_GPIO_PULL_UP);
+#elif CONFIG_CONS_INDEX == 1 && defined(CONFIG_MACH_SUN50I_H616)
+ sunxi_gpio_set_cfgpin(SUNXI_GPH(0), SUN50I_H616_GPH_UART0);
+ sunxi_gpio_set_cfgpin(SUNXI_GPH(1), SUN50I_H616_GPH_UART0);
+ sunxi_gpio_set_pull(SUNXI_GPH(1), SUNXI_GPIO_PULL_UP);
#elif CONFIG_CONS_INDEX == 1 && defined(CONFIG_MACH_SUN8I_A83T)
sunxi_gpio_set_cfgpin(SUNXI_GPB(9), SUN8I_A83T_GPB_UART0);
sunxi_gpio_set_cfgpin(SUNXI_GPB(10), SUN8I_A83T_GPB_UART0);
sunxi_gpio_set_cfgpin(SUNXI_GPL(2), SUN8I_GPL_R_UART);
sunxi_gpio_set_cfgpin(SUNXI_GPL(3), SUN8I_GPL_R_UART);
sunxi_gpio_set_pull(SUNXI_GPL(3), SUNXI_GPIO_PULL_UP);
+#elif CONFIG_CONS_INDEX == 2 && defined(CONFIG_MACH_SUN8I) && \
+ !defined(CONFIG_MACH_SUN8I_R40)
+ sunxi_gpio_set_cfgpin(SUNXI_GPG(6), SUN8I_GPG_UART1);
+ sunxi_gpio_set_cfgpin(SUNXI_GPG(7), SUN8I_GPG_UART1);
+ sunxi_gpio_set_pull(SUNXI_GPG(7), SUNXI_GPIO_PULL_UP);
#else
#error Unsupported console port number. Please fix pin mux settings in board.c
#endif
-#ifdef CONFIG_MACH_SUN50I_H6
+#ifdef CONFIG_SUN50I_GEN_H6
/* Update PIO power bias configuration by copy hardware detected value */
val = readl(SUNXI_PIO_BASE + SUN50I_H6_GPIO_POW_MOD_VAL);
writel(val, SUNXI_PIO_BASE + SUN50I_H6_GPIO_POW_MOD_SEL);
clock_init();
timer_init();
gpio_init();
-#ifndef CONFIG_DM_I2C
+#if !CONFIG_IS_ENABLED(DM_I2C)
i2c_init_board();
#endif
eth_init_board();
}
#ifdef CONFIG_SPL_BUILD
+static u32 sunxi_get_spl_size(void)
+{
+ if (!is_boot0_magic(SPL_ADDR + 4)) /* eGON.BT0 */
+ return 0;
+
+ return readl(SPL_ADDR + 0x10);
+}
+
+/*
+ * The eGON SPL image can be located at 8KB or at 128KB into an SD card or
+ * an eMMC device. The boot source has bit 4 set in the latter case.
+ * By adding 120KB to the normal offset when booting from a "high" location
+ * we can support both cases.
+ * Also U-Boot proper is located at least 32KB after the SPL, but will
+ * immediately follow the SPL if that is bigger than that.
+ */
+unsigned long spl_mmc_get_uboot_raw_sector(struct mmc *mmc,
+ unsigned long raw_sect)
+{
+ unsigned long spl_size = sunxi_get_spl_size();
+ unsigned long sector;
+
+ sector = max(raw_sect, spl_size / 512);
+
+ switch (sunxi_get_boot_source()) {
+ case SUNXI_BOOTED_FROM_MMC0_HIGH:
+ case SUNXI_BOOTED_FROM_MMC2_HIGH:
+ sector += (128 - 8) * 2;
+ break;
+ }
+
+ return sector;
+}
+
u32 spl_boot_device(void)
{
return sunxi_get_boot_device();
spl_init();
preloader_console_init();
-#ifdef CONFIG_SPL_I2C_SUPPORT
+#if CONFIG_IS_ENABLED(I2C) && CONFIG_IS_ENABLED(SYS_I2C_LEGACY)
/* Needed early by sunxi_board_init if PMU is enabled */
i2c_init(CONFIG_SYS_I2C_SPEED, CONFIG_SYS_I2C_SLAVE);
#endif
}
#endif
-void reset_cpu(ulong addr)
+#if !CONFIG_IS_ENABLED(SYSRESET)
+void reset_cpu(void)
{
#if defined(CONFIG_SUNXI_GEN_SUN4I) || defined(CONFIG_MACH_SUN8I_R40)
static const struct sunxi_wdog *wdog =
/* sun5i sometimes gets stuck without this */
writel(WDT_MODE_RESET_EN | WDT_MODE_EN, &wdog->mode);
}
-#elif defined(CONFIG_SUNXI_GEN_SUN6I) || defined(CONFIG_MACH_SUN50I_H6)
+#elif defined(CONFIG_SUNXI_GEN_SUN6I) || defined(CONFIG_SUN50I_GEN_H6)
#if defined(CONFIG_MACH_SUN50I_H6)
/* WDOG is broken for some H6 rev. use the R_WDOG instead */
static const struct sunxi_wdog *wdog =
while (1) { }
#endif
}
+#endif
#if !CONFIG_IS_ENABLED(SYS_DCACHE_OFF) && !defined(CONFIG_ARM64)
void enable_caches(void)