Merge branch 'master' of git://git.denx.de/u-boot-mmc
[platform/kernel/u-boot.git] / arch / arm / mach-omap2 / omap5 / Kconfig
index 4041adc..1a66abd 100644 (file)
@@ -1,11 +1,17 @@
 if OMAP54XX
 
+config DRA7XX
+       bool
+       help
+         DRA7xx is an OMAP based SOC with Dual Core A-15s.
+
 choice
        prompt "OMAP5 board select"
        optional
 
 config TARGET_CL_SOM_AM57X
        bool "CompuLab CL-SOM-AM57x"
+       select DRA7XX
 
 config TARGET_CM_T54
        bool "CompuLab CM-T54"
@@ -16,12 +22,14 @@ config TARGET_OMAP5_UEVM
 config TARGET_DRA7XX_EVM
        bool "TI DRA7XX"
        select BOARD_LATE_INIT
+       select DRA7XX
        select TI_I2C_BOARD_DETECT
        select PHYS_64BIT
 
 config TARGET_AM57XX_EVM
        bool "AM57XX"
        select BOARD_LATE_INIT
+       select DRA7XX
        select TI_I2C_BOARD_DETECT
 
 endchoice
@@ -55,6 +63,23 @@ config TI_SECURE_EMIF_PROTECTED_REGION_SIZE
          using hardware memory firewalls. This value must be smaller than the
          TI_SECURE_EMIF_TOTAL_REGION_SIZE value.
 
+config OMAP_PLATFORM_RESET_TIME_MAX_USEC
+       int "Something"
+       range 0  31219
+       default 31219
+       help
+         Most OMAPs' provide a way to specify the time for which the reset
+         should be held low while the voltages and Oscillator outputs
+         stabilize.
+         This time is mostly board and PMIC dependent. Hence the boards are
+         expected to specify a pre-computed time using the above option.
+         This value can be computed using a summation of the below 3
+         parameters
+         1: Time taken by the Osciallator to stop and restart
+         2: PMIC OTP time
+         3: Voltage ramp time, which can be derived using the PMIC slew rate
+            and value of voltage ramp needed.
+
 if TARGET_DRA7XX_EVM || TARGET_AM57XX_EVM
 menu "Voltage Domain OPP selections"