if OMAP54XX
-config SPL_EXT_SUPPORT
- default y
-
-config SPL_FAT_SUPPORT
- default y
-
-config SPL_GPIO_SUPPORT
- default y
-
-config SPL_I2C_SUPPORT
- default y
-
-config SPL_LIBCOMMON_SUPPORT
- default y
-
-config SPL_LIBDISK_SUPPORT
- default y
-
-config SPL_LIBGENERIC_SUPPORT
- default y
-
-config SPL_MMC_SUPPORT
- default y
-
-config SPL_NAND_SUPPORT
- default y
-
-config SPL_POWER_SUPPORT
- default y
-
-config SPL_SERIAL_SUPPORT
- default y
-
-config SPL_DISPLAY_PRINT
- default y
+config DRA7XX
+ bool
+ help
+ DRA7xx is an OMAP based SOC with Dual Core A-15s.
choice
prompt "OMAP5 board select"
optional
+config TARGET_CL_SOM_AM57X
+ bool "CompuLab CL-SOM-AM57x"
+ select DRA7XX
+
config TARGET_CM_T54
bool "CompuLab CM-T54"
config TARGET_DRA7XX_EVM
bool "TI DRA7XX"
+ select BOARD_LATE_INIT
+ select DRA7XX
select TI_I2C_BOARD_DETECT
select PHYS_64BIT
+ imply SCSI
config TARGET_AM57XX_EVM
bool "AM57XX"
+ select BOARD_LATE_INIT
+ select DRA7XX
select TI_I2C_BOARD_DETECT
+ imply SCSI
endchoice
using hardware memory firewalls. This value must be smaller than the
TI_SECURE_EMIF_TOTAL_REGION_SIZE value.
+config OMAP_PLATFORM_RESET_TIME_MAX_USEC
+ int "Something"
+ range 0 31219
+ default 31219
+ help
+ Most OMAPs' provide a way to specify the time for which the reset
+ should be held low while the voltages and Oscillator outputs
+ stabilize.
+ This time is mostly board and PMIC dependent. Hence the boards are
+ expected to specify a pre-computed time using the above option.
+ This value can be computed using a summation of the below 3
+ parameters
+ 1: Time taken by the Osciallator to stop and restart
+ 2: PMIC OTP time
+ 3: Voltage ramp time, which can be derived using the PMIC slew rate
+ and value of voltage ramp needed.
+
if TARGET_DRA7XX_EVM || TARGET_AM57XX_EVM
menu "Voltage Domain OPP selections"
endmenu
endif
+source "board/compulab/cl-som-am57x/Kconfig"
source "board/compulab/cm_t54/Kconfig"
source "board/ti/omap5_uevm/Kconfig"
source "board/ti/dra7xx/Kconfig"