Convert CONFIG_RESET_PHY_R to Kconfig

[platform/kernel/u-boot.git] / arch / arm / mach-kirkwood / include / mach / config.h

diff --git a/arch/arm/mach-kirkwood/include/mach/config.h b/arch/arm/mach-kirkwood/include/mach/config.h
index cf6b1b9..e629a30 100644 (file)
--- a/arch/arm/mach-kirkwood/include/mach/config.h
+++ b/arch/arm/mach-kirkwood/include/mach/config.h
@@ -27,15 +27,6 @@
 #define CONFIG_KIRKWOOD_RGMII_PAD_1V8  /* Set RGMII Pad voltage to 1.8V */
 #define CONFIG_KIRKWOOD_PCIE_INIT       /* Enable PCIE Port0 for kernel */
 
-/*
- * By default kwbimage.cfg from board specific folder is used
- * If for some board, different configuration file need to be used,
- * CONFIG_SYS_KWD_CONFIG should be defined in board specific header file
- */
-#ifndef CONFIG_SYS_KWD_CONFIG
-#define        CONFIG_SYS_KWD_CONFIG   $(CONFIG_BOARDDIR)/kwbimage.cfg
-#endif /* CONFIG_SYS_KWD_CONFIG */
-
 /* Kirkwood has 2k of Security SRAM, use it for SP */
 #define CONFIG_SYS_INIT_SP_ADDR                0xC8012000
 
@@ -59,7 +50,6 @@
  */
 #ifdef CONFIG_CMD_NET
 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN        /* detect link using phy */
-#define CONFIG_RESET_PHY_R     /* use reset_phy() to init mv8831116 PHY */
 #endif /* CONFIG_CMD_NET */
 
 /*
@@ -67,21 +57,12 @@
  */
 #ifdef CONFIG_IDE
 #define __io
-/* Needs byte-swapping for ATA data register */
-#define CONFIG_IDE_SWAP_IO
 /* Data, registers and alternate blocks are at the same offset */
-#define CONFIG_SYS_ATA_DATA_OFFSET     (0x0100)
-#define CONFIG_SYS_ATA_REG_OFFSET      (0x0100)
-#define CONFIG_SYS_ATA_ALT_OFFSET      (0x0100)
 /* Each 8-bit ATA register is aligned to a 4-bytes address */
-#define CONFIG_SYS_ATA_STRIDE          4
 /* Controller supports 48-bits LBA addressing */
 #define CONFIG_LBA48
 /* CONFIG_IDE requires some #defines for ATA registers */
-#define CONFIG_SYS_IDE_MAXBUS          2
-#define CONFIG_SYS_IDE_MAXDEVICE       2
 /* ATA registers base is at SATA controller base */
-#define CONFIG_SYS_ATA_BASE_ADDR       MV_SATA_BASE
 #endif /* CONFIG_IDE */
 
 /* Use common timer */