static void ps_mode_reset(ulong mode)
{
- writel(mode << ZYNQMP_CRL_APB_BOOT_PIN_CTRL_OUT_VAL_SHIFT |
- mode << ZYNQMP_CRL_APB_BOOT_PIN_CTRL_OUT_EN_SHIFT,
- &crlapb_base->boot_pin_ctrl);
- udelay(1);
writel(mode << ZYNQMP_CRL_APB_BOOT_PIN_CTRL_OUT_EN_SHIFT,
&crlapb_base->boot_pin_ctrl);
udelay(5);
#if defined(CONFIG_SPL_ZYNQMP_ALT_BOOTMODE_ENABLED)
/* Change default boot mode at run-time */
- writel(BOOT_MODE_USE_ALT |
- CONFIG_SPL_ZYNQMP_ALT_BOOTMODE << BOOT_MODE_ALT_SHIFT,
+ writel(CONFIG_SPL_ZYNQMP_ALT_BOOTMODE << BOOT_MODE_ALT_SHIFT,
&crlapb_base->boot_mode);
#endif
reg = readl(&crlapb_base->boot_mode);
+ if (reg >> BOOT_MODE_ALT_SHIFT)
+ reg >>= BOOT_MODE_ALT_SHIFT;
+
bootmode = reg & BOOT_MODES_MASK;
switch (bootmode) {
case JTAG_MODE:
return BOOT_DEVICE_RAM;
#ifdef CONFIG_SPL_MMC_SUPPORT
- case EMMC_MODE:
- case SD_MODE:
case SD_MODE1:
+ case SD1_LSHFT_MODE: /* not working on silicon v1 */
+/* if both controllers enabled, then these two are the second controller */
+#if defined(CONFIG_ZYNQ_SDHCI0) && defined(CONFIG_ZYNQ_SDHCI1)
+ return BOOT_DEVICE_MMC2;
+/* else, fall through, the one SDHCI controller that is enabled is number 1 */
+#endif
+ case SD_MODE:
+ case EMMC_MODE:
return BOOT_DEVICE_MMC1;
#endif
#ifdef CONFIG_SPL_DFU_SUPPORT
case USB_MODE:
return BOOT_DEVICE_DFU;
#endif
+#ifdef CONFIG_SPL_SATA_SUPPORT
+ case SW_SATA_MODE:
+ return BOOT_DEVICE_SATA;
+#endif
default:
printf("Invalid Boot Mode:0x%x\n", bootmode);
break;
u32 spl_boot_mode(const u32 boot_device)
{
- switch (spl_boot_device()) {
+ switch (boot_device) {
case BOOT_DEVICE_RAM:
return 0;
case BOOT_DEVICE_MMC1:
+ case BOOT_DEVICE_MMC2:
return MMCSD_MODE_FS;
default:
puts("spl: error: unsupported device\n");
#ifdef CONFIG_SPL_OS_BOOT
int spl_start_uboot(void)
{
+ handoff_setup();
+
return 0;
}
#endif