Merge branch 'master' of git://git.denx.de/u-boot-arm

[platform/kernel/u-boot.git] / arch / arm / cpu / armv7 / omap3 / sdrc.c

diff --git a/arch/arm/cpu/armv7/omap3/sdrc.c b/arch/arm/cpu/armv7/omap3/sdrc.c
index 96fd990..6c419f5 100644 (file)
--- a/arch/arm/cpu/armv7/omap3/sdrc.c
+++ b/arch/arm/cpu/armv7/omap3/sdrc.c
@@ -99,7 +99,7 @@ u32 get_sdr_cs_offset(u32 cs)
                return 0;
 
        offset = readl(&sdrc_base->cs_cfg);
-       offset = (offset & 15) << 27 | (offset & 0x30) >> 17;
+       offset = (offset & 15) << 27 | (offset & 0x30) << 17;
 
        return offset;
 }
@@ -107,18 +107,12 @@ u32 get_sdr_cs_offset(u32 cs)
 /*
  * do_sdrc_init -
  *  - Initialize the SDRAM for use.
- *  - Sets up SDRC timings for CS0
  *  - code called once in C-Stack only context for CS0 and a possible 2nd
  *    time depending on memory configuration from stack+global context
  */
 void do_sdrc_init(u32 cs, u32 early)
 {
-       struct sdrc_actim *sdrc_actim_base;
-
-       if (cs)
-               sdrc_actim_base = (struct sdrc_actim *)SDRC_ACTIM_CTRL1_BASE;
-       else
-               sdrc_actim_base = (struct sdrc_actim *)SDRC_ACTIM_CTRL0_BASE;
+       struct sdrc_actim *sdrc_actim_base0, *sdrc_actim_base1;
 
        if (early) {
                /* reset sdrc controller */
@@ -138,24 +132,29 @@ void do_sdrc_init(u32 cs, u32 early)
                sdelay(0x20000);
        }
 
-       writel(RASWIDTH_13BITS | CASWIDTH_10BITS | ADDRMUXLEGACY |
-                       RAMSIZE_128 | BANKALLOCATION | B32NOT16 | B32NOT16 |
-                       DEEPPD | DDR_SDRAM, &sdrc_base->cs[cs].mcfg);
-       writel(ARCV | ARE_ARCV_1, &sdrc_base->cs[cs].rfr_ctrl);
-       writel(V_ACTIMA_165, &sdrc_actim_base->ctrla);
-       writel(V_ACTIMB_165, &sdrc_actim_base->ctrlb);
-
-       writel(CMD_NOP, &sdrc_base->cs[cs].manual);
-       writel(CMD_PRECHARGE, &sdrc_base->cs[cs].manual);
-       writel(CMD_AUTOREFRESH, &sdrc_base->cs[cs].manual);
-       writel(CMD_AUTOREFRESH, &sdrc_base->cs[cs].manual);
-
        /*
-        * CAS latency 3, Write Burst = Read Burst, Serial Mode,
-        * Burst length = 4
+        * SDRC timings are set up by x-load or config header
+        * We don't need to redo them here.
+        * Older x-loads configure only CS0
+        * configure CS1 to handle this ommission
         */
-       writel(CASL3 | BURSTLENGTH4, &sdrc_base->cs[cs].mr);
+       if (cs) {
+               sdrc_actim_base0 = (struct sdrc_actim *)SDRC_ACTIM_CTRL0_BASE;
+               sdrc_actim_base1 = (struct sdrc_actim *)SDRC_ACTIM_CTRL1_BASE;
+               writel(readl(&sdrc_base->cs[CS0].mcfg),
+                       &sdrc_base->cs[CS1].mcfg);
+               writel(readl(&sdrc_base->cs[CS0].rfr_ctrl),
+                       &sdrc_base->cs[CS1].rfr_ctrl);
+               writel(readl(&sdrc_actim_base0->ctrla),
+                       &sdrc_actim_base1->ctrla);
+               writel(readl(&sdrc_actim_base0->ctrlb),
+                       &sdrc_actim_base1->ctrlb);
+       }
 
+       /*
+        * Test ram in this bank
+        * Disable if bad or not present
+        */
        if (!mem_ok(cs))
                writel(0, &sdrc_base->cs[cs].mcfg);
 }
@@ -164,6 +163,7 @@ void do_sdrc_init(u32 cs, u32 early)
  * dram_init -
  *  - Sets uboots idea of sdram size
  */
+#if defined(CONFIG_SYS_ARM_WITHOUT_RELOC)
 int dram_init(void)
 {
        DECLARE_GLOBAL_DATA_PTR;
@@ -189,6 +189,43 @@ int dram_init(void)
 
        return 0;
 }
+#else
+int dram_init(void)
+{
+       DECLARE_GLOBAL_DATA_PTR;
+       unsigned int size0 = 0, size1 = 0;
+
+       size0 = get_sdr_cs_size(CS0);
+       /*
+        * If a second bank of DDR is attached to CS1 this is
+        * where it can be started.  Early init code will init
+        * memory on CS0.
+        */
+       if ((sysinfo.mtype == DDR_COMBO) || (sysinfo.mtype == DDR_STACKED)) {
+               do_sdrc_init(CS1, NOT_EARLY);
+               make_cs1_contiguous();
+
+               size1 = get_sdr_cs_size(CS1);
+       }
+       gd->ram_size = size0 + size1;
+
+       return 0;
+}
+
+void dram_init_banksize (void)
+{
+       DECLARE_GLOBAL_DATA_PTR;
+       unsigned int size0 = 0, size1 = 0;
+
+       size0 = get_sdr_cs_size(CS0);
+       size1 = get_sdr_cs_size(CS1);
+
+       gd->bd->bi_dram[0].start = PHYS_SDRAM_1;
+       gd->bd->bi_dram[0].size = size0;
+       gd->bd->bi_dram[1].start = PHYS_SDRAM_1 + get_sdr_cs_offset(CS1);
+       gd->bd->bi_dram[1].size = size1;
+}
+#endif
 
 /*
  * mem_init -