.globl _TEXT_BASE
_TEXT_BASE:
+#ifdef CONFIG_NAND_SPL /* deprecated, use instead CONFIG_SPL_BUILD */
.word CONFIG_SYS_TEXT_BASE
+#else
+#if defined(CONFIG_SPL_BUILD) && defined(CONFIG_SPL_TEXT_BASE)
+ .word CONFIG_SPL_TEXT_BASE
+#else
+ .word CONFIG_SYS_TEXT_BASE
+#endif
+#endif
/*
* Below variable is very important because we use MMU in U-Boot.
/*
* void relocate_code (addr_sp, gd, addr_moni)
*
- * This "function" does not return, instead it continues in RAM
- * after relocating the monitor code.
- *
+ * This function relocates the monitor code.
*/
.globl relocate_code
relocate_code:
mov r6, r2 /* save addr of destination */
adr r0, _start
- cmp r0, r6
- moveq r9, #0 /* no relocation. relocation offset(r9) = 0 */
+ subs r9, r6, r0 /* r9 <- relocation offset */
beq relocate_done /* skip relocation */
mov r1, r6 /* r1 <- scratch for copy_loop */
ldr r3, _bss_start_ofs
add r2, r0, r3 /* r2 <- source end address */
copy_loop:
- ldmia r0!, {r9-r10} /* copy from source address [r0] */
- stmia r1!, {r9-r10} /* copy to target address [r1] */
+ ldmia r0!, {r10-r11} /* copy from source address [r0] */
+ stmia r1!, {r10-r11} /* copy to target address [r1] */
cmp r0, r2 /* until source end address [r2] */
blo copy_loop
* fix .rel.dyn relocations
*/
ldr r0, _TEXT_BASE /* r0 <- Text base */
- sub r9, r6, r0 /* r9 <- relocation offset */
ldr r10, _dynsym_start_ofs /* r10 <- sym table ofs */
add r10, r10, r0 /* r10 <- sym table in FLASH */
ldr r2, _rel_dyn_start_ofs /* r2 <- rel dyn start ofs */