Such implementation may be faster under some conditions
but may increase the binary size.
+config SET_STACK_SIZE
+ bool "Enable an option to set max stack size that can be used"
+ default y if ARCH_VERSAL || ARCH_ZYNQMP
+ help
+ This will enable an option to set max stack size that can be
+ used by u-boot.
+
+config STACK_SIZE
+ hex "Define max stack size that can be used by u-boot"
+ depends on SET_STACK_SIZE
+ default 0x4000000 if ARCH_VERSAL || ARCH_ZYNQMP
+ help
+ Defines Max stack size that can be used by u-boot so that the
+ initrd_high will be calculated as base stack pointer minus this
+ stack size.
+
config ARM64_SUPPORT_AARCH32
bool "ARM64 system support AArch32 execution state"
depends on ARM64
select ARCH_MISC_INIT
select BOARD_EARLY_INIT_F
select CPU_V7A
- select SYS_FSL_HAS_SEC if SECURE_BOOT
+ select SYS_FSL_HAS_SEC if IMX_HAB
select SYS_FSL_SEC_COMPAT_4
select SYS_FSL_SEC_LE
imply MXC_GPIO
config ARCH_MX6
bool "Freescale MX6"
select CPU_V7A
- select SYS_FSL_HAS_SEC if SECURE_BOOT
+ select SYS_FSL_HAS_SEC if IMX_HAB
select SYS_FSL_SEC_COMPAT_4
select SYS_FSL_SEC_LE
select SYS_THUMB_BUILD if SPL
select USB if DISTRO_DEFAULTS
select USB_KEYBOARD if DISTRO_DEFAULTS
select USB_STORAGE if DISTRO_DEFAULTS
- select USE_TINY_PRINTF
+ select SPL_USE_TINY_PRINTF
imply CMD_DM
imply CMD_GPT
imply CMD_UBI if NAND
select DM_MMC if MMC
select DM_SERIAL
select OF_CONTROL
+ imply BOARD_LATE_INIT
config ARCH_VF610
bool "Freescale Vybrid"
select CLK
select DM
select DM_ETH if NET
+ select DM_MAILBOX
select DM_MMC if MMC
select DM_SERIAL
select DM_SPI if SPI
select DM_SPI_FLASH if DM_SPI
select DM_USB if USB
+ select FIRMWARE
select OF_CONTROL
select SPL_BOARD_INIT if SPL
select SPL_CLK if SPL
+ select SPL_DM_MAILBOX if SPL
+ select SPL_FIRMWARE if SPL
select SPL_SEPARATE_BSS if SPL
select SUPPORT_SPL
+ select ZYNQMP_IPI
imply BOARD_LATE_INIT
imply CMD_DM
imply FAT_WRITE
select PL01X_SERIAL
select SEMIHOSTING
-config TARGET_VEXPRESS64_BASE_FVP_DRAM
- bool "Support Versatile Express ARMv8a FVP BASE model booting from DRAM"
- select ARM64
- select PL01X_SERIAL
- help
- This target is derived from TARGET_VEXPRESS64_BASE_FVP and over-rides
- the default config to allow the user to load the images directly into
- DRAM using model parameters rather than by using semi-hosting to load
- the files from the host filesystem.
-
config TARGET_VEXPRESS64_JUNO
bool "Support Versatile Express Juno Development Platform"
select ARM64