imply DM_SPI
imply DM_SPI_FLASH
imply FAT_WRITE
+ imply SPL
+ imply SPL_DM
imply SPL_LIBDISK_SUPPORT
imply SPL_MMC_SUPPORT
imply SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION
select DM_ETH
select DM_GPIO
select DM_KEYBOARD
+ select DM_MMC if MMC
+ select DM_SCSI if SCSI
select DM_SERIAL
select DM_USB if DISTRO_DEFAULTS
select OF_BOARD_SETUP
select SYSRESET
select SYS_THUMB_BUILD
imply CMD_DM
+ imply CMD_POWEROFF
imply ENV_VARS_UBOOT_RUNTIME_CONFIG
help
Support for STM32MP SoC family developed by STMicroelectronics,
config TI_SECURE_DEVICE
bool "HS Device Type Support"
- depends on ARCH_KEYSTONE || ARCH_OMAP2PLUS
+ depends on ARCH_KEYSTONE || ARCH_OMAP2PLUS || ARCH_K3
help
If a high secure (HS) device type is being used, this config
must be set. This option impacts various aspects of the
authenticated) and the code. See the doc/README.ti-secure
file for further details.
+if AM43XX || AM33XX || OMAP54XX || ARCH_KEYSTONE
+config ISW_ENTRY_ADDR
+ hex "Address in memory or XIP address of bootloader entry point"
+ default 0x402F4000 if AM43XX
+ default 0x402F0400 if AM33XX
+ default 0x40301350 if OMAP54XX
+ help
+ After any reset, the boot ROM searches the boot media for a valid
+ boot image. For non-XIP devices, the ROM then copies the image into
+ internal memory. For all boot modes, after the ROM processes the
+ boot image it eventually computes the entry point address depending
+ on the device type (secure/non-secure), boot media (xip/non-xip) and
+ image headers.
+endif
+
source "arch/arm/mach-aspeed/Kconfig"
source "arch/arm/mach-at91/Kconfig"
source "arch/arm/mach-imx/Kconfig"
source "board/bosch/shc/Kconfig"
+source "board/bosch/guardian/Kconfig"
source "board/CarMediaLab/flea3/Kconfig"
source "board/Marvell/aspenite/Kconfig"
source "board/Marvell/gplugd/Kconfig"