config HAVE_ARCH_IOREMAP
bool
-config NEEDS_MANUAL_RELOC
- bool
-
config SYS_CACHE_SHIFT_4
bool
config MICROBLAZE
bool "MicroBlaze architecture"
- select NEEDS_MANUAL_RELOC
select SUPPORT_OF_CONTROL
- imply CMD_IRQ
+ imply CMD_TIMER
+ imply SPL_REGMAP if SPL
+ imply SPL_TIMER if SPL
+ imply TIMER
+ imply XILINX_TIMER
config MIPS
bool "MIPS architecture"
select BZIP2
select CMD_POWEROFF
select DM
+ select DM_FUZZING_ENGINE
select DM_GPIO
select DM_I2C
select DM_KEYBOARD
imply CRC32_VERIFY
imply FAT_WRITE
imply FIRMWARE
+ imply FUZZING_ENGINE_SANDBOX
imply HASH_VERIFY
imply LZMA
imply TEE
source "arch/xtensa/Kconfig"
source "arch/riscv/Kconfig"
+if ARM || M68K || PPC
+
+source "arch/Kconfig.nxp"
+
+endif
+
source "board/keymile/Kconfig"
+
+if MIPS || MICROBLAZE
+
+choice
+ prompt "Endianness selection"
+ help
+ Some MIPS boards can be configured for either little or big endian
+ byte order. These modes require different U-Boot images. In general there
+ is one preferred byteorder for a particular system but some systems are
+ just as commonly used in the one or the other endianness.
+
+config SYS_BIG_ENDIAN
+ bool "Big endian"
+ depends on (SUPPORTS_BIG_ENDIAN && MIPS) || MICROBLAZE
+
+config SYS_LITTLE_ENDIAN
+ bool "Little endian"
+ depends on (SUPPORTS_LITTLE_ENDIAN && MIPS) || MICROBLAZE
+
+endchoice
+
+endif