ARM: k2g: Program DDR PHY MR2 register with the default value

[platform/kernel/u-boot.git] / README

diff --git a/README b/README
index 504b120..ee35dec 100644 (file)
--- a/README
+++ b/README
@@ -687,29 +687,10 @@ The following options need to be configured:
                Define this variable to enable hw flow control in serial driver.
                Current user of this option is drivers/serial/nsl16550.c driver
 
-- Console Interface:
-               Depending on board, define exactly one serial port
-               (CONFIG_8xx_CONS_SMC1 or CONFIG_8xx_CONS_SMC2),
-               or switch off the serial console by defining
-               CONFIG_8xx_CONS_NONE
-
-               Note: if CONFIG_8xx_CONS_NONE is defined, the serial
-               port routines must be defined elsewhere
-               (i.e. serial_init(), serial_getc(), ...)
-
 - Console Baudrate:
                CONFIG_BAUDRATE - in bps
                Select one of the baudrates listed in
                CONFIG_SYS_BAUDRATE_TABLE, see below.
-               CONFIG_SYS_BRGCLK_PRESCALE, baudrate prescale
-
-- Console Rx buffer length
-               With CONFIG_SYS_SMC_RXBUFLEN it is possible to define
-               the maximum receive buffer length for the SMC.
-               This option is actual only for 8xx possible.
-               If using CONFIG_SYS_SMC_RXBUFLEN also CONFIG_SYS_MAXIDLE
-               must be defined, to setup the maximum idle timeout for
-               the SMC.
 
 - Autoboot Command:
                CONFIG_BOOTCOMMAND