Define this to use i/o functions instead of macros
(some hardware wont work with macros)
+ CONFIG_FTGMAC100
+ Support for Faraday's FTGMAC100 Gigabit SoC Ethernet
+
+ CONFIG_FTGMAC100_EGIGA
+ Define this to use GE link update with gigabit PHY.
+ Define this if FTGMAC100 is connected to gigabit PHY.
+ If your system has 10/100 PHY only, it might not occur
+ wrong behavior. Because PHY usually return timeout or
+ useless data when polling gigabit status and gigabit
+ control registers. This behavior won't affect the
+ correctnessof 10/100 link speed update.
+
CONFIG_SMC911X
Support for SMSC's LAN911x and LAN921x chips
globally (CONFIG_CMD_MEM).
- CONFIG_SKIP_LOWLEVEL_INIT
- [ARM only] If this variable is defined, then certain
- low level initializations (like setting up the memory
- controller) are omitted and/or U-Boot does not
- relocate itself into RAM.
-
- Normally this variable MUST NOT be defined. The only
- exception is when U-Boot is loaded (to RAM) by some
- other boot loader or by a debugger which performs
- these initializations itself.
+ [ARM only] If this variable is defined, then certain
+ low level initializations (like setting up the memory
+ controller) are omitted and/or U-Boot does not
+ relocate itself into RAM.
+
+ Normally this variable MUST NOT be defined. The only
+ exception is when U-Boot is loaded (to RAM) by some
+ other boot loader or by a debugger which performs
+ these initializations itself.
- CONFIG_PRELOADER
Modifies the behaviour of start.S when compiling a loader