Makefile: Allow CONFIG_SPL_FIT_GENERATOR to be empty

[platform/kernel/u-boot.git] / README

diff --git a/README b/README
index 7ab7e37..d4bf74c 100644 (file)
--- a/README
+++ b/README
@@ -1401,7 +1401,6 @@ The following options need to be configured:
 
                CONFIG_BOOTP_NISDOMAIN
                CONFIG_BOOTP_BOOTFILESIZE
-               CONFIG_BOOTP_SEND_HOSTNAME
                CONFIG_BOOTP_NTPSERVER
                CONFIG_BOOTP_TIMEOFFSET
                CONFIG_BOOTP_VENDOREX
@@ -1416,13 +1415,6 @@ The following options need to be configured:
                to Link-local IP address configuration if the DHCP server
                is not available.
 
-               CONFIG_BOOTP_SEND_HOSTNAME - Some DHCP servers are capable
-               to do a dynamic update of a DNS server. To do this, they
-               need the hostname of the DHCP requester.
-               If CONFIG_BOOTP_SEND_HOSTNAME is defined, the content
-               of the "hostname" environment variable is passed as
-               option 12 to the DHCP server.
-
                CONFIG_BOOTP_DHCP_REQUEST_DELAY
 
                A 32bit value in microseconds for a delay between
@@ -2257,10 +2249,6 @@ The following options need to be configured:
                parameters from when MMC is being used in raw mode
                (for falcon mode)
 
-               CONFIG_SYS_MMCSD_FS_BOOT_PARTITION
-               Partition on the MMC to load U-Boot from when the MMC is being
-               used in fs mode
-
                CONFIG_SPL_FS_LOAD_PAYLOAD_NAME
                Filename to read to load U-Boot when reading from filesystem
 
@@ -2281,24 +2269,10 @@ The following options need to be configured:
                CONFIG_SPL_SKIP_RELOCATE
                Avoid SPL relocation
 
-               CONFIG_SPL_NAND_BASE
-               Include nand_base.c in the SPL.  Requires
-               CONFIG_SPL_NAND_DRIVERS.
-
-               CONFIG_SPL_NAND_DRIVERS
-               SPL uses normal NAND drivers, not minimal drivers.
-
                CONFIG_SPL_NAND_IDENT
                SPL uses the chip ID list to identify the NAND flash.
                Requires CONFIG_SPL_NAND_BASE.
 
-               CONFIG_SPL_NAND_ECC
-               Include standard software ECC in the SPL
-
-               CONFIG_SPL_NAND_SIMPLE
-               Support for NAND boot using simple NAND drivers that
-               expose the cmd_ctrl() interface.
-
                CONFIG_SPL_UBI
                Support for a lightweight UBI (fastmap) scanner and
                loader